Satellite L300-10 q - imposible to connect to wireless local area network

Similar Questions

• Satellite Pro L40 PSL43E: Unable to connect to wireless local area network

  Hello to everyone who reads,

  I've had this laptop for about 12 months and a few days ago while trying to connect to the internet, she advised that I was not connected to my router.

  I have another laptop, it connects well with wireless and it connects fine using the ethernet cable but wireless!
  Especially, when I switch the radio power on/off using the small switch on the front the same symbol rises (the cell phone, red circle with a red slash through it, then the sign of the internet!)

  I tried the update of the driver for the Atheros AR5007EG Wireless Network wireless adapt and not much happened!

  I'm not in portable computers in a big way so any advise given better would become simple?
  I saw some stuff about the removal of the cards and other things? but I don't know where to start!

  Is it a common thing with these laptops?
  Need help please, I desperately need my laptop wireless.

  Thanks a lot to all in advance

  Paul

  Hello Paul

  Make sure that the wireless network adapter is correctly enabled.
  After putting using WLAN switch using FN + F8 key combination and make sure the wireless network adapter is enabled.

• Satelite C50 - B cannot connect to wireless local area network

  My brand new straight out of the box Satelite C50 - B cannot connect to my wireless network, when you are running Windows 8.1.

  When you run the wizard for the first time user, it was unable to connect to my network to register. And I have been unable to connect after starting the OS, even if my thread was visible and the signal strength would be strong. I entered the security network key, but the message came back "unable to connect to this network.

  However, when I started on a USB key to run Linux Mint 17.1, it took less than 5 seconds to connect to my wireless network. If the Toshiba hardware work properly, as also my wireless LAN.

  If I plug in a network cable, same Windows connects to my network and Internet.

  However, given that the C50 - B satellite comes with Windows 8.1 both of wireless capabilities, I was hoping someone here might be able to help me get a wireless connection in Windows.

  It's really strange. I have S50 - B and WLAN works properly. I used my laptop connected to several different networks and everything was OK.
  You can try to test with different wireless LANs?
  Have you checked all the WLAN settings?
  Try restarting your router.

  I mean if your laptop can detect WLAN, this means that the hardware is enabled and working properly. There must be a problem with the WLAN settings.

  Also check the advanced power settings, and then set it to maximum power WLAN.

• I'm not able to open the properties and the State in Local (or all network devices) network. Actually I am not able to connect to the local area network connection in network and sharing Center.

  Connection to the local network - properties dialog box

  Hi, I'm not able to open the properties and the State in Local (or all network devices) network. Actually I am not able to connect to the local area network connection in network and sharing Center. But I can't access the Internet. My OS is Windows 7

  Hello Rajaneer,

  Is the computer that you are using a personal computer or a work computer?
  You will need to re - install your network card drivers like something was damaged and it prevents you to access the property:
  http://Windows.Microsoft.com/en-us/Windows7/update-a-driver-for-hardware-that-isn ' t-work correctly

• Satellite L300 will not let me connect

  My Satellite L300 will not let me connect unless I'm in safe mode and when I go to advanced options it just comes up with a blue screen

  Help!

  Who knows what's the problem here?
  Maybe you should install new OS. You can enter boot options using F8 at startup?

  Repair my computer option is available?

• No links to the local area network connection. But how to use the Internet again, please help establish a LAN connection.

  Original title: no local network connection

  No links to the local area network connection. But how to use the Internet again, please help establish a LAN connection.

  Hi H.mustafaakyurek,

  ·         What operating system is installed on your computer?

  You can view the following items on the creation of a network connection:

  Setting up a network home

  http://Windows.Microsoft.com/en-us/Windows7/setting-up-a-home-network

   

  Start here to set up a home network in Windows 7

  http://Windows.Microsoft.com/en-us/Windows7/start-here-to-set-up-a-home-network-in-Windows-7

   

  Setting up a wireless network

  http://Windows.Microsoft.com/en-us/Windows7/setting-up-a-wireless-network

  Also see the following articles on the connection of an Internet connection:

  What do I need to connect to the Internet?

  http://Windows.Microsoft.com/en-us/Windows7/what-do-I-need-to-connect-to-the-Internet

   

  Allows to connect to the Internet mobile broadband

  http://Windows.Microsoft.com/en-us/Windows7/use-mobile-broadband-to-connect-to-the-Internet

  Hope this information helps.

