2950 PE + PERC 6 / I and RAID recovery

Similar Questions

• PowerEdge 2900 Perc 6 / i internal Raid Controller

  OK, so I use a server Dell PowerEdge 2900 with a PERC 6 / i integrated RAID controller

  I have configured the RAID array very well, installed Windows 2008 R2 and works fine and dandy

  The only problem I encounter is that, when starting the server (Post), I get a message on the cable SAS B are not connected or misconfigured.  The bottom of the basket on my server, which goes to the internal drives, has only a port where I can plug a cable between the Perc 6 / i.  Where is the 2nd wire supposed to go?  I can't find the second port.

  Thank you

  Hello

  joeyjojo56

  I get a message on the cable SAS B are not connected or misconfigured.  The bottom of the basket on my server, which goes to the internal drives, has only a port where I can plug a cable between the Perc 6 / i.  Where is the 2nd wire supposed to go?  I can't find the second port.

  PERC connector 0 goes to the bottom of basket. Connector on the PERC 1 connects to the modular Bay. If you don't have the module Bay optional then you ensure that you use the 0 on the PERC and not the connector 1.

  Thank you

• PERC 6/E and PERC 6 / i Firmware download - it's actually the same file?

  My Dell PowerEdge R710 has two PERC 6 / i and PERC 6/E installed. Both with RAID arrays active. I do an update of the system (BIOS, iDRAC, the life cycle, OpenManage and PERC firmware). I noticed that I have downloaded two files DUP of the firmware for the PERC 6 / i and 6/E and they seem to be identical in all but name.

  Do both?

  • SAS - RAID_Firmware_3H5G8_WN32_6.3.3 - 0002_X00. EXE
  • SAS - RAID_Firmware_F96NR_WN32_6.3.3 - 0002_X00. EXE

  It is advisable to run updates for internal/external controllers, because they "may" have differences in the firmware. The payload for updates in THIS version are the same... an update can update them both, but I suspect it will update the device it was intended.

• What is the different between firefox "Sync Key" and "key recovery"?

  The problem is: I can't get my data from server. I have my key to 'Sync', and I used it several times before, but now Firefox says its wrong. Are 'sync key' and two 'recovery key' names to a single key or its two different keys?

  There is no difference between tho two names, they both refer to the sync key that is used to encrypt data locally before sending it to the sync server.

  Try creating a new profile as a test to check whether your profile is the source of the problems.

  See "create a profile":

  • https://support.Mozilla.org/KB/Profile-Manager-create-and-remove-Firefox-profiles
  • http://KB.mozillazine.org/Standard_diagnostic_-_Firefox#Profile_issues

  If the new profile works then you can transfer files from a profile in the new profile, but make sure not to copy corrupted files.

  • http://KB.mozillazine.org/Transferring_data_to_a_new_profile_-_Firefox

• System user name and password recovery options

  Hi, looking for help to find my user name and password recovery system, I'm trying to factory reset my laptop, any information will be greatly appreciated, thanks siiinky

  Generally, you don't need to insert any user name or password when you start the recovery process...
  Usually, you must press ENTER to continue.

• Backup and HP Recovery Manager General Questions

  I made a series of restore DVD using backup and HP Recovery Manager hear are several questions I have.

  If the restore on my hard drive partition is deleted can always restore from the DVD I made?

  I am upgrading to Windows 7 will soon be the Recovery Manager always be available for use?

  Thanks, Rich614

  richie614 wrote:
  

  I made a series of restore DVD using backup and HP Recovery Manager hear are several questions I have.

  If the restore on my hard drive partition is deleted can always restore from the DVD I made?

  I am upgrading to Windows 7 will soon be the Recovery Manager always be available for use?

  Thanks, Rich614

  Rich, Yes, the DVD can take the place of the partition.  However, I would test to ensure that they work properly before you delete the partition of the DVD.

  Yes, however, it will restore your computer to its original state.  This means that you will no longer Win 7, but programs and original OS.

