Satellite Pro L20 cannot see APs works on Channel 13

Similar Questions

• Satellite Pro L20 - cannot get WLAN to work

  Hello

  I have problems with my Satellite Pro L20 after a reinstallation. The wifi does not work.
  I installed the right driver, but have had no luck.
  Anyone with the same problem?

  Any help would be great

  You reinstall your laptop computer with the recovery disc or Microsoft?

  Do you have which driver installed?
  You must use the driver from the Web from Toshiba site. Check again:
  http://EU.computers.Toshiba-Europe.com-online decision-making supported Downloads & => Download drivers

  Perhaps a BIOS might also solve the problem.

• Satellite Pro L20 - cannot install Windows XP

  Hello!

  I discovered this great forum and wanted to try my luck with the following problem. Any help at all is greatly appreciated!

  I do a clean install of Windows XP on my Toshiba Satellite Pro LP20. I don't have the original Windows XP cd that came with the computer, but have you tried many (legitimate) copies of Windows XP with the same result:

  The first step of the installation works fine, IE. files are copied from the CD to the hard drive and the computer restarts once the process is complete. However, during the restart to calculate, is wrong on the second phase of the facility (where continues the installation of windows XP graphic), but goes back to the DOS file copy process. This means, even if the files have been successfully copied from the CD to the hard drive, the computer does not recognize that there is a current operating system.

  The problem is not in the boot order, like the HARD drive is my number 1 option, and tried without the installation Cd in the drive. In this case the computer says only: "no operating system found".

  Where is the problem? Is this a problem of motherboard BIOS, or do you recon that the HARD disk is somehow broken? I know that the problem is not in the XP installation CD, because it works fine on other computers.

  Thank you!

  It's not easy to say what is the problem and what are the causes of the problem.
  You can try another drive to install Microsoft?

  In my opinion, it could be a problem with the HARD drive. Then you should check this with the Drive Fitness Test.
  Google for this test, it of quite easy to use.

• Satellite Pro U300: Cannot see the HARD drive during the installation of XP

  Due to the restrictions of the network must downgrade the operating system on a new satellite Pro U300. I am unable to run the XP + sp2 cd as it says there is no hard drive installed on the machine. I guess it's because I need 3 scsi drivers or third-party raid.

  Does anyone have these or know a place where I can get my hands on them? Or am I completely off the mark that you have another solution?

  Hello

  You need the Intel Matrix Storage Management utility for the management of your local storage, including the RAID support.

  On the European driver Toshiba page I found Robson tea for Vista package which includes the Intel Matrix Storage Management utility.

  The same can be downloaded from the Intel page for the XP operating system.

  I found this on the page of Intel:
  http://Downloadcenter.Intel.com/Filter_Results.aspx?strTypes=all&ProductID=2101&OS FullName = Windows * + XP + Professional & lang = eng & strOSs = 44 & submit = Go %21

  Something similar is described here in this thread.
  http://forums.computers.Toshiba-Europe.com/forums/thread.jspa?threadID=25749

  Good luck buddy

• Restart the problem after booting on Satellite Pro L20 - approx. 4 seconds

  I have a toshiba satellite pro l20 series and it worked fine until yesterday.
  the problem is that it restarts... Well actually, he stops in about 4 seconds after the start, remains closed for 1 or 2 seconds and then again
  same problem occurs with or without the battery.
  all I see is the Toshiba logo. I can enter the bios and when in the bios it does not stop.
  When I get out of the bios, saving the changes he stops. and then begins by itsself after 2 seconds.
  Please help me... How can I fix?

  Hello

  If the laptop goes through the Toshiba logo then maybe there is just something wrong with the software.
  In this case, the first step should be again install the Toshiba Recovery CD.
  Put the CD in the drive and try to boot from the CD.
  After installation, all should work properly.
  If it's not, so I guess there is a serious problem and service guys should check the laptop.

• Cannot get wireless with my Satellite Pro L20

  My Satellite Pro L20 simply does not recognize my wireless network at home - he can't even see when I search for wireless networks. With my other non-Toshiba laptop on - there was no problem and that captures wireless 4 or 5 in my neighborhood.

  My Tosh works well when he hard plugged on the Net, but if you help get me wireless I would appreciate.

  Are you sure that your laptop is an installation of a WLan minPCI card?
  You can check this in the device under network adapters Manager

  If the wireless network adapter is listed in the device manager then you should check the compatibility of the WLan standards.
  If the wireless network adapter supports only the 802. 11 G standard and your router supports only 802.11 A or 802.11 standard B then you will not be able to connect to the WLan router.

• Satellite Pro L20-212 - USB 2.0 does not work

  Hello

  I own a * Satellite Pro L20-212 *, * Windows XP (SP2) is installed, but USB2.0 does not work *. I see nothing on USB 2.0 in the Devicemanager and the speed of the USB 2.0 devices attached is at the level of the USB 1.1.

