Equium L100 186 does not start!

Similar Questions

• Satellite L100 113 does not start after upgrading memory

  Hello.

  Our Integrator bring to our company KVR800D2S5, but laptop memory modules does not start :(

  I read manual - this laptop supports 533 PC4200 memory modules.

  But SO-DIMM 533 MHz will be delivered in one month...

  The memory modules, we can install to Toshiba L100-113?

  Thank you.

  Hello

  I think that the laptop does not power upward because of a barrette memory faulty or not fully compatible.

  Please visit this memory 3rd party:

  [Memory for Toshiba Satellite L100 113 | http://www.orcalogic.co.uk/asp/prodtype.asp?prodtype=22360&ft=m&st=3]

  As you can see Satellite L100 113 memory can be upgraded up to 2 GB (2 x 1 GB) and you must use the DDR2 533 MHz (PC2-4200) 200 - PIN SODIMM

  Concerning

• Equium M50-192 does not start

  Hello
  I posted a question here earlier on my laptop and I had useful assistance but he juices do not appear to have sorted.
  but I have now no wat it is not and just don't need to know wat it is

  I have a toshiba m50-192
  and when I turn it on it does not start going to a black screen and gives me errors (pxe - e61)

  in my last question, I was told that it was the hard drive was dead.
  Since then, I've replaced my hard drive and my hard drive, but it always seems to be doing almost the same

  I can get into my bios and the hard drive is recognized.
  I tried to boot from the disk recovery and hard drive but no joy.

  but since I replaced both drives when I boot from the hard drive it gos just a black screen with the little line in the upper right corner.

  but when I boot from the disk it gives me this error pxe - e61, which is where his tent to boot from the network I have read.

  until I replaced my hard drive, he had a strong look that has disappeared since I replaced it.
  the disk hard im trying to use now is off my brother's mobile which all ready installed xp on it it would make a difference when you try to boot from the hard drive? (my laptop is xp)

  I read something on definition of my hard drive to the master and my cd player to the slave that would make a difference and how would I do?

  I think it's as much information im aware off

  could someone please help as im stuck and did not have any idea what to do

  Post edited by: domio
  o im also getting the and pxe - e61 pxe - m0f error code

  Hello!

  What happens to an error you get? Please post what we can help you.

  To be honest that I n don't know what you mean with clip Ribbon keyboard but if the keyboard is faulty or something else, the keyboard completely must be exchanged. You are not a unique key or something else.
  If you want a new keyboard or other spare parts contact your local ASP.

  Good bye

• Satellite A660-186 does not start when the USB nano-receiver is connected

  Recently I bought a mouse a4tech g7-750 with the nano-receiver into usb port plug.
  After the nano-receiver is inserted into the USB before lighting, computer laptop does not start.

  Only the cursor is displayed, so that it is displayed before the screen with the ability to enter the F2 BIOS or select the F12 boot device.
  Without the nano-receiver laptop runs without problem.

  Any advice?

  Thank you much in advance.

  Hello

  During the POST (power on self-test) all parts laptop as RAM, motherboard (also of connected devices) is enabled.
  If a problem (compatibility problems, etc.) would be detected during POST, then the laptop would not initialize correctly.

  This mouse nano-receiver is unknown to me and I m not very well what s wrong with this unit, but I doubt that this problem is related to the laptop.
  I guess that the laptop starts properly with other devices connected to the laptop. right? Well well, in such cases, there s no question cell phone but the 3rd unit affect the functionality of the laptop.

• Equium A100-338 does not start the OS Vista - update Bios?

  Hi guys,.

  My laptop (a few months) decided to die and was told by tech support that it might be because of the BIOS. The problem is that the computer does not start the operating system (Vista) and the update of the BIOS available only is the version of windows. Are there any other mirror to get the traditional update or even a way to convert a the update the BIOS from Windows startup disk?

  Thank you

  Hello

  If you can see that one version of BIOS on Toshiba page then only one version exists and is available!

  > The problem is that the computer does not start the Vista operating system
  I don t think that BIOS could be responsible for this problem.

  You must first provide more info on this problem!
  The laptop goes to home Toshiba screen? Have you tried to recover the laptop with the Toshiba Recovery CD?

  Please provide details!

