Photosmart 6515: Printer will print 10 Windows with HP full software

Similar Questions

• My photosmart c4599 printer is compatible with windows 7 64 bit?

  I just bought a Slimline Pavilion and hung my c4599 photosmart all-in-one; but it was not detected by windows.  I tried to download a driver on the HP website, no luck, downloaded the printer installation wizard, still nothing.  Is there a driver for this printer compatible with Windows 7 64-bit or not?

  honeydobee,

  There are readers that you can download for Windows 7. You can go to the link below to find:

  http://h10025.www1.HP.com/ewfrf/wc/softwareCategory?product=3757826&cc=us&LC=en&DLC=en&product=3757826&tmp_track_link=ot_search

  Below the download section is also a "Update" section with a download "HP Software Service Pack". I think this will help with the Windows 7 installation problem that you are experiencing.

  Andrew

• Photosmart C5580: Printer on Windows 7 networking don't print network shared computer

  I've been trading emails with HP support for several days now on this problem and they are unable to solve.

  I have a Photosmart C5580 all-in-one printer connected to a computer HP Pavilion 64 bits with Windows 7 Ultimate edition.  I shared the printer and created a homegroup with one not also loaded with Windows 7 Ultimate 32-bit HP.  Also on the network is a laptop HP with Windows 7 Ultimate edition.

  That is the problem.  I can print the C5580 of the host computer and the HP laptop.  The printer will not respond to the 32-bit computer with the print job hanging in Quebec with an error.  Of course, the window Troubleshooting Wizard is no help.  I installed the package of windows 7 HP printer on all three computers.  I added the printer through the Add Wizard of the printer, tried to add network printer connection, add a TCP/IP port for the printer properties to the 32-bit computer.  I followed the instructions of

  http://support.HP.com/us-en/document/c01886193

  HP and I have run each step resolution of problems they can think of and we begin to repeat.

  Does anyone else have this problem and how did you solve it?

  It is a 32-bit to 64-bit problem. Turns out that the driver for the x 86 processor must be installed on the two computer and vice versa for a 64-bit computer, trying to pint on a x 86 processor.

  I found the solution on microsoft technet at http://social.technet.microsoft.com/Forums/en-US/winserverprint/thread/6067a35d-d9ac-4f52-8beb-9aca3f116e9e

  Here's what I did to remedy.

  On the printserver 64 bit, I opened the printer sharing tab properties.

  Then I opened the button drivers additional.

  The x 86 processor has not been installed.

  I sailed on the network to the 32-bit computer and wanted by the printer drivers in the c:/windows/system32/driversStore/fileRepository to find the prnhp00r.inf.

  After I installed this driver, the printer would answer correctly.

• HP Photosmart C310 print black even with new cartridge

  HP Photosmart C310 cannot print black. Replace the cartridge and ran clean printhead multiple times. Still nothing. Print head alignment failed. Printer does not turn off with power button. Recycled/restarted by pulling out the plug, count to ten and reconnect it.

  Nothing changes except power button works again.

  The steps in this post can help.

• iPad for photosmart 6515 printing options

  Is it possible for all of the default in grayscale printing when printing via airprint from iPad with ios 6.0?

  I updated the documents printed from the computer in grayscale by default on my windows computer which applies only

  Thank you

  Hi again!

  Sinc ei use printcentral myself I wanted to check for myself on the gray-scale

  If you open your document and select the icon for the printer, scroll to the bottom of the print window that appears and there should be a slider swetch Grayscale Toggle for? see how you go with that

• HP Photosmart 3310 printer. Problem with new cartridges hp 363 original.

  I live in Italy and I bought an all-in one HP Photosmart 3310 U.S.. Once the original ink cartridges were being run-out, I bought a complete set of original HP ink cartridges that are new in Italy. Now, the printer screen displays the following message: "Printer set up to use ink cartridges 02" and do not want all works. The ink cartridge, I bought was 363 (n.6 cartridges for all 70 euros!). Please let me know if there is a way to change the configuration of the printer and allow it to work with 363 cartridges instead of 02. Thanks in advance for your answer. I'm looking to pass on your instructions. Best regards. Carlo of Urso

  Of course, I can't speak for cdurso, but for my part, HP refused to help me with the reset of the region. Some representatives of the foreign customer support told me simply repeatedly that my printer was obsolete, and that I had to buy a new one. However, I found a solution very simple to my problem. I simply pulled the chip on the ink cartridge in the region that the printer has been set to, and I stuck on my new cartridge. I think that this would negate my ink level readings, but it allows me to use the printer, which now works perfectly. I just have to ignore the "expired cartridge" message I get every time I need to activate or reset it.

