Satellite A10 dies after the power LED blink

Similar Questions

• Satellite A205 freeze after the power connection

  My computer has this strange problem. It stops completely after that I have plug in the power supply.
  What I do now, it is let it recharge when it is off and use it without food.

  There is a chance that it works with the power connected, but generally, it stops again in the trunk.
  If the battery is low and I connect the power usually, it stops right after that I do, sometimes not.

  I also tried to install Linux. But the same thing happens (except by the fact Linux only stops in the trunk)
  I'm now using Windows Vista.

  Thanks for the time and sorry for the English.

  > any suspicion?
  As suggested above; It looks like an electrical problem on the motherboard power supply. Maybe the motherboard must be changed.

• Satellite Pro A120-151 - switch and power LED blinks

  My 120-151 will stop when I used it. On the laptop, the power LED flashes: short-long-long-short-short-short-long-short

  Anyone know what this error code?

  Hi mate,

  I had a similar problem which stops my Satellite A300 and the power light was blinking. This happens always after 1 or 2 minutes.

  I decided to contact an authorized service provider. Technicians control the laptop and fix it for me. The repair took only a few days and it was free because the laptop was still under warranty.

  I hope I could help a bit! :)

• (Model: D6000 ac750) Only the Power LED comes on after start

  Hello

  When I turn on my router, only the power LED comes on, no other LED lights. Ive been waiting for awhile as well, switching router on and outside, from time to time but its still the same result, only power LED lights

  I think this happened because of the failure of an attempt to upgrade my modem firmware, which I clicked on another tab, stop the download. After that, the modem turned off and only the power LED came on when I switched it back on

  any help would be apperciated, thank you

  NotGTAV

  I would say that the modem can be bricked you wish to contact Netgear phone support if it is still under warranty.

  http://support.NETGEAR.com/general/contact/default.aspx

  DarrenM

• Satellite P300-16 t - power power LED blinking

  I replaced my old charger yesterday and when I plugged the new charger yesterday everything was fine, but when I plugged this morning the power led continues to blink continuously. I took the battery and everything all right, the power led remains lit.

  What I need to get a new battery or is there something else that needs to be replaced?

  A new charger the same previous specification?

• Qosmio X 500 does not start and the power LED is flashing every 5 seconds

  Hello
  I need help my X 500 does not start now. I tried to launch the NB as usual and suddenly the X 500 start or even power up.

  If I press the power button / stop it makes no noise, the power LED on the button and the second power LED just bliks once and turns on and keep blinking every 5 seconds.

  I tried to:
  * Remove battery and power up with AC only
  * power only to batteries
  * remove the battery power button hold for 30 seconds and over power with AC, battery only athen

  but it did not help.

  I checked the LEDs AC & battery, but they do not blink, they are just RED, so there is no problem in battery or AC.

  No idea where could be the problem?

  Thanks for help
  Frantisek

  Hello

  The failure of RAM could be the reason for this behavior of the laptop.
  Remove the RAM modules with good modules tested and check the functionality of the laptop.
  In the case of RAM isn t the troublemaker, the motherboard could be affected.

  Good luck and share your experience with us.

• I can't start with Satellite P10 by pressing the power button more

  I can't start my Satellite P10 by pressing the power button more.
  Sometimes, very rarely its starts when I hold the power button for a while say 10 seconds.

  I tested the power supply and a battery to my friends P10 (of the same type) and both work very well.

  So it must be a problem with the key.
  No idea what to do?

  Thanks for any help

  The best.

  Tobias

  If it s a button or a power supply electronic problem, then you can't do anything.
  In this case assistance by the technicians of laptop would be necessary.

  But the next time that you should try this option if the laptop turns on not;
  Remove the battery and unplug the AC adapter from the laptop for about 30 min.

  After this short period of time to reconnect the two parts and check if the laptop could start.

  Good luck

• Portege R100 stoped working - the power LED flashes error codes

  I have a R100 that has suddenly stopped working.
  The power led (clear amber with the image of the power wire) flashes what appears to be an error code of 5 flashes with a long pause on the last flash, followed by 3 flashes.

