can not see my DVD player

Similar Questions

• Windows can not see my dvd players, how to fix this?

  I have reinstalled XP and it does not show my dvd players

  Hello

  Run the fix it tool for the article mentioned below and check if this can help fix the problem.

  Your CD or DVD drive is missing or is not recognized by Windows or other programs
  http://support.Microsoft.com/kb/982116

• can't see the DVD in the drive

  I can see both drives and they can see and read CDs.  Can not see any DVD into two discs

  Hi snapeandcapture,

  Please see the following article with useful information about your question:

  http://support.Microsoft.com/kb/306318

  I hope this helps!

  Debra
  Microsoft Answers Support Engineer
  Visit our Microsoft answers feedback Forum and let us know what you think

• I can not eject a dvd from my drive iPhoto super-cannot see the drive open up Adobe Photo Elements and organizer and then apps get hung up "not responding" and cannot do anything - I've fixed dozens of times w msg success drive.  Help

  I can not eject a dvd from my drive iPhoto super-cannot see the drive open up Adobe Photo Elements and organizer and then apps get hung up "not responding" and cannot do anything - I've fixed dozens of times w msg success drive.  Help, please.  Thank you!

  Hello golden2,.

  I understand that you have a DVD picture in your SuperDrive drive, but it is not mount on the desktop and will not eject.

  Please, try the procedure described in this article using the disc is ejected.

  Get help with the SuperDrive slot on your Mac - Apple Support loading

  Do not eject discs or discs eject slowly

  1. If the drive ejects discs slowly or appears to have difficulty, insert and eject a disc several times. Check the disc to see if it has a label or other material stuck to the disc which increases the thickness. Remove the label if possible.
  2. If the disc does not eject, try pressing the eject on the keyboard button. Some older keyboards may use the F12 key to eject the disc.
  3. If the disc does not eject, try dragging the icon of the disk to the trash.
  4. If the disc will still not eject, try to hold down the mouse or trackpad button after you restart the computer. The Superdrive should attempt to eject the disc.
  5. If the disc still does not eject, reset the System Management Controller (SMC) and repeat steps 1 to 4.
  6. If the disc still does not eject, Contact Apple or an provider of services authorized Apple, or make an appointment with a Store Apple Store for further assistance.

  Take care.

• Can not see the whole clips on DVD

  Hello

  I recently created a project and it was engraved on a DVD. I can view the DVD very well, but can not see the entire width of the clips. I can see the entire width of the clips during playback on computer and TV. Any help is greatly appreciated.

  Is the DVD 4:3 or 16:9 wide screen? What type of display you're displaying on - an old 4:3 CRT or a screen flat 16:9? What image is missing? Some televisions show a picture of overscan, part of the meaning of the image is lost under the bezel, unlike most computer monitors showing each pixel on the screen.

  Thank you

  Jeff

• Satellite P200 - HD-DVD Player Toshiba can not read HD-DVD

  Hello.

  I have a problem with my Satellite P200-1: can not read HD DVD. There is a message that says that the video may not be in an external device.

  The problem is the same if I try on the screen of the laptop or on the TV (Sony Bravia Full HD) with HDMI. I have the latest driver and software for vista sp1 installed...

  Some have an idea?
  Sorry to talk so badly...

  Published by: ADMIN

  I think I know what's wrong;

  Check this Toshiba TB document;

  [HD DVD title does not play ("unable to output the video to an external device"): http://askiris.toshiba.com/ToshibaSupportSite/search.do?cmd=displayKC&docType=kc&externalId=1664 788xml & sliceId = & dialogid = 41741513 & stateId = 0% 200% 20 41739828]

  To resolve this problem, you will need to update the Audio driver Realtek for Windows Vista.

• Qosmio G20-127: after that Windows update I can not see list fax and printer

  Description of the problem
  Model: Toshiba Qosmio G20-127
  Operating Sysytem: Microsoft Windows Media Center Edition

  After the restoration of BONE of restore DVD, I can see list Fax and printer. But after the Windows Update I can not see the list of fax and printer and cannot run the Wizard "add a printer".

  I just installed printers.

  It seems that it s a Microsoft Windows problem and it s not bound Toshiba laptops
  See this Microsoft Knowledge base article:
  http://support.Microsoft.com/kb/823447/

• DVGW/hd ts-l802a does not see any DVD/CD

  first DVD worked fine, but when I read the second DVD, it's a ticking hard sound.
  end now, he does not see any DVD/CD / audio CD.

  Is there someone who has / have had this same problem or is there someone who can help me with this problem?

  Hello!

  You must give us a little more information such as your laptop model and the OS.

  However, maybe it could be useful for you:
  http://support.Microsoft.com/kb/314060

  You can boot from a CD like Linux boot disk?

  Good bye

• How can I get my dvd player to start as soon as I insert a cd or a dvd

  Help! I put my dvd in play and do not start the dvd player. So, I manually click on the icon to read dvd and it doesn't start. How can I go about setting up the dvd player to start automatically as soon as I put a dvd in the computer to play?

  Hello

  What is the operating system of your machine? Please try this:

  http://Windows.Microsoft.com/en-us/Windows-Vista/Change-AutoPlay-settings?SignedIn=1

  It is not a good idea to let the machine play automatically in order to avoid CD/DVD that contains viruses.

  Kind regards.

