Tecra 8000 boot problem

Similar Questions

• Toshiba Tecra 8000, monitor problem

  Hello

  I have a problem with my laptop Toshiba Tecra 8000, there is a green line with a width of 1 pixel on the screen of my laptop which does not disappear. the laptop is almost 2 years old. is there a possibility that it could be repaired? Thanks in advance,
  Mark Kuiper

  Hello

  interesting would be if the green line is permanently on the screen during startup or 'just' that Windows runs.

  But never mind, the laptop Tecra series three-year warranty.

  So in this case you can give it to a Toshiba repair for a control center upward.

  Good bye

• Tecra M4 boot problem - missing or damaged ntoskernl

  Hello

  I have a Tecra M4 running Windows XP Tablet Edition, which fails to start due to "a missing or corrupt ntoskrnl.exe. According to the MS website I can solve it using the installation disc, but I don't have one that I bought the laptop from my employer when I retired. I was told that my installation is legal and have the license number.

  I tried to get a Toshiba drive, but it seems that the machine is too old.

  Anyone know where I can get a drive to. If it is not possible to find the same version of the operating system can I can use an installation disk XP Pro standard (I could buy on the Internet), even though my system is the tablet edition. I don't want to take the risk to wipe my data, because even though I have most of the stuff saved there are has some important issues that are not.

  Any help appreciated.

  Thank you

  Barbara

  Hey,.

  Yes, that is a known issue regarding the ntoskrnl file and you need a Microsoft Windows disk to fix this problem in the repair console.

  Are familiar you with Windows repair console? I ask this question because you need to use the DOS command line based to solve this problem, there are GUI. If so ask a friend if they have such a drive and normally the professional XP disk should also work.

  Otherwise, you will have to reinstall the whole system :(

• Tecra 8000: Startup problems

  I was called to my classmates because he has problems with his laptop...

  At startup it asks EC/KBC drive... in research I found that it is the update of the bios...

  howevev I can't update because it has an external drive USB floppy only... the bios can be updated by CD rom? or that this message can be ignored if I can update Via Windows...

  Thank you very much
  Billie Skeggs
  BILLIG. [email protected]

  [Edited by: admin April 30 05 15:52]

  Hello
  have you tried booting in save mode?

• Tecra S1 boot: problems

  Finally, I installed sp2 and everything now works very well only I have a problem:
  When the s1 is well unplugged the power cord and I start it, I get after you have filled my passw a blue screen. then the pc restarts, same problem, restarts and so on. I can reboot into safe mode, then there is no problem. When I plug in the power cord and reboot the pc once again everything works fine. It is said that it is has recovered from a serious error.

  Hello

  you have reinstalled the Toshiba Power Saver after update to SP2?

  Pete

• Tecra 8000 sudden power outage

  Hello
  I have a tecra 8000, the problem is that there is a sudden break or sudden running (roaming), the outlets led turns orange instead of green.

  The cable which is the output of the zine warms

  Hello

  Sorry, but I don't really know what you mean. Have you had problems with the AC adapter or the battery charging procedure?
  I can t give you an adequate response to your problem now. Perhaps you can describe your problem in more detail.

  But nevertheless it its s like a power supply problem. In this case, I recommend to contact the service partner.

  Good bye

• Tecra 8000 SD 2102 DVD Drive problem

  Hello

  I have a Tecra 8000 with a 2102 sd drive, the drive may be used if I boot from a boot disk, but has driver problems when used in Win 2 k. Anyone has any ideas, what is the problem?

  Dave N

  Hello

  a http://www.toshiba-europe.com/storage/index.asp?nav=HOM&page=HOM&frame=home, you can find more information on your drive!

  Choose your player and download the device driver. This should solve your problem!

  Good bye

• Tecra 8000: update of the Bios allows booting from USB?

  Hello

  I have Toshiba Tecra 8000 (simple 266 MHZ)
  Will be this bios bios-t8000-930 - trad.zip (08/26/02) allow you to boot from USB?

  Hello

  As far as I know, you need a supported drive to boot from external USB drive.
  The update of the Bios won't boot options.
  If you want you can ask for the readers supported ASP.
  I found this site one:
  http://www.CCD.co.UK/Xpress/catalogue/product.asp?PN=JD0000283

  It s a Toshiba CD - RW / DVD-ROM combo wit reader PC Card interface.

• Tecra 8000 isn't boot from CD - how to enter the BIOS?

  Hello

  I have a 2nd hand tecra 8000.

  Now, it does not start from CD? I don't know why... but a question is to know how to enter the BIOS setup, because is not possible with the F2 key.