• I can't install my wireless dn P2015 Printer Laser Jet with MS 7 software.

  For three years the P2015 worked 'Wireless' on my Lenovo T60p with microsoft XP.  He walked through my router wireless and print correctly.

  I have just updated the software MS 7 (32 bit, 2007) and the printer will not work on the router.  I plugged the printer up directly by cable, downloaded printer out of MS 7 software drivers and it worked very well attached.  The router works fine with MS 7 for internet and e-mail on my computer and other computers (even MS XP) on the router.

  I tried to install the 2015nd Jet Laser using the driver CD that came with originally and I come to the screen 'looking for available printers' and there is nothing in the box below to choose (white screen).  It will but a routine "looking for available printers' and finally the message came"no printer has been found. "  This same thing happens when I try to download drivers HP Web site.  I get the same screens and the same results.

  What should I do?  (I am a beginning computer knowledge level)

  Is the Control Panel on the printer itself?  Where is the control panel of the printer?

• Photosmart 6515 does not print black ink after replaced the cartridge

  I am very frustrated! I can't get my Photosmart 6515 print black ink.

  Our school sends the documents by e-mail now that we have to print at home. Ideal for them, but not for me. They are usually in PDF format, so I do not have the ability to edit and change the blue color to print, either.

  I only use HP cartridges on this printer. I know it's more than a year, in order to call phone support will do no good.

  I replaced both cartridges and now it shows black ink completely full, but when I print the printer status report, black is not displayed. Black does not appear on the tool pages, either.

  I tried the command "clean printhead" several times. I unplugged and waited. I took all the cartridges. Connections look clean.

  What should I do to perform a partial reset or full?

  Hi Photokool,

  I understand that this has been a frustrating experience for you, and I want to help him.

  I will send you a private message, please check the little envelope on the upper right of the forums page to check your Inbox of Forums.

  

• are will fix his problem with newer versions (16.0.2) that causes the game of music 2 b/g so voice strong audience is * Impossible *? PLEASE?

  When loading a clip of FF w / sound of any kind, if there is no b/g music-everything is acceptable * except a much lower volume level * that older versions had. BUT if there is no b/g music game - * IT * (b/g, music) will BE COMPLETELY DROWN OUT ANY VOICE CONVOs!

  Hello

  You can try to adjust the volume in the individual controls of media on Web pages. You can also try to set a level of minimum volume individually for Firefox, Flash, Silverlight etc. in the Mixer Panel Windows operating system: click the icon on the toolbar State Windows bar tasks > mixer.

  If the problem persists, you can reset Firefox and start over.

  The reset Firefox feature can solve a lot of problems in restaurant Firefox to its factory default condition while saving your vital information.
  Note: This will make you lose all the Extensions, open Web sites and preferences.

  To reset Firefox, perform the following steps:

  1. Go to Firefox > help > troubleshooting information.
  2. Click on the button 'Reset Firefox'.
  3. Firefox will close and reset. After Firefox is finished, it will display a window with the imported information. Click Finish.
  4. Firefox opens with all the default settings applied.

  Information can be found in the article Firefox Refresh - reset the settings and Add-ons .

  This solve your problems? Please report to us!

• HP Photosmart D110 printer will not install with Windows Vista?

  HP Photosmart D110 printer will not install with Windows Vista?

  Hello

  (1) what happens when you try to install the printer?

  (2) you get an error message?

  Method 1: You can run the fixit available in the link below and check to see if that makes a difference

  Problems printing and printing errors

  http://support.Microsoft.com/mats/printing_problems/

  You might want to know

  Add or remove a printer

  Thanks and greetings

  Ajay K

  Microsoft Answers Support Engineer
  ---------------------------------------------------------------------------------------------------------
  Visit our Microsoft answers feedback Forum and let us know what you think.

