Satellite C855-1GN does not start the Windows system

Similar Questions

• Satellite A135-S4437 does not start the Vista operating system more

  Hello

  I have a Satellite A135-S4437 old laptop computer for 2 years. It is not start the Windows Vista operating system. When I press the power button, I can't see the screen "in touch with tomorrow TOSHIBA" and below in the status bar is the option press F2 for SETUP or press F12 for the boot device selection menu.

  I tried pressing both F2 and F12, and none of these options has nothing to do. They give just 'Please Wait... "and it remains right on the screen to touch.

  Thanks in advance for any help!
  PG

  Are you can access BIOS by pressing the ESC key?
  Select this check box.

  But to be honest, it sounds like a BIOS problem, and in the worst case, you will need to ask the technician to mobile to help.

  Welcome them

• Satellite A300-288 does not load the operating system

  Hello everyone.

  Today I turned on my laptop A300 and does not load the operating system. In other words, Toshiba logo appears, the message "Press F2 to enter SETUP", but not in continuity with the boot. Yesterday it worked and did not update the BIOS or something else.

  Someone has an idea? I deleted a both SDRAM and vice versa, to check that the problem wasn't RAM, but no. There is no beep. LED touch 'NumLock' and other, power on and off when I have impulses, so the keyboard responding but by pressing F2 or F12 does nothing.

  Thank you very much for your help.

  Start your laptop with F8 and test if you can start the operating system in safe mode.

• Satellite A300-259 does not start on windows

  Hello

  I have a laptop Toshiba A300-259 and I have problems trying to get into windows.
  When I try to start my laptop, it would remain on the screen of the Microsoft logo with no response. I tried to use the HDD recovery procedure (link below) but if the screen jumps just to load Microsoft. I tried also security mode, but when it finishes loading all the drivers it just freezes.

  Is that what I can do before purchasing a toshiba recovery media disk?

  HARD drive recovery procedure

  http://APS2.toshiba-tro.de/KB0/HTD9102IR0000R01.htm

  Hi mate

  Well, if you didn t create a recovery disk previously, you must purchase a new recovery disk.

  If the Windows operating system starts not using safe mode or normal mode and if the HDD recovery procedure does not start then I n t see other options for you to try the recovery disk.

• Toshiba Satellite L70 - B does not start the BIOS or OS

  Hello

  I changed the same parameters (UEFI priority CSM to start: FIRST USB) in the Bios and saved them, now computer laptop does not start, I can't enter BIOS more... Just see a black screen... I tried to remove the pulp and power, clicked on the power 1 m button, but nothing has changed...

  I can fix this please

  Laptop model: Toshiba L-70-B

  Any help please?

• Satellite C855-CCI does not start - I na not create Recvoery media

  My son laptop won't boot say "can not find the HARD drive. The HARD drive IS listed in the BIOS settings.

  The bad news is that it does not create the recovery media - one of the many things he'll "do later."

  The laptop is still under warranty, however, the laptop has Win 8 64 bit installed and I have a recovery disk to my laptop working (a happens with Win8 64-bit) - the simple equation is, can I use the recovery on my son's machine?

  In General, you cannot use it. Recovery image contains all the necessary drivers and laptops both have different hardware platform.
  Enter the BIOS and set it to default settings.

  After having done this, test it once more please.
  You have a disk bootable win7, just to see if HARD drive will be recognized for setting up installation?

  BT the way: what happens when you start Notepad, and then press F8 to display the advanced startup options?

• Satellite C855 - 21Q does not start - BIOS flash failed

  Hello.

  I'm french, sorry if my English is bad.

  I updated the Bios of a Toshiba C855 - 21Q. But during the flash, mobile restarts.

  Now, the computer will not boot (black screen + power on wifi led flashes).

  I'll try the recovery mode.

  I extracted the exe file. Rename the FD PLCSF8. EDM
  Copy to the root of the USB stick (256 MB FAT16).

  Can I plug it into the laptop with AC, HDD, unplug. Just the USB STICK.
  Plug the AC, hold + B key and start the computer.

  But nothing happens. The USB is not read (no Flash)...
  I also tried with the other key like Fn + F / Fn + B / Fn + Esc... still nothing.

  What are the keys to start the recovery.
  The process is correct?

  Thank you.

  Hello

  Unfortunately, you need special BIOS version to be able to Flash the BIOS to USB flash memory.

  The fact is that you could download only the version of the BIOS Win-based driver Toshiba UE page and requires this version of BIOS preinstalled system.

  In your case, it seems that something was wrong during the process of updating the BIOS and the EPROM module was not properly flashed. To resolve this problem, the EPROM module must be flashed once more use special disc of crisis of the BIOS.

  To my knowledge, this can be done by Toshiba approved maintainer.

  However, I have also read in this forum that only users managed reflash the BIOS with Bios Phoenix crisis recovery tool. Not very well where you can find these software but recommend to google.

• Re: Satellite A135-S2276 - does not start, the screen is blank

  I have a Toshiba Satellite A135-S2276, I bought 2 years ago. It worked fine except the clock which has never kept the exact time since I bought it. I turned it off Sunday night as I do regularly. But he could not turn it on Monday afternoon. The power light is not on when you turn it on, but primer. The light remains on but does nothing. The screen is blank when feeding it works.

  Can someone help me with the answer? Thank you

  Dennis

  It's hard to say what is happening to your knees. You can access Bios? Try to connect the external monitor and see (maybe the screen of the laptop disappeared)...

• Satellite P100-347 does not start in Windows

  My recently purchased P100-347 has recently developed a problem where it is unable to start windows, I get the Toshia welcome screen, then the initial xp load screen, but then everything stops and I'm left with a blank screen.

  This happens not all the time, but it only successfully boots up to abut 1 to 10 tent, ideas or suggestions?

