Satellite P300-16 t - power power LED blinking

Similar Questions

• Satellite A65-S065 - button Power LED is blue & amber at the same time

  1st off I have a S065 A65 and worked well after a replacement motherboard, my fault, he had to be replaced.

  In any case, I have the power button LED is blue & amber LED light up at the same time. Anyone has any idea as to what it means, or maybe I'm going into something, I don't know what it is and it should be reset at the back. Any ideas?

  Thank you
  Ben

  Hello

  I checked the manual of the Satellite A65 and there I can find information that the Power LED blinks orange indicating the machine is in standby mode. So for me it sounds like that your laptop is in sleep mode.

  What happens if you click Start > stop and choose the closing down in the menu drop-down? Normally, the power LED button must be turned off and also the laptop is in sleep mode.

• Satellite Pro L650 turns off after start; DC In and Power LEDs blink on stop

  A friend Satellite Pro L650 having worked well until yesterday, all of a sudden turned itself off. Now, at startup, it lights up normally for about 10-15 seconds before turning off suddenly. Turned off, the DC in white/blue LED and the orange Power LED Flash on a broad set of intervals of approximately one second. This extinction happens if I leave Windows or press F2 to enter the BIOS setup.

  I guess this blinking is intended to serve as a kind of diagnostic code, but I have yet to track down what it means. Can anyone help?

  To avoid confusion, power without the product stack the same, sudden stop experience, except the two LEDs remain solidly lit this time. With or without battery, trying to turn on again immediately after that a shutdown produced no response at all. Remove the power cable and immediately it reconnect again and turn then produced a brutal power off, but in less than 5 seconds. More wait between attempts to market seems to give a little longer powered on State, but without fault, the machine turns off just suddenly. With its short time 'turned on' we are talking, there cannot be any kind of thermal protection?

  I had an old Satellite L450D lying around that uses coincidentally the same AC PA-1750 adapter, but use it made no difference. Of course, the battery does not have the L650!

  The only previous numbers, that I am aware of this machine have been intermittent case of Windows reporting "Plugged in, not charging", but as my friend use it exclusively on the network, it was not a problem.

  Your thoughts will be greatly appreciated...

  WTF?

  What is an unmoderated forum?

  Can someone help with my problem?

• Satellite Pro A120-151 - switch and power LED blinks

  My 120-151 will stop when I used it. On the laptop, the power LED flashes: short-long-long-short-short-short-long-short

  Anyone know what this error code?

  Hi mate,

  I had a similar problem which stops my Satellite A300 and the power light was blinking. This happens always after 1 or 2 minutes.

  I decided to contact an authorized service provider. Technicians control the laptop and fix it for me. The repair took only a few days and it was free because the laptop was still under warranty.

  I hope I could help a bit! :)

• Satellite R840-139 - Power led blinks

  Hello
  Sorry for my bad English :-).

  a computer whose power LED flashes orange. I tried to read the error code is 01001010 = 4 Ah. I think my computer has a bit of a shock, but I'm not sure. It would be a failure but 3V but which?

  I tried to press and hold the power for 30 seconds and reconnect the power supply and the battery and nothing changes. I measured the voltage charger is about 19V.

  He had already put in this fashion several months ago, but has restarted.

  What can I do?

  3V resembles the RAM. Try a different RAM module.
  If it still does not respond, it may be a faulty motherboard.

• Yellow flash - Satellite Pro 6070 DC power led

  I have a Toshiba laptop that I got from a friend, when I push the power button that flashes a green light as if it's going on, but then the DC power led starts flashing yellow. I have looked this up, but wanted to make sure it was good...

  I thought he had 3 batteries on the cell phone the main bios one and another one. I looked at other newspapers on here and tried to run right next to the power, but the same thing happens.

  How would he fixed or what could be the problem?

  Hello

  It dose not sound very optimistic the domain controller IN the witness lights usually green when DC is supplied from the AC adapter.
  But if the output voltage adapters is abnormal or if power outages, this indicator flashes orange.