  That - what it means, and where can I get a list of all codes error?

  I changed the main battery, changed the spare battery and changed supply - and again, I get the error permanently. I was not able to power the laptop at all since it started. When you press the power button / nothing happens.

  I hope someone on this forum has some information that may help you diagnose this problem. Tech support representatives Toshiba post here?

  Thanks in advance.

  Hello

  I m not a R100 owner but to me it looks like a card mother malfunction because you have already tried to exchange the battery and the AC adapter.

  In this case, the best solution would be if you go to an authorized service provider. Technicians can consult the specifications and they know what means this code I think.
  Here it s only a user to user forum and I have never seen anyone from Toshiba again.

  Anyway, here you can search for the nearest ASP:
  http://EU.computers.Toshiba-Europe.com-online decision-making supported downloads & => find an authorized service provider

  Good luck!

• Have HP Pavilion dv2500, won, t turn on. When you connect the power supply blinks blue.

  Have HP Pavilion laptop dv2500, p/n kn997ua #aba, does not illuminate. When you connect the power supply blinks blue.

  Now you can take the laptop at best buy or Wal-Mart and get them to plug a power cord. This will give you an idea if you need to buy a power cord or not.

  Again, you can always buy the power supply cord and if it does not return.

  THX

• Z820 - button Power LED blinks 4 times (red) with beep... bad card (Quadro 4000) graphics?

  Hello

  My Z820 at the office is suddenly having a few hardware malfunction.

  When I turn on my machine, the PSU/system fans don't rev and the Power LED button flashes red with a beep 4 times.

  According to this page of troubleshooting, this indicates a faulty PSU on the new UEFI computers:

  HP desktop - computer does not start and emits a LED or a beep Code

  Section "code beep and LED descriptions.

  Get the exact model of LED as the example of "power failure".

  Then, I got a new power supply replacement. I still have the exact same model LED and beeps...

  So, I have drawn deeper and found that when I removed the Quadro 4000 card graphics and then put on my machine, the power button LED is lit in blue (led code ' computer-S0 (normal operation) "") and all the normal spin fans.

  The Quadro card seems to be the culprit...

  Unfortunately, I have no alternative graphic card laying to verify this around, I'm waiting for a replacement of the graphics card (via HP service) to arrive tomorrow.

  Is it possible that the power LED button code (4 times red with beep...) has nothing to do with a bad power supply and that my Quadro is bad?

  Dries

  Dry... that Z820 has been giving you headaches.

  Many fault codes have not changed since the previous workstatons.  I hit this series of beeps of error in the past, and often doesn't mean that the power supply itself is the cause.  It can be a hardware device to the bottom of the chain causing a power surge to power, triggering his "crowbar circuit: fault protection

  http://en.Wikipedia.org/wiki/crowbar _ (circuit)

  Here are the instructions to deal with this series of beeps of a previous HP xw technical and repair.  Note the number 2 in the troubleshooting instructions... usually you don't have to go down to 3, in my experience.  I think that you have already found the faulty unit:

  Loss of power.
  1. open the access panel and make sure that the power cable is properly
  connected to the system board.
  2. Locate the faulty device by removing all devices and then reinstalling one at a time
  until the workstation fails. Replace the device at the origin of the failure. Continue to add
  devices to make sure that everything works correctly.
  3. check the power supply feature.
  a. turn off the AC power.
  b. remove all cables internal power on the system board.
  c. connect the power supply.
  ● If the power supply fan turns and the BIST LED lights, then the
  power supply is good. Replace the motherboard.
  ● If the power supply fan does not turn or the BIST LED does not
  light up, replace the power supply.

• Satellite Pro L650 turns off after start; DC In and Power LEDs blink on stop

  A friend Satellite Pro L650 having worked well until yesterday, all of a sudden turned itself off. Now, at startup, it lights up normally for about 10-15 seconds before turning off suddenly. Turned off, the DC in white/blue LED and the orange Power LED Flash on a broad set of intervals of approximately one second. This extinction happens if I leave Windows or press F2 to enter the BIOS setup.