  Well, your laptop has successfully passed the POST (power on self-test) and so I n t think there could be something wrong with the material as the motherboard.

  Possibly the HARD drive contains certain corrupt sectors or there problems with the operating system.
  In any case, I think the first attempt should be reinstalling new Windows OS.
  I assume you have a Toshiba restore CD. You use this CD to install the OS.

  After this procedure the laptop should start without any problems.
  But if the problem persists you should contact the service partner because it s unusual laptop cannot start properly. In all cases, the warranty is valid and everything should be done for free.

• Satellite A110-162 does not start under windows

  Hello

  Could someone please try and help, Sunday my satellite was fine, came to do turn, Monday and all I get is the black screen, we apologise... etc and start mode, safe mode with networking, security options it security comms mode, last known good config and start windows normally.

  I tried all these, all safe mode options are is giving me a lot of lines from multi (0) disk (0) partition (1) etc., known last good config, and start windows normally just take me to the screen with the blue dotted line flashing boot to windows then pause then intermittent again until I have manually it turns off. I considered using the cd of restoration but if poss won't lose anything on the computer.

  Any suggestions would be greatly appreciated.
  Thanks in advance and Merry Christmas to all!

  Hello Anne

  I don't know if this can work, but you can try it. Start your computer in Mode safe mode and then try to restore the operating system to an earlier time using System Restore tool.

• Satellite Pro A10 does not pass the Windows page after removing SP2

  Hello

  I have a toshiba laptop Satellite Pro A10.
  I installed windows service pack 2 week last to try to get one of these dongles TNT to work, he never so I uninstalled service pack 2 I was going to try and reinstall it to see if it would work.

  Now, my problem is that the laptop will not go at all, it gets to the windows XP page and then everything stops, someone could help me I don't know what to do!

  Thank you
  Sharon

  Hi Sharon

  Seems that the system files are corrupted on the HARD drive.
  All of the installation and the removal of the service pack has damaged some files or registry entries.

  I don t think you will be able to resolve this situation without reinstalling the OS.
  In my opinion, it's a better way to get rid of this problem.

  Take the Toshiba Recovery CD and reinstall everything.
  If you want to back up your data, I recommend to connect the internal HARD drive to another computer via the external USB HDD controller.

  Good luck

• Satellite L300-135 does not start in windows!

  bought about 2 years ago everything has worked perfectly until today where it is still unable to boot into windows vista... I just turn it on when the windows loading bar loads then it shows a screen for 0.1 sec blue and it resets... even safe mode wouldn't start and restore mode (last known good config) couldn't help him start... I tried to use a live cd of ubuntu linux to back up my data but could not start either gave an error message stating something as abnormal.

  So where is the problem?

  Windows Boot Manager tried to find the problem and tells me this:

  status: 0xc00000e9

  Info: an unexpected i/o error has occurred.

  > so where's the problem?
  Who knows? Do you think that it of so easy to tell what's exactly wrong without running all the tests?
  Maybe it s just a software problem but a hardware problem (RAM, motherboard, etc.) can also be possible.

  If I understand your message, you want to access the data and to safeguard the necessary files
  Well, the recovery disk Toshiba would format the whole HARD disk, so you must back up the data before using the recovery disk.
  You could remove the laptop HARD drive and it could connect to another computer using an external USB HDD enclosure.
  After the backup, you can use the recovery disk to reinstall Windows.

• Windows 7 does not start the form system recovery disk

  Hi everyone, I've been strugglling for weeks with W7 on my Samsung Series5 Ultrabook.  Windows Update will not install, start slow, freezes the closure. I've tried several - clean start, check the disk, windows Diagnostics...  Have had a complete virus check done by McAfee

  Now, I decided to reinstall W7, origibal system recovery disk, but that freezes too. I changed the priorities of the BIOS, but the external CD began to turn, but it is ignored and windows starts normally (when he does...).  If I run the application recovery it windows disk, it crashes.  Winsows update for the moment blocked on KB2952664 that won't install.

  Please help... Thanks Pietro

  Try to restart you computer and press F4, it should start in recovery mode.

• Satellite A205-S4607 does not start after windows vista update

  Hello

  I was installing updates in windows vista, but the battery was low and the computer is turned off, then, at the beginning of computer doesn´t, only the hard drive led is light but the screen is black, please can you help me?

  The model is Satellite A205-S4607

  It's not so easy...

  Try to remove the battery and unplug the AC adapter, then wait 30 to 40 minutes, plug in the AC adapter and try again. Maybe the problem is resolved.

  Give me a feedback, what happened.

• VN7 791G - does not start the Windows operating system

  So I got my Acer VN7 - 791 G for 5 months now and until last month, everything was going fine until suddenly, the system has become VERY slow (operating system and programs have been suspended) and the boot process has long redicilously. To exclude a software problem, that I decided to restore the default computer via Acer recovery, hoping that would solve the problem.

  Unfortuantely it's still very slow after a successful reset and all of a sudden one day after a reboot the system decided he did not want to join the opening scene of session windows more and decided to stay on the loading screen Acer or the loading screen 'Prepare auto repair' Acer.

  I decided to leave the system to run to see if it would eventually reach the opening of windows session, but he never did and she now does is continue to stay on the Acer loading screen or gives me a black screen with the mouse pointer (nothing happens if I have nothing at this point (, or if I leave it running). Same thing happens when I try to press Alt + F10, it's just a black screen.

  As it is still under warranty, I intend to ship to the Acer Service, however I read some bad reviews before I do I wanted to see if:

  (a) someone has had the above question on their model, and
  (b) are the comments that I've read about Infoteam Acer repairs without merit?

  Thank you very much.

  Sounds like your hard drive is broken.