  How to enter the BIOS?

  Thank you too

  Francisco
  ([email protected])

  Hello

  ESC key to enter the BIOS settings.

• Tecra 8000 screen goes green

  I have a Tecra 8000 running Windows 2000 with the latest version of the bios/drivers, etc.. It works fine and all, but it has this particular problem. At first boot, the display is fine, but then gets a green tint to everything. I can fix it by going into hibernation (or suspend) and turn the machine back (out of hibernation).

  Similarly, if I run an application that changes res and past in full screen (ie: MAME) the screen will return to a green tint again and will not go back to normal unless I have Hibernate-> restarts. Any ideas?

  Hello

  Have you tried to plug the external monitor?
  If this is not the case, try to connect the external monitor and check if this problem also occurs on the second monitor.
  If this isn't the case, so I guess something is wrong with the display on the laptop, but if this problem also appears on the external monitor if there could be a malfunction of the graphics card or as something bad on the motherboard.
  Unfortunately I don't think that you can solve without professional help.
  You should contact Toshiba service partner in your country.
  Explain the situation to him.

• Tecra 8000 does not initialize to top

  My Tecra 8000 will not initialize-to the top (previously worked fine).
  1. the Red "TOSHIBA" icon comes up, then it just "grey screens" on me.
  2. I can start up to the A: drive using a bootable floppy and I see the hard drive (C:\) and it seems OK.
  3. I checked the settings of BIOS (ESC, F1), and they look OK.
  4. I have Windows 2000 installed.

  Any suggestions? Thanks, Neil

  Hello

  It seems that the laptop properly the Toshiba screen.
  In this case, there should be no problem with hardware or BIOS.

  Eventually switch you to the external display? I would recommend the connection of the external monitor to check if something pops up.
  But if it doesn't help, so possibly damaged HARD drive could be responsible for this issue.

  Have you tried to boot from the CD? You see something?

• Tecra 8000 laptop don't dΘmarre

  Hello. I have a Tecra 8000 I used for 3 years with no problems. I recently gave to someone, anyone, but she gives it telling me that it has stopped working.
  The problem is it does not boot, it gives me the TOSHIBA logo, then the screen "booting Windows 2000 upwards", then again TOSHIBA logo and new "Windows 2000 is starting up". It just keeps going forever.
  One of my fried said that the NETDETECT.COM file may have been tampered with. But how do I get that back and if I can't go beyond these 2 screens. Help please.

  See you soon
  Veen

  Hello

  one of my friends had similar problems with his notebook of W2k, so I searched in the Ms knowledge base and found this article no. 281770

  Go to http://support.microsoft.com and search for this number.

  This article contains a description of the Safe Mode and safe boot sequence.

  Goodbye, Sam

• Tecra 8000 - connection of the hard disk

  Hello

  My old Tecra 8000 dropped last night after 4 years loyal service. She simply refuses to start to start most of the time. I think that this is a motherboard problem because sometimes it is starts on a diskette and remains stable for about 10 minutes. I know that the hard drive is fine as I can copy files on disk when booting from the floppy in DOS mode. Is there a way I can connect the HDD on a desktop PC so that I can recover the files which are there?

  Thanks for your help,

  Tom

  Hello

  James means the case of HARD drive 2.5 external with a USB port or / and the firewire interface. These cases, you can buy everywhere. Also check ebay.

• Tecra 8000 - factory restore

  I'm having a lot of problems with my tecra 8000 and I want to restore it back to factory settings. No idea how I can do that I don't have a boot disk.

  Thank you

  Hello

  If you don t have delivered the recovery CD, you must use the full version of Microsoft CD and install the operating system. After installing all the necessary drivers, tools and utilities that you can find on Toshiba download page.

  http://EU.computers.Toshiba-Europe.com/cgi-bin/ToshibaCSG/download_drivers_bios.jsp

  Good bye

• Tecra 8000 sees no PCMCIA network card

  I don't get my Belkin network card Wireless PCMCIA connected to my Tecra 8000.
  That's all new win 2000, including all updates and I don't know that the pcmcia slot is working very well.

  The problem during the installation of this card is that the tecra does not see the network card.
  Does anyone have an idea how to solve this problem. Network adapter is Belkin F5d7010 54 Mb.

  THX

  Guus
  Utrecht

  Try to change some settings in the BIOS.
  In the configuration box, you can set the configuration of device option to all devices.
  In addition, in the area PC card, you can try changing the compatible option CCIP or CardBus / 16-bit.

  Play with these settings and check if a this will allow the card.

  PS: Have you installed all the drivers that should be shipped with this card?