• H8XT does not start a DVD player

  I recently bought a H8XT and I want to do a clean install of windows 7.  The DVD drive seems to work very well and I used it to create the recovery discs already.  However, when I try to boot from the DVD drive, the boot in the bios menu does not show the DVD player.  I t shows a generic drive called "ATAPI CD/DVD Drive.  Even when I try to choose that it does not start on the DVD, it always starts on the hard drive.  I have this research group and found a position with a similar problem to mine.  Here it is:

  http://h30434.www3.HP.com/T5/desktop-operating-systems/computer-won-t-boot-to-install-Windows-7-full...

  The solution for this post was to clear the CMOS.  However, my motherboard is not exactly like the one shown in this post, and I can't figure out how to clear the CMOS memory.  In the 'Clear the CMOS' link in figure 4, it shows 2 jumpers on the right side of the 6-pin.   In my system, 2 riders are on the left side 6 pins.  Any help would be appreciated.  Thank you.

  Thanks for the suggestions.   It turns out that when I burned an image of windows 7 on DVD, it does not burn properly and is not bootable.

• Computer to read DVD - one message says that I can not read the DVD, except that I have installed a new driver.

  I have a new Toshiba C650 laptop, and he says that I can not read the dvd on it except that I have installed a new driver. Is this true?

  Hi Bill,

  To be honest, this sounds ridiculous but if you get a message, I suppose it could be possible even if I find it incredible.  Do you have it in a (local or online) retail store or Toshiba?  By any chance did you upgrade from the DVD player when buying (where they may have accidentally neglected to update the drivers of the drive that was originally installed)?

  As it is new, Toshiba should help you with this.  Here's the contact page: http://www.csd.toshiba.com/cgi-bin/tais/support/jsp/navShell.jsp?cf=su_contact&pf=true.  Give them everything they need to prove that buy you it and it should be under warranty and then give them the message Word for Word, that you have found.  They should be able to help you.  They can, for some reason I don't know, you don't need to help or guide you through a new driver installation.  I ask for a clear explanation of why this is necessary on a new computer and, if you are not satisfied with the response, ask them to consider that all the faulty computer and replace it.  Even if they won't, he needs the get them less motivated to solve your problem.

  I hope this helps.

  Good luck!

• Windows will not see my DVD/CD drive

  I have Windows Xp Professional SP3. Windows will not see my DVD +-RW which is internal drive, or my double-sided external DVD RW lightscribe. I tried the FixIt tool and the registry hack. They can work at the same time, but whenever I try to use the car, they both disappear again. Anyone have any new ideas?

  Hello

  ·        Since when are you facing this problem?

  ·        Remember to make changes to the system?

  ·        What registry hack you speak and what patch did you use?

  Method 1:

  I suggest you try the steps mentioned in the articles below and let us know your progress.

  Drive CD - R or CD - RW Drive is not recognized as a recordable device

  http://support.Microsoft.com/kb/316529

  Advanced Troubleshooting for issues that occur when you are installing a new CD or DVD drive in Windows XP

  http://support.Microsoft.com/kb/314096

  Your CD or DVD drive is missing or is not recognized by Windows or other programs

  http://support.Microsoft.com/kb/982116

  Method 2:

  I suggest to update the firmware of the CD/DVD drive on the system and check if the problem persists.

  Method 3:

  In addition, run the fix that is present in the link mentioned below.

  Hardware devices do not work or are not detected in Windows

  http://support.Microsoft.com/mats/hardware_device_problems/en-us

  Thanks and regards.

  Thahaseena M
  Microsoft Answers Support Engineer.
  Visit ourMicrosoft answers feedback Forum and let us know what you think.

• can't see the Dvd rom after the Update window window 10 7

  can't see the DVD rom after the Update window 10 window 7.

  Hi Michael,

  Thanks for posting your query in Microsoft Community.

  We would be happy to help you with the problem you are facing today. I understand the difficulty that is the problem, and I suggest you follow the methods below:

   

  Method 1: Run the troubleshooter of material and check.

  Follow the steps to run the Troubleshooter:

  a. type Troubleshooting in the search bar and click on it.
  b. click hardware and sound.
  c. click on Windows Media Player DVD and follow the instructions.

  Method 2: Uninstall, reinstall the drivers CD/DVD.

  a. press the Windows key + X , and then click Device Manager

  b. expand CD-ROM/DVD-ROM drives, right click on CD and DVD devices and then click Uninstall.
  c. When you are prompted to confirm that you want to remove the device, click OK.
  d. restart the computer.
  e. After you restart the computer, the drivers will be installed automatically.

  Method 3: Download/install the driver CD-ROM/DVD-ROM from the computer manufacturer's support Web site.

  Visit the computer manufacturer's support Web site and install the latest driver CD-ROM/DVD-ROM and check.

  Hope it will be useful. Incase if you still have any other queries please respond with more details and we will be happy to help you.

• Hi I can not download the flash player because I forgot my password.

  Hi I can not download the flash player because I forgot my password.

  It is the operating system, no Flash Player, which is asking to specify the password.  Please see what userid & password I need to install Flash Player?  for assistance.

• MY PHONE SCREEN IS BLACK, PHONE WILL RING AND ICAN HEAR THROUGH THE MESSAGES BUT CAN NOT SEE ANYTHING AT ALL

  MY PHONE SCREEN IS BLACK, PHONE WILL RING AND ICAN HEAR THROUGH THE MESSAGES BUT CAN NOT SEE ANYTHING AT ALL

  Try this restart your iPhone, iPad or iPod touch - Apple Support

  If this does not work, it may be a hardware problem.

  Hope this helps, good luck to you.