• Equium P300-19O does not start

  Hi all

  I have an Equium P300-19O, which I have had the problem. Now the pc doesn't even start not at all. When I turn it on, there is not even a power light and it doesn't do anything.
  Could someone of you please advice me to solve this problem and resuscitate Equium P300-19O?

  Best regards

  Taro

  > Could someone of you please advice me to solve this problem and resuscitate Equium P300-19O?
  You must understand the hat on this virtual path that nobody of can say for sure what is wrong there and we can only speculate on the potential problem.
  Who knows what's wrong there. Maybe there is a problem with electronic control gear.

  Unplug the power plug, remove the battery and leave it for a while. Try to start the laptop with AC power only.
  When you connect the AC power supply is LED on indicator system turned on?
  Is there a reaction when you press the power button / stop?

• Equium P300-190 does not start after battery

  Hi all

  The battery died on my laptop, Toshiba Equium P300-190 and power off.
  I have pluged in the output, but it won't start. The light is not yet on the front of the PC.

  Please shed some light on this problem on the issue that can be resolved.

  Thanks in advance

  Concerning
  Taro

  Hello

  Try this:
  Remove the battery and unplug the notebook sector.
  It takes a few hours (in my case, I left the laptop throughout the night disconnect battery and network.)
  Then reconnect the two parts and check if the laptop lights

  If it s hardware problem without gravity, then the laptop must turn on, otherwise you will need professional help

• Equium A200-1VO does not start and makes weird noises

  My Toshiba Equium A200-1VO don't load on Windows entirely, which means I can't use it. When you turn everything goes well until the Welcome screen in Windows Vista. From there, it starts to get weird creaking and it beeps from time to time. It won't start here and these sounds do not stop.

  Help please

  Hello

  Is it possible to know where the noise comes from?
  As suggested by above user, it could be a HARD disk, but in this case, it would mean that HARD drive failures and he could die in the next time

  You said it s begin properly until appears the window Vista would be
  So maybe it s only a problem of software but I m still don t know what part of the software would create such sound however, I think that if would not be bad to reinstall the operating system in order to check the notebook with factory settings.

  If this strange question would persist or if you would not be able to reinstall the operating system using the recovery disc then a hardware problem could cause this strange things and I think it means that you will need to contact the ASP in your country for a material test

• Ieee 1394 host controller Texas Equium A60-692 does not start

  Hello!

  I have a Toshiba Equium A60-692 about 2 years old. On rare occasions the above will install and also the network/ethernet card etc with it when it starts. But 99% of the time it fails to start upward.

  Tech from Toshiba tell me it's the CMOS battery, but time slept OK for the last week so maybe it could be something else. Other strange things are can only recognize the drive HARD to start from what IDE Standard is chosen in the BIOS options (Enhanced IDE option and I think only used normal overall, ups causes boot errors). Also a green screen with weird graphics on occasion. Also the speed of the processor can be reduced, as shown in the properties of my computer.

  Any ideas from anyone as worried of wasting time to unsolder the battery if this isn't the problem. Could this be a fault of the motherboard that is irreparable? I am a relative novice if need help someone here. This made me!

  Hello

  I think you might be right. Eventually he s a small part on the motherboard that could malfunction.
  If I m not mistaken the controller IEEE 1394 Texas Instruments could be the Firewire port and it s part of the mobo

  Welcome them

• Equium A60-173 does not start after the BIOS update

  Hello people,

  I downloaded a BIOS updated toshiba for my Equium A60 - 173 and while it was loading on, restarted my laptop. Now, whenever I turn it on, the power light comes on for a few seconds, there is nothing on the screen and then it turns off again. I'm really worried, I've done some serious damage. I know a bit of the BIOS, but not that much. I need help, this is how I put a BIOS on here if I can't turn it on and the current one is damaged. Is it possible to get the loaded BIOS on without being able to turn it on?

  Any help will be greatly appreciated! Thanks in advance.

  Concerning
  James

  You could try to remove the battery, wait 2 minutes and then go back, however he only its not very likely that your BIOS update was not successful. If I remember correctly when I flashed my A60-181 this process takes about 10 minutes. If your laptop prematurely reloaded until the program has finished, I'm afraid you have no choice but to send new to Toshiba to be fixed.

  Richard S.