  Either there is something wrong with electronic power supply on the motherboard or adapter AC is defective.
  I think it s the first possibility and in this case I n t think you will be able to fix it yourself.
  I'm afraid the technician advice and help is needed: (m

• Satellite Pro 2100: strange power LED questions

  I have 3 problems:
  1. when I plug my power, my laptop still the AC plug LED.
  2. when I am on battery, the laptop turns OFF and my laptop provides 100% of battery power.
  3. when I am running on battery, my phone says the AC plug the power LED indicator and battery.

  Please help me
  Thank you
  Tommy

  Hi Tommy

  I think electronic power on your laptop is completely confused. I recommend you contact the customer Service of your country partner. It is unclear to me that you can do something like the end user.

  Only thing you can do is to remove the battery and use the laptop with AC power and be happy that it works.

• Z820 - button Power LED blinks 4 times (red) with beep... bad card (Quadro 4000) graphics?

  Hello

  My Z820 at the office is suddenly having a few hardware malfunction.

  When I turn on my machine, the PSU/system fans don't rev and the Power LED button flashes red with a beep 4 times.

  According to this page of troubleshooting, this indicates a faulty PSU on the new UEFI computers:

  HP desktop - computer does not start and emits a LED or a beep Code

  Section "code beep and LED descriptions.

  Get the exact model of LED as the example of "power failure".

  Then, I got a new power supply replacement. I still have the exact same model LED and beeps...

  So, I have drawn deeper and found that when I removed the Quadro 4000 card graphics and then put on my machine, the power button LED is lit in blue (led code ' computer-S0 (normal operation) "") and all the normal spin fans.

  The Quadro card seems to be the culprit...

  Unfortunately, I have no alternative graphic card laying to verify this around, I'm waiting for a replacement of the graphics card (via HP service) to arrive tomorrow.

  Is it possible that the power LED button code (4 times red with beep...) has nothing to do with a bad power supply and that my Quadro is bad?

  Dries

  Dry... that Z820 has been giving you headaches.

  Many fault codes have not changed since the previous workstatons.  I hit this series of beeps of error in the past, and often doesn't mean that the power supply itself is the cause.  It can be a hardware device to the bottom of the chain causing a power surge to power, triggering his "crowbar circuit: fault protection

  http://en.Wikipedia.org/wiki/crowbar _ (circuit)

  Here are the instructions to deal with this series of beeps of a previous HP xw technical and repair.  Note the number 2 in the troubleshooting instructions... usually you don't have to go down to 3, in my experience.  I think that you have already found the faulty unit:

  Loss of power.
  1. open the access panel and make sure that the power cable is properly
  connected to the system board.
  2. Locate the faulty device by removing all devices and then reinstalling one at a time
  until the workstation fails. Replace the device at the origin of the failure. Continue to add
  devices to make sure that everything works correctly.
  3. check the power supply feature.
  a. turn off the AC power.
  b. remove all cables internal power on the system board.
  c. connect the power supply.
  ● If the power supply fan turns and the BIST LED lights, then the
  power supply is good. Replace the motherboard.
  ● If the power supply fan does not turn or the BIST LED does not
  light up, replace the power supply.

• Satellite A10 dies after the power LED blink

  Hello

  I have a problem with the power supply of my Toshiba Satellite A10. Sometimes, after the computer sat for some time, I have a problem with the power. The "plugged power cable" - LED will start to blink and shortly after, the computer just dies.

  It can also have the time to go into a lower energy state before he does. When it happened once, it will most likely happen also when I restart the computer, but after a much shorter time. WXP won't even have time to start. If I stop to select the source of start-up, the problem will occur anyway, this isn't the software. It should also be noticed that when the computer is not turned off, the 'smart power' - is on correctly.

  I know that my battery is not very good. Completely loaded, the computer can run for maybe 3 minutes with only the battery. I know that I must have a battery connected, even if I use the power cable, but this occurs even when the mine problem. The battery would be pretty bad not even allow me to use the computer with a cable?

  It should be added, that sometimes I can use the computer for long periods of time without this problem to happen. I also have a problem with the battery not being not properly in physical contact with the pins of the computer, but this isn't the problem here, because I have the same problem with the battery removed and me holding the battery in place.

  Thank you for your help.