• HP Photosmart 7150: My HP Photosmart 7150 printer won't print with Windows update 10

  I can't update Windows 10 my HP Photosmart 7150 printer.  It worked fine with Windows 7.  What should I do to have it printed with the new update that Windows has to install on my computer.

  Hello

  I'm afraid that your printer is no longer supported on Windows 10, windows 7 was the last operating system support for your printer.

  You can find any Windows 10 compatibiity information isted in the following link:

  http://support.HP.com/us-en/document/c04658195

  Kind regards

  Shlomi

• Print 'canvas' with a printer of All - in - One Photosmart 6515

  I want to print some of my images on the paper "canvas" product that is available for inkjet printers.

  The 6515 printer will print to the "Web"?

  What brand of this type of paper HP recommends?

  Should what the printer settings I use to get the best results?

  Are there any other tips or tricks that will help me to get the best results?

  The "Web" leave debris on the printhead which will cause problems?

  Am that I better off buying Matt finish paper 8.5 x 11 and framing the photos?

  Thank you.

  You can use the canvas into the printer, it will usually take a backup on the Web to help him run through the machine. Regarding the possible debris, which will be determined on the canvas that is used and how it is sized for printing. Sometimes there are stray fibers that can get stuck in the mechanics. I'm not familiar enough with the process to make any recommendation, because it is generally a question for printers large format.

  To operate, you will need to just the size of the canvas for a printable option and make sure it is set enough media to feed into the printer safely.

  Honestly, I would recommend the matte finish photo paper. The resulting image looks great, has a clarity and a fantastic time.

  I hope that answers your questions! Have a great day!

• Have renewed my subscription ExportPDF, but still pop up with window 'your course has expir├⌐' when will convert via the printer driver window. Comments / help welcome thanks :-)

  Have renewed my subscription ExportPDF, have the confirmation e-mail, but still up pop with window 'your course has expiré' when will convert via the printer driver window. Comments / help welcome thanks :-)

  Hi azza675,

  ExportPDF converts PDF files to Word and Excel formats (and many others). What you describe, sounds like you are trying to convert a file * to * PDF. Have you ever started a trial of Acrobat, maybe? (So that you can create PDFs with Acrobat, ExportPDF don't allow you to convert files to PDF.)

  What happens when you connect directly to ExportPDF to https://cloud.acrobat.com/exportpdf?

  Best,

  Sara

• Advances of paper but will not print using Windows XP, computer HP Pavilion DV6000 CTO laptop and HP PSC 2210 all in one with USB

  Communication takes place properly between the printer and the computer.

  Paper advance but not printing on the page.

  Printer copies fine.

  Pilots are underway.

  Help, please!

  Hi GraceWolf,

  You did it of any material changes or software on the computer before this problem?

  You can follow this link & check if the problem persists.

  Printer in Windows problems

  Hope the helps of information.

  Please post back and we do know.

• Photosmart 7520: Printer Wizard does not work on Windows 10

  My PC has recently upgraded Windows 10.  I am now having a problem with the Printer Wizard.

  Previously, I had the status display, the ink levels, scan document, check printer heads, etc.

  Now all I get is a printer configuration screen that has 3 options

  -connect a new printer,

  -convert a USB printer wireless, and

  -Add new software.

  How can I get the correct printer assistant screen to run?

  Thank you.

  Hi @AJA3,

  Thanks for joining the Forums of HP Support for a solution to your problem of HP printer Assistant.

  I understand that you use a HP Photosmart 7520 e-all-in-one printer with a computer who has recently upgraded Windows 10 and now, when you click on the printer icon to open the HP printer Assistant you get the "connect a new printer"window. " I would like to help with that.

  It is not that the HP printer Assistant does not work, but probably the printer probable network needs to be reinstalled.

  I would like to start by uninstalling all software that was installed before the upgrade to Windows 10 relating to printers. Here is a support document which can help needed - uninstalling the software of the printer (Windows).

  If you get prompted to restart the computer when uninstalling, go ahead and do the restart. If this isn't the case, restart the computer after the uninstall is complete.

  Once the computer is ready, try to use the HP printer installation wizard for installation. This tool will find the most recent version of the printer software and installation help.

  Please let me know if that solves the problem, or if you need assistance.

  Indeed, if this help you to achieve a solution please click the 'accept as Solution' and the 'thumbs up' buttons down below in this message.

  Thank you!