Satellite C870-155 - the Touchpad does not work

Similar Questions

• Satellite M105-S3031: the TouchPad does not work

  Hello guys!

  I have a M105-S3031 Satellite. It's been 1 week shut down and this morning when I turned it on, the touchpad did not work, check status, that's like "enable." I installed a mouse cable and with it works well.

  Any help?
  TKS.

  Check it please again using FN + F9 key combination.

• Satellite X 200-219 - the touchpad does not work as it should

  Hi all

  I recently bought a 2nd hand Toshiba Satellite x 200-219. Had some problems with it that I have overcome now, except one... The touchpad does not work as it should. I think that the cable has been damaged at some point.

  So I'm wondering if I should use the same ribbon cable to connect the keyboard to the motherboard or can I get one of a different model of PC Toshiba laptop?

  I tried searching on the net for advice but have resulted in nothing so thought I would try the forums.

  Any help you can give will be greatly appreciated.

  Thanks in advance,

  Lee

  I think you can use the items to the satellite X 205 series since this seems to be the same series as X 200:
  Found some related parts the touchpad:
  Satellite X 205 / X 200 touchpad Board with cable: reference number: K000047950
  Satellite part number for the TOUCH PAD FFC X 205 / X 200: K000047980

  But why you n t come into contact with a Toshiba authorized service provider in your country and order the part necessary and compatible?

• I have laptop (hp probook 4520 s), the touchpad does not work. How can I turn it back on it?

  I have laptop (hp probook 4520 s), the touchpad does not work. How can I turn it back on it?

  This is a question which would probably respond by HP support, because it isn't really a Windows problem.

  Are you sure that the touchpad is not just turned off? Many laptops have switches, power switch, so you can rest your palm while typing one is not worry by pressing the key.

  Sometimes, there is a button above the key, a key on the Ko, or some have a stain on the pavement you waiting/tap/double tap/etc. to toggle the pad.

  If not, you could try to go on the site of HP and DOWNLOAD/reinstall assistance the SW for the touch pad.

• FN + F3 disable the Touchpad does not work. Dell XPS L702X

  Hello, I am new to this forum.

  The function FN + F3 that disable the Touchpad does not work, my laptop Dell XPS 17 (L702X)

  I googled my problem and the only thing I found was this: http://en.community.dell.com/support-forums/laptop/f/3518/t/19454265.aspx

  I think that my problems with the touchpad started when I plugged a mouse into the USB port. It didn't work (it worked well before), and in material-sound-mouse control panel, the system asked me to uninstall a driver or other. I do not remember, but later the mouse worked.

  After this weird thing with the mouse, I noticed that the touchpad was malfunctioning. While I write, the cursor moves without touching the touchpad, it is annoying because it makes me write bad because he is moving in the middle of writing, as I write so it's a mess.

  The second oddity, the Fn + F3 does not disable the touchpad, the orange light come on (the led on the top of the touchpad), but the cursor can be moved in any case, with or without a connected mouse.

  I checked for driver updates, perform an audit of the system, checked for viruses, spywares and I don't know what I could do. I don't know if the problem with the mouse had nothing to do with the function Fn + F3 problem.

  I have not formatted or re installed windows 7, never.

  In Device Manager I have this:

  -mouse and other pointing devices:-Compatible PS/2 mouse

  Help, please. Thank you.

  DOH! Problem between Chair and keyboard...

  C:\dell\drivers\R289237

  Run the executable file of Synaptics.

  Download of extracts only the program on your disk. You must manually install the driver for the Synaptics touchpad with its own executable.

  FN + F3 now disables =)

• Satellite L50-B-211 - Touchpad does not work

  Hi I have a question

  We just bought a Satellite L50-B-211, but the touchpad is not working properly.
  Move the pointer autour is no problem, but the buttons do not work.

  Using the buttons does nothing, left or right clicking has no effect?
  If I want to get the properties of a file right-clicking does not work?
  (two fingers press work)

  The hardware is correctly installed, there is no problem in the configuration of the device.

  Do I have to return the device (before installing our software / config the device to our needs)
  or is this a software bug?

  According to specification for laptop, your laptop was supplied with Win8.1 pre-installed so that all the necessary drivers are installed and all hardware should work fine.

  Try please check all the touchpad settings and check if changing the settings has positive effect.
  What you can try to do is to reinstall the original recovery image and test once more with the factory settings. If the result will be the same, I recommend you to contact your dealer as soon as possible and explain the situation. Ask if you can get the new machine.

• Satellite Pro M30-701: TouchPad does not work after installation of XP Pro

  My touchPad does not work after reinstalling XP Pro OS with recovery disk. I install a driver for Toshiba M30 - 701 Synaptics TouchPad tpdrv-sp-m30-xp - 7920.zip

  Can you help me solve the my problem please?
  Excuse my bad English...
  Thank you
  Jorge Neto

  HI Jorge,.

  If you have reinstalled your system using the Toshiba recovery disks the touchpad should have the right drivers and be fully functional. I seem to remember that it is possible to disable the touch pad using one of the "keyboard shortcuts" (F9 on my SA30) in order to check that it has not been inadvertently pressed.

  Kind regards

• Satellite L855-149 - Synaptics touchpad does not work after upgrade to win 8

  I Hare recently upgradedmy Toshiba Satellite L855-149 to the most recent version of windows 8 6.2 and since I did then the Synaptics touch pad stopped working, I guess because the driver does not work with this version of windows 8. What can I do to fix this so I can use my computer without a plug in the mouse again?

  Thank you
  Simon

  Thanks for your comments!