• Satellite L300 - WLan disconnect tries to connect to various Web sites

  I have a Satellite L300.

  Can I get the connection to the home page when I want to search other sites, I lose the connection. Page does not open.
  Is this a problem with my laptop or a wireless router?

  Help please

  > Is it a problem with my laptop or a wireless router?
  Who knows, have you tested the WiFi connection using computers/laptops?

  PS: it s always advisable to update the BIOS and driver WLan to check if that helps solve these WLan connectivity problems.

• Satellite L300 - 29 X - how to connect to the TV?

  I have a Toshiba Satellite L300-29 X with a mini-VGA output and want to connect it to my TV, preferably by the DVI - I analog/digital double entry, but impossible to find a cable that will do it. Can someone point me in the right direction? I live in the United Kingdom and as such, have access to retailers based in the United Kingdom and do not want to pay the exorbitant costs to import from abroad.

  If all else fails, I could connect through the input SCART on my TV, but once again, someone could point me in the right direction of a cable that could do that?

  Cheers in advance for any help.

  C

  I also noticed just my TV has an entry of RS232 9 pin so if that's any help?

  Hey,.

  As I know there is no analog/DVI adapter, DVI only of-analog adapters available.

  The connections you have on your TV?
  Usually, you can use a RCA VGA adapter to connect your laptop to the TV as [THIS | http://images.ncix.com/forumimages/12BADAB5-13A6-D8D7-0372158257AC5AE9.jpg] a.

• Satellite Pro M70-132: excellent WiFi connection but the pings are slow

  Hi all...
  My Satellite Pro M70-132 have problems with Wi - Fi connections (WiFi built in)... Generally, when the connection is excellent (indicator of windows), the pings are slow - very long time: 1212ms, 325ms, 645ms, 2112ms, 91ms, s 168ms... etc 'demand time limit has expired' (or sth like this).
  I have updated with the latest version of the Intel WiFi driver - it does not work...
  I installed new system - it does not work...

  Is it possible, that LAN WiFi is dead on my M70-132? How can I check before sending my 'Toshi' to the service?

  (BTW - built-in Bluetooth has been switched off...)

  I was tempted to access with several AP and also ad hoc. Every time, same results... connection strong-great but pings are slow... and often ping timeout...

  The IP address has been set manually and automatically - it does not work... too multidimensional :-(

  It's not metter WEP encryption is enabled, 'on' or 'off' and no authentication method does not change the situation with WLAN...

  Post edited by: maxgoldie

  Hello

  If the work of WLan connection and you are connected to the router so I guess everything's ok.
  Time to ping depends on not always the strength of the signal.

  If you ping other ip on the net if the time depends on the provider and type of connection.
  But if you ping your WLan router and it s very slow so it s a bit strange.

  If you think there could be something wrong with the Wlan card then you can try asking for help ASP.

• Satellite L300-15V - the system can not install wireless LAN driver

  After you have installed all the drivers for this machine, the system shows that you need to install the wireless LAN driver, but I did! What is going on? Help! I can't make wireless net home!

  Have you installed the correct driver WLan?
  Please note that the L300 and other series of laptops were equipped with various wireless network cards. Please make sure that you have installed the compatible WLan driver!

  Welcome them

• Satellite A100 - 02 M: cannot open the local area network to share files and printer - LAN Unplugged

  I have an office of another manufacturer which was connected by a wireless network via a Belkin router for a laptop another manufacturers - both running XP.

  I have now replaced the other laptop with a laptop Toshiba Satellite A100 - 02 M under Vista Home Premium. While I can still access the Internet from both machines, I can't open the LAN to share files and printers. The laptop shows 'LAN Unplugged' all the time. Any ideas would be accepted with gratitude.

  Ray Freeman

  Hello

  I have no general solution, but I'll try to give some advice solution;
  If you want to connect laptop with LAN cable both please make sure that you use a crossover ethernet cable.
  In addition, check if the network card is properly recognized in Device Manager.