• C670 - 10 p and image recovery satellite facility

  Hello. I have a C670 I had starting problems. I tried the backup of disks that I created when I got the machine, but they did not. I had an extended warranty with the company I bought the laptop from and I sent it to them to get the problem sorted. As the backup of disks did not work, what they have done is reinstall windows, and I lost the software and system recovery disc HARD on the D drive that come on the machine. Lesson learned here I think.

  If I had to buy a whole Toshiba backup discs it would bring back the machine to his condition of "out of the box.

  Thank you in anticipation

  > If I buy a set Toshiba backup discs it would bring back the machine to his condition of "out of the box.
  Yes. You can order original recovery on https://backupmedia.toshiba.eu/landing.aspx disks

• I don't remember my password or security questions, and email recovery is an old, that I no longer use. What can I do?

  I don't remember my password or security questions, and email recovery is an old, that I no longer use. What can I do?

  You will need to contact support in the country where you are (and therefore the country on your account) for questions (and the password) reset: Contact Apple for the Apple ID account security support

  If your country is not on this page, then try this form to contact Support: https://www.apple.com/emea/support/itunes/contact.html

  When they have been reset you can then update your email address of relief for possible future use: on your Apple ID - Apple Support email addresses

  Or if it is available in your country, you can substitute 2-step verification: frequently asked questions about two-step for Apple ID verification

• I forgot my security question answer Apple ID and my recovery email address has since been deleted and disabled. How to get answers to security questions and or change my email recovery?

  I forgot my security question answer Apple ID and my recovery email address has since been deleted and disabled. How to get answers to security questions and or change my email recovery?

  Go to https://getsupport.apple.com . Click on "see all of the products and services ', then 'More', then 'Apple ID', then 'other Apple ID subjects' then 'security issues forgotten Apple ID". If you have problems with this test of this form: https://www.apple.com/emea/support/itunes/contact.html

• Updated SL500 and OS recovery Media (s)

  Hello world

  This is my first purchase of laptop and I did some research as to what long I must/need to do before messing with the system.

  Please bear with me as I have a few general questions and the search function track me not enough for all the responses.

  My OS is Vista Home Basic.

  At startup, I typed recovery leading to "Create recovery media", "Create product recovery media" and "rescue and recovery".

  I made backups of these three programs.

  To "Create the product recovery media", it has created 3-disc Start recovery disc i) and ii) product Recovery Disc 1 and 2

  For "Create recovery media", it created i) recovery and rescue boot disk

  Now, after you create the recovery of two types, it is safe to assume that I can delete the Q: Partition.

  Here are some questions that puzzled me:

  1. What is the difference between the product recovery media and the recovery media?

  If I can answer my own question, product recovery media restore the laptop to its factory as well as the 3 partitions EVEN AFTER State I've done a 'clean install' of Vista and removing all partitions. Someone correct me if I'm wrong.

  I have no idea what a recovery media as product recovery media seems to do everything.

  2. what type of recovery (of the two mentioned above) is the operating system Vista pre installed inside I should decide to go back to Vista.

  My guess is the product with its OS and Lenovo recovery media drivers + utilities.

  3. should I decide to go and install W7 Pro, once versions or Lenovo official drivers (because I can not directly upgrade Home Basic to Pro), is possible to always use the product and revert to Vista Home Basic recovery media, assuming that what came as factory settings have all been removed.

  4. and finally, I'll be able to make any kind of recovery media after a fresh install of W7? (I think a definitive answer will arise come W7 launch date, but it does not hurt to ask )

  Thank you very much for reading a long and perhaps repetitive for some, post.

  I always visit the forums then I hope I'll learn new things through time.

  1. recovery of product support will include your ad OS drivers that get you with your system

  2 medial recovery allows you to enter in the rescue and recovery environment

  You can use the product recvoery support to return to Vista Home Basic, if you want to

  You cannot do any recovery media after installing windows 7, because that has not been delivered with your system

• Aspire BIOS and RAID m3970

  Hello

  I noticed in the tab BIOS for an Acer Aspire M3970 and then advance under the integrated devices, there are options for the SATA mode on "Native IDE", "AHCI" and "RAID".