• Sometimes Equium A110-233 does not start correctly

  I've cured it 3 times this year, but why is it?
  Basically you turn on, small rotation of the fan and crashes. No activity of HD or DVD.
  Unsolder strip down one side of the battery of the bios for 10 seconds. Welding again, rebuild and all is well again.
  Until the next time.

  No idea if this is common on this model?
  Hope that healing can help someone with these symptoms.

  Hello

  > I've cured it 3 times this year, but why is it?
  I think that no one will be able to provide a solution to this issue and whole exactly.
  Is that it doesn t happen permanently, but only sometimes and it s not easy to reproduce the problem
  I think the laptop detailed audit to locate the fault.

  > Desoldering strip down one side of the battery of the bios for 10 seconds. Welding again, rebuild and all is well again.
  I think it was really a bad idea to disassemble the laptop.
  Why? Because this invalidates the warranty!

  So what to do?  :|
  According to me, there's only a way o learn what s wrong. The ASP must be contacted. Technicians can run diagnostics tests and find the fault.
  Here, we can speculate on the fault. Eventually and dysfunction of the mobo or the faulty BIOS battery.

• Equium A200-1V0 does not start after recovery

  Hi all

  I have Toshiba Equium A200-1V0.

  I wanted to restore Vista back to the factory settings and used the recovery disc - everything seems to go well, selected 'no' on the disc Add on to the end, as I don't seem to have one. When you restart the laptop, it goes beyond the post screen, then darkness... nothing happens at all.

  Now, I thought that maybe there was a hardware problem, so I tested it using a copy of Windows XP I - installs fine, no problem. I noticed that the recovery partition "Winre" was 1.5 GB in size and 1.37 GB free. I guess that's complete, it contains a file called "boot.sdi" and the folder called 'sources' in the 'sources' folder there is a file called "boot.wim" and that's, I don't know if this is right.

  Whatever it is, I can't get the thing to work with the recovery disk (Vista Home Premium) and there seems to be no hardware issues that XP is fine.

  Any ideas would be greatly appreciated.

  Thank you

  Danny

  Try to remove all partitions on the HARD disk and re-run recovery.

  You can use FDISK on a BACK (www.bootdisk.com) boot disk to delete partitions non-dos.

• Satellite L100 - cooling fan does not start up more

  Hello

  On my L100 laptop cooling fan doesn't seem to work! It does not start up more and after awhile the laptop shuts down as it is too hot. What can we do?

  See you soon
  Mark

  Hi Mark,

  The fan lights normally the POST process before loading the BIOS. Your laptop will continue to boot normally, I presume that your fan control electronics is still viable, otherwise the MESSAGE would fail. So, it seems likely that the problem is with the fan itself. I suggest you check that the fan will run in fact and it missed upward (try to blow strongly in grids).

  If you laptop is still under warranty, then you must contact an ASP to get the fan replaced.

  Kind regards

• Equium M40X: I get to the banner of Toshiba, but Windows does not start

  When I start my 2 year old Toshiba Satellite M40X, I get to the banner of Toshiba, but Windows does not start. I tried using the recovery CD and it does not either.

  Any suggestions as to what could be the problem?

  Hello

  What do you mean with the banner of Toshiba? Did you mean the Toshiba splash screen that appears at the begging of the boot?

  Equium M40X successfully passed this screen?

  If the laptop is unable to switch to the home Toshiba screen then I presume that the BIOS has detected a hardware problem.
  In this case primarily the motherboard fails

  But if the laptop is able to spend the Toshiba start screen, the motherboard must be ok and only a 3rd device malfunction as HARD drive could cause this problem.

  Try to study a little

• Equium does not start after Exchange VGA and motherboard

  Greetings.
  I have a satellite that were replaced VGA & mainboard, but it does not start. There power correctly and power & switch are turned on but there is no image on the LCD or external. HDD led flashes but nothing more.

  I tried a different CPU and RAM modules.

  In other threads with similar problems seems to be a problem with the screws but I tried to remove all the, winding or change.

  Im stuck with this and have need of any kind of help.

  Thank you

  Try this:
  Remove the battery and the AC adapter, wait up to an hour, plug in the battery and the AC adapter and try again to restart the laptop.

  In my opinion, a problem with the motherboard. The new mother is maybe defective.
  You have replaced parts by yourself?