  You could try updating the LAN driver and remove the NIC in Device Manager to update the installed driver.
  After restarting again the operating system should recognize the new (Lan) device and should install it automatically.

  I also studied a bit in this forum and found a similar thread:
  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=14852&MessageID=54037

  Check the proposals contained in this message.

  By the way; Microsoft provides a very useful page on Vista and how to configure the network, the file and printer sharing and troubleshooting
  http://windowshelp.Microsoft.com/Windows/en-us/networking.mspx

• Network Diagnostics cable - A is not connected to the Local Area Connection network adapter

  All the links are perfect - network card appears in Device Manager and work - ping 127.0.0.1 but seeing none on in the network connection - cable works in another system - I unplugged the power cables one night and restarted but no result-help solve this problem

  Hello

  Follow the steps in troubleshooting section and check if that helps:

  Network adapter problems

  http://Windows.Microsoft.com/en-us/Windows-Vista/troubleshoot-network-adapter-problems

  Also read these articles and check if it helps:

  Network connection problems

  http://Windows.Microsoft.com/en-us/Windows-Vista/troubleshoot-network-connection-problems

  http://Windows.Microsoft.com/en-us/Windows-Vista/using-Windows-Network-Diagnostics-event-logs-to-solve-network-problems

• Connection problems on wide AREA network (3G or wireless remote)

  Hello.

  I created a lab configuration on my esxi server running a windows 7 client and a server connection view - and it works absolutely flawlessly, when I'm at home - but I'd like to do a show at work but I am unable to do this without VPN is active on my iPad.

  I did the following

  (1) enabled "Use PCoIP Secure Gateway for connections to PCoIP desktop computers" on my login server

  (2) entered the external URL field above the box my WAN (public IP)

  (3) the forwarded port TCP/UDP - TCP 443 - 4172 80 TCP on the IP connection server internal

  What could be wrong? Would it not possible to make this configuration without a security server?

  I am getting the box to logon on the Ipad - and my powers are accepted - but still not able to access my computer from windows client

  @chrmol - you did everything correctly and it should work fine with view 4.6

  You have a dns name in the external field "url"?

  You have a secure server Win 2008 R2 64-bit? (It is a requirement)

  Make sure 4172 is open the UDP and TCP protocols between the internet and the connection to the server

  Linjo

• Cannot connect by Satellite L300 wireless access point

  I have a new laptop L300 & I can't connect to the laptop to my wireless access point. I have an another mobile E-sytems with the same hardware Realtek RTL8187B & it connects without problems.

  The machine has the free two month Mcafee subscription & I have disabled all the protection incase that was causing the problem. I updated the driver for the wireless card & the bios on the Toshiba site, but nothing is.

  Can someone shed light on this problem because the laptop is only two weeks old?

  Thank you...

  Hello

  To connect the laptop to the WLan, it must ensure that everything is enabled and configured correctly.
  You should check these points:

  -activated the WLan with the WLan switch and the FN + F8
  -don t use any 3rd party config tools WLan if you use the WLan configuration options own Vista
  -for the first test WLan disable the security settings of the Wlan router
  -configure settings to laptop as good SSID and search for your wireless local area network
  -After that the laptop is connected to the WLan router, you can turn back the security settings (encryption, mac address filtering, firewall, etc.)

  Welcome them

• Why Satellite L300-10 q does not recognize wireless network

  This new laptop works well on a wired LAN but does not recognize a wireless local area network. Received the message no network found. In the same room with another PC laptop Toshiba the wireless LAN is located and has good signal strength.
  The wireless LAN switch is on and the 'antenna' pictogram led burns red.

  Seems that it is not configured for detection. No idea how to solve this problem?

  Hello

  You´re sure you checked all THE settings? I mean, if the local wired network works and the wireless is enabled, you need to check all the parameters available that could be done. One idea would be to check the L300 on another access point to make sure that the problem persists on different brands of wireless routers.

  Please check this first and make sure that your settings are all on "automatic" so if you do not find the reason, come back and we will try to find another solution.

  Welcome them