• Satellite C855 - 1 HM-Touchpad does not work

  Hello

  My touchpad does not work! indications are he should be, pilot the newest, toggle F5 etc. Any ideas as to what may be wrong welcome. Machine is also only a few weeks, how do you contact technical support?

  Thank you

  Hello

  You can contact the Toshiba authorized service partner in your country, your hardware is defective.
  But you should first check if its hardware problem.

  First of all, you should check if the touchpad (pointing device) is enabled in the BIOS
  Press F2 during the powering of the device and go to the Advanced tab-> the system setup
  You will find the touchpad power option.

  If the touchpad is enabled in the BIOS, I recommend to check the touchpad system settings: Control Panel-> mouse-> last (Advanced) tab-> Advanced button

  Last but not least you should recover the laptop to test the device with factory settings.
  If all these tips would not be successful success, well, then I recommend to ask the guy to service

• Satellite P850-30W - the fan does not work after returning from the mode "Eve"

  I have a Toshiba Satellite P850 30W with bios 1.90.

  Sometimes the fan does not work at all after back mode standby on windows 7.
  What happened twice (perhaps several times without knowing me), and Ive had the computers for a month.

  Normally the fan starts to run when the CPU gets more than 50 degrees celsius and stops less than 50 celisus...

  I tried running Prime95 when this fan-this occurs and the time of the computer got dangerously high (near 100 degrees)! the fan did not start at all
  .. .This error could damage the laptop potentinally...
  to get the fan turns once again I have to restart windows

  anyone experienced this?
  I guess that the fix would be to never use standby... or toshiba needs to fix it with an update of the bios.

  > Sometimes the fan does not work at all after back mode standby on windows 7.
  > What has happened twice (perhaps several times without knowing me), and Ive had the computers for a month.

  You said it's happened twice and only sometimes done this means that above all the fans are working well?
  In this case, this would mean that it of difficult to reproduce this problem, but you might be right: maybe a BIOS update would help solve this problem permanently

  I found some discussions on the stand-by mode and fan activity and in most cases, the update of the BIOS was the key.

• BlackBerry Z30 the touchpad does not work on my Blackberry

  Touchpad does not work after restarting my blacberry to factory settings.

  Do one or more of the following actions and try again.

  Restart: With the BlackBerry powereddevice, press and hold the power button on top about 20-30 seconds, ignore the 3-2-1 timer and hold the button until the screen goes black and you see the red LED.
  or
  Restart: With the phone smart BlackBerry turned on, using the keys of volume of the edge side, press on and hold the keys of volume for about 20 seconds and both of the Up, ignoring the initial message of screenshot... the screen go black, reboot.

• After turning on the computer, the Touchpad does not work until I have press a key on the keyboard

  Original title: Touch Pad issue

  Hello

  Every time I turn on the computer touchpad does not work (in the form of connection), first I press any key on the keyboard once I press a button and then press the mouse will start to work, I don't know what exactly is the problem... I reinstalled the drivers, checked in services but still the same. Can someone help me on this.

  Kind regards

  NGO

  Hello, NGO,

  Changes were made on the computer before the show?

  Method 1:

  Run the hardware and devices Troubleshooter and check if that helps.

  Method 2:

  I suggest you to return the item and check if it helps:

  Mouse, touchpad and keyboard with Windows problems

  http://Windows.Microsoft.com/en-us/Windows/help/Mouse-touchpad-and-keyboard-problems-in-Windows?T1=tab05

  Let us know if it helps.

• Satellite A300D-126 the keyboard does not work

  I reinstalled the driver but it still does not. What could be the problem? Help please. Thank you

  Hello

  What s wrong exactly?
  You have reinstalled the drivers?
  What drivers do you mean?

  The keyboard driver is part of the Windows operating system and it cannot be reinstalled separately.

  If your keyboard doesn't work properly then either the software doesn't run as it should, or the material (keyboard) is defective.

  You could try reinstalling the operating system using the Toshiba HDD recovery to check whether the problem is related to the software.
  If the keyboard does not work after this procedure, then a hardware problem might be possible.

• Satellite C50D-B-120 - buttons on the touchpad does not work after upgrade to win 10

  I just bought this new laptop. I have updated to Windows 8 Windows 10. Everything worked fine before the update. I am now active on Windows 10 and the mouse pad does not work. Initially, the entire mouse pad not working, I couldn't even move the mouse on the screen. I had a play around in the settings and have managed to get the work of the mouse, but now the button of mosuepad. I searched around the computer for the settings to solve this problem, but I had no luck.

  Please any help would be great, begin teaching and could do with getting this issue sorted.

  Thank you!

  You need to uninstall the driver for the touchpad (MOMENTUM or Synaptics)
  After that, restart the laptop...

  You can also try to update the driver in Device Manager... but the unit must be connected to the internet...

• Satellite A300-20 b - Touchpad does not work after BIOS update

  I've updated the BIOS on my Satellite A300-20 b latest version 2.00. Update succeeded, but when I rebooted system touchpad has stopped working.

  I tried to find the solution, resettled drivers (windows XP system). In the Windows Device Manager there is no problem with Synaptics PS/2 Port Touchpad, I see. Software Synaptics shows no problem I can enable and disable the touchpad, but it does not work for the touchpad. I tried Linux live CD and in this system does not work as good touchpad. I think there is problem in this version of the BIOS.

  Does anyone have the same problem?

  Hey Buddy,

  Have you tried to turn the touchpad on or off if you press FN + F9? Check this please!
  Also, try to load the default settings in the BIOS.

  What happens if you connect an external mouse to the laptop? It work?

  I can t imagine that the BIOS update causing this problem. If it doesn't work, you need to contact a service provider for help. They can check the touchpad and replace.