  I guess this blinking is intended to serve as a kind of diagnostic code, but I have yet to track down what it means. Can anyone help?

  To avoid confusion, power without the product stack the same, sudden stop experience, except the two LEDs remain solidly lit this time. With or without battery, trying to turn on again immediately after that a shutdown produced no response at all. Remove the power cable and immediately it reconnect again and turn then produced a brutal power off, but in less than 5 seconds. More wait between attempts to market seems to give a little longer powered on State, but without fault, the machine turns off just suddenly. With its short time 'turned on' we are talking, there cannot be any kind of thermal protection?

  I had an old Satellite L450D lying around that uses coincidentally the same AC PA-1750 adapter, but use it made no difference. Of course, the battery does not have the L650!

  The only previous numbers, that I am aware of this machine have been intermittent case of Windows reporting "Plugged in, not charging", but as my friend use it exclusively on the network, it was not a problem.

  Your thoughts will be greatly appreciated...

  WTF?

  What is an unmoderated forum?

  Can someone help with my problem?

• Satellite A130/135 dies when the power adapter is connected

  Yesterday, my laptop satellite A130/135 completely dead in use.
  Even the lights indicating that the laptop is plugged into the custom of light.

  I read today that by removing the battery, hold the power button and place the battery back in place, I could get the laptop to turn it.
  It worked, but after that my battery is low I plugged my power adapter and the laptop is returned to its State does not.

  So now I have a limited amount of battery power and it does not load.
  Yes, what's wrong with my computer laptop/battery/adapter

  How can I solve this problem?

  Hello

  I found your other thread:
  http://forums.computers.Toshiba-Europe.com/forums/message.jspa?MessageID=143840

  It seems that the problem might be related to the hardware failure and all you can do is contact the ASP in your country.
  I put really know what might cause this problem but I think it could be something wrong with the motherboard

  To check the device by a technician of ASP.

• Satellite R840-139 - Power led blinks

  Hello
  Sorry for my bad English :-).

  a computer whose power LED flashes orange. I tried to read the error code is 01001010 = 4 Ah. I think my computer has a bit of a shock, but I'm not sure. It would be a failure but 3V but which?

  I tried to press and hold the power for 30 seconds and reconnect the power supply and the battery and nothing changes. I measured the voltage charger is about 19V.

  He had already put in this fashion several months ago, but has restarted.

  What can I do?

  3V resembles the RAM. Try a different RAM module.
  If it still does not respond, it may be a faulty motherboard.

• Satellite A100 - turns off the power after 60 seconds

  After pressing the power button, the laptop starts but 60 seconds from the moment it is activated, the it turns off suddenly?

  The fan turns, I tried cutting dvd, wireless, modem, ram, hard drive, it opens and clean all the dust. It turns off after 60 seconds exactly every time

  Any ideas?

  Thank you
  Ben

  Hello

  > and clean any dust
  How did you do that?
  Usually, you can use jet of compressed air to clean the laptop and remove the dust that blocks the fan. That is why it s not necessary to disassemble the laptop as you can read here:
  [How to clean a Toshiba laptop cooling system? | http://forums.computers.toshiba-europe.com/forums/ann.jspa?annID=40]

  And the same thing happens if you access the BIOS instead of starting in Windows?

• Satellite Pro A120: AC power-power LED blinks orange

  Hello

  could someone tell why the power supply light is orange flashing?

  In this case my laptop don't turn on.
  Its has turned on the strange, 1 or 2 times only that when the display shows the deskstop it turns off automatically.

  > could someone tell why the power supply light is orange flashing?
  The LED flashes as an error and the fault on the motherboard has been detected!

  The LED gives an error which can be read by Toshiba ASP. technicians

  This is why I would recommend contacting guys for control of the laptop!

  Good luck