  Andreas

  Hello

  You description is very long and detailed and it of still not easy to say what's wrong.
  Usually, the DC-In witness lights up green when DC is provided FRO the AC current. If the output voltage of the adapter is abnormal or if power outages, this indicator flashes orange.

  So I think that is your AC adapter malfunctions or there is something wrong with the electronic power supply on the motherboard.

• Satellite Pro A120: AC power-power LED blinks orange

  Hello

  could someone tell why the power supply light is orange flashing?

  In this case my laptop don't turn on.
  Its has turned on the strange, 1 or 2 times only that when the display shows the deskstop it turns off automatically.

  > could someone tell why the power supply light is orange flashing?
  The LED flashes as an error and the fault on the motherboard has been detected!

  The LED gives an error which can be read by Toshiba ASP. technicians

  This is why I would recommend contacting guys for control of the laptop!

  Good luck

• Satellite A200-AH7 - will not power on, only power LED blinks

  Hello

  I have this laptop where all of a sudden it turned off and does not turn upward. All that happens is this flashing electric blue. I tried to remove the battery and just go out of the adapter. I tested the cards that I have two and both seem fine.

  Any ideas?

  Thank you
  Chris

  Hi motopsycho,.

  I think that this flashing of the LED will display an error code or something else that would be useful information for an authorized service provider.

  In any case, before contacting these guys here you should read this article:
  http://forums.computers.Toshiba-Europe.com/forums/Ann.jspa?annID=21

  If this doesn t work, contact the nearest authorized service provider. Guys are going to solve this problem for you. :)

• Satellite U305 no electrical power, battery blinks

  My U305 powers is no longer in place. If the battery connected or not, light battery blinks and nothing else happens.

  Michael

  Hallo Michael

  There must be a serious problem with electronic control gear. If there is a serious problem with that laptop power supply sends hexadecimal code and this code can help technicians to identify the problem.

  I'm afraid of nothing you can do about it, so please contact the nearest authorized maintainer and ask for help.

• Tecra A8: Power led blinks orange twice and does not start

  trying to turn on PC toshiba laptop tecra a8. the light on the power button flashes two times once green and orange and it won't start.

  any suggestions?

  Hello

  It seems that there is a hardware failure.
  The flashing LED provides a microcode of dysfunction. The short flashing 0 flashing medium-long and 1.
  The full code can be read by a maintenance technician, and the reason for the failure could be found very easily.

  But before you contact the ASP in your country, I recommend trying the suggestion given by Robin.
  Remove the battery and unplug the AC of the laptop. Then wait a little (15-20 min) and then connect everything again. Then check if the laptop starts.
  SE not-> ASP.

  Good luck

• Dell studio xps mt135 dead, no fans, no brief power LED blinking when press button

  Dell studio xps mt135 dead, no fans, only brief flashing of LED power when the button pressed.

  I'll have to open it - thought I would like to reset the BIOS settings, see if all 6 GB of RAM work.  I recently made a change to the registry to activate the disk cache system.  Windows 7 is installed.

  I don't think that this has nothing to do with the other question, that I asked audio problems.

  If you can not help me with this problem, please suggest a hardware problem diagnosis forum.

  Thank you.

  Dell studio xps mt135 dead, no fans, only brief flashing of LED power when the button pressed.

  I'll have to open it - thought I would like to reset the BIOS settings, see if all 6 GB of RAM work.  I recently made a change to the registry to activate the disk cache system.  Windows 7 is installed.

  I don't think that this has nothing to do with the other question, that I asked audio problems.

  If you can not help me with this problem, please suggest a hardware problem diagnosis forum.

  Thank you.

  Ask in the forums of Dell.com.
  Sounds like the power or the motherboard.
  Likely to toast.
  Registry setting: coincidence.

• Satellite P300/Q01 - buttons Mute & Media LED is dead.

  Hello, I am running on a P300/Q01. And recently my 2 LED buttons (media) are dead, they light up but when I press them nothing opens / mutes. He always runs the flicker thing however.

  My other keys such as Stop/Play/Next work correctly.

  I tried some solutions like the installation of VFR again, but that did nothing.

  Please help me, because this is my last resort.

  To be honest if fresh VAP installation didn't help all you can do is the last but radical solution install Vista using recovery DVD or HARD drive recovery option.