  I would like to know what RAID modes are supported by the RAID option on this forum. I can't seem to find this information anywhere does support at least 1 RAID when you have two drives?

  Any help would be great. Thank you.

  This system supports Raid 0, Raid 1, Raid 5, and Raid 10 configurations.

• Beats Audio Control Panel and HP Recovery Manager missing

  Hey there! I recently bought a HP Pavilion dv4-5a02tx and I have deleted the IDT audio drivers. However, when I rebooted my laptop, beats audio and HP Recovery Manager Control Panel was missing! The product number is B8M77PA #AB2 and the laptop runs Windows 7 Ultimate 64 bit.

  Operating instructions: how to download Driver / software of your computer - Audio Driver Web site

  • Open the link to the Web site of your computer for drivers and downloads

  HP Pavilion dv4-5a02tx Entertainment Notebook PC drivers & downloads

  • Ensure that the operating system is correctly selected
  • Scroll down and open category - Audio driver
  • Click on IDT High Definition Audio Driver available
  • When the Audio Driver page opens, scroll down (if necessary)
  • Under "Release Details", find your package of loadable execution: sp*.exe
  • Click on the package to start the download

  ==============================================================================

  It's the IDT Audio Driver for your system, running Windows 7

  IDT High - Definition (HD) Audio Driver V6.10.6395.0 sp57345

  ===============================================================================

  • Save the Setup *.exe appropriate on your computer package

  NOTE name and location -likely the *.exe file to save to "downloads".

  • Install the software / driver installation package: If you have control of "Admin", you can highlight the package and "double-click" to install, if not right click, select "Run as Administrator" and install.
  • Once the file has been installed, reboot / restart your computer and log in

  ===============================================================================

• Need your Help_Reformat diskless resettlement and the recovery partition deleted

  Hello.

  Please kindly help me to reformat my laptop G4 2014. Unfortunately I have no recovery disk and my recovery partition is already deleted.

  Thanks in advance for the help that you can give her.

  Just as I said, the web document, I provided the link for you to give options that are available to you.

  You or someone else with access to your laptop made some decisions aware, perhaps unfortunate not to create a recovery media and removal of the recovery partition.

  These decisions lead to choices that can be found on the web document that I you provided a link to.  An alternative is to buy a DVD of installation of Microsoft in the operating system of your choice.

• Statrted of Vista in safe mode and systm recovery restores and no recoverydisk not found?

  Statrted of Vista in safe mode and systm recovery restores and no recoverydisk not found? Sys restore is off and will not turn on and due to safemode noting els / programs will not work. is there a way out?

  Hi Jeff,

  1. you receive messages or error codes?

  2. did you of recent changes on the system?

  If you are able to boot into safe mode without any problem, you can try to perform a clean boot and check if it helps.

  Method 1:

  A clean boot to check if startup item or services to third-party application is causing this issue.

  You can read the following article to put the computer in a clean boot:

  How to troubleshoot a problem by performing a clean boot in Windows Vista or in Windows 7

  Note: After troubleshooting, be sure to set the computer to start as usual as mentioned in step 7 in the above article.

  Method 2:

  If you are always faced with the question, then you can check if you can start your computer by using the known last good Configuration feature and fix the problem.

  You can read the following article to do the same thing:

  Using the last good known Configuration

  Method 3:

  If the steps above fail, then you must have a full version of Windows Vista disk and try to perform a repair of the boot to WinRE (Windows Recovery Environment) boot from the installation disc.

  If restarting fails, then try to perform a restore of the system to WinRE (Windows Recovery Environment).

  For more information, you can consult the following article:

  What are the system recovery options in Windows Vista?

• Identifying BitLocker password and PIN recovery does not tally in AD DS

  The PC is connected to a domain, Bitlocker is on but the ID password and PIN recovery isn't tally to AD DS services, why is it so?

  Hi ahNAh,

  Since you have questions about Bitlocker on domain PC, it would be better suited in the Technet Windows forum. Please post your question in the following Windows Vista TechNet forum to improve assistance:

  http://social.technet.Microsoft.com/forums/en-us/category/windowsvistaitpro