  I don't know what information is needed to help me with this problem as it should normally work on my laptop (and I know that the laptop has USB 2.0 ports).

  What I have to install a special driver to use USB2.0 or is there any software on my laptop that I need to activate?

  Thank you very much
  Frank

  Hello

  Did you install the image on the Toshiba Recovery CD? This image contains the Windows operating system, Toshiba drivers and additional utilities. After installation, everything should work fine, and also the USB ports should work also.

  The USP ports, you can find in Device Manager in the serial BUS controller universal section. Open the tree and check if there is some yellow exclamation points.
  Then try to remove the Device Manager, the controllers and the USB hub and restart the laptop. After restarting again the OS should recognize USB controllers deleted again.

  I hope that this accelerated procedure will help you.

  Greetings

• Satellite Pro L20 USB ports no longer work

  Hello

  A little bit ago, I experienced a few problems with my Satellite Pro L20. After he brought to life, I found out that the USB ports no longer work.

  Things I've tried so far:

  Reinstall the chipset drivers
  Update the BIOS.
  Ensure USB is enabled in BIOS
  Uninstall and reinstall the USB controllers via the Device Manager.

  

  The USB ports no longer work and I ran out of things to try. Any suggestions?

  Thank you

  Hello

  If possible, try to install the operating system with recovery media. On this way, you will have to factory settings. It's the best test you can do. If the problem persists, it may be a malfunction of the equipment. Sorry but on this path is not easy to tell what the problem may be.

• Cannot charge battery on my Satellite Pro L20

  I have a satellite Pro L20 and I can't charge my battery why? Is there someone for help please?

  Hello

  Why? It is not easy to say, but it may be because of the faulty electronic power.

  Remove the battery, connect the laptop to the power adapter and switch it on. When the operating system starts, put the battery inside and let us know exactly what is happening.

  It will be interesting to know if the battery is correctly recognized and what's with battery LED.

• Satellite Pro L20: WLan cannot find the IP address

  I just bought the Satellite Pro L20
  I have the ability to go wireless, but when I try to use it is not find my ip address?

  can someone help me? : D

  thanx
  Groovyjax xxx

  You should check the settings of the router. Check if the MAC address filtering is disabled.
  In addition, to access the WLan card properties and access the properties of the TCP/IP protocol.
  There you can check if the parameters are set on the automatically

• Satellite Pro L20 - looking for a better battery

  Hello
  You just bought a Satellite Pro L20, am a little disappointed at the time of the battery, I was wondering where to find the best/most long duration batteries for it, if there is such a thing?

  See you soon

  Max

  [Edited by: admin January 21 06 10:42]

  Hello

  Well, battery working time depends on the use of the laptop. The use of the high-performance notebook reduces the battery working time.
  In addition, you should check the watch tool Toshiba. There are different modes of battery that you can use. The right mode increases battery working time.

  Good bye

• Satellite Pro L20 - no audio output device installed

  Hi, I would appreciate some help with my installation of 32 bit Vista on my Satellite Pro L20 series.

  Installation went well but my sound icon has a cross with her and when I place the mouse over it I see the message: no audio output device installed. I went in full with privilagesand Device Manager there is an exclamation following audio controller appliances. I looked at the General properties and it says: "this device is not configured correctly (code 1). I uninstalled the driver and downloaded Realtek AC97-Ref: 6285_Vista_APO_PG536 driver installed and rebooted but I still got the same error messages!

  Can someone help me? I tried uninstalling and reinstalling many times now, I don't know where to go next!

  Concerning
  Abidan

  Hello

  As a boarder, said, if you have a Conexant sound card, you should look for a Conexant audio driver.
  The Realtek driver will never work because that makes this different s.

  Check other Toshiba laptops for the same card his Conexant. Maybe you can find a Conexant Vista driver.

• Satellite Pro L20: battery not charge when the power adapter is connected

  Hello

  all advice appreciated.

  I had a Satellite Pro L20 for about 18 months. Recently, battery does not charge when the power adapter is connected. The battery light starts yellow (which means more liberated, I think?), then will both green, the machine sat for awhile. However the ACPI often said that AC is "offline."

  There are two recent occurrences that coincide with this problem, I try to eliminate:

  1. my friends rat chewed by the feeder for pets! Power is Mobile OK insofar as he fled sector - the rat seems to have simply chewed by the outer cover (I see some threads, but I think that is just a shield, although I'm not an electrician).

  2. I put the laptop in hibernation for the first time. That seemed to mess up the system a bit, which was what initially drew my attention to the problem. This question is a bit complicated because I'm under Linux (Xubuntu).

  I updated the drivers etc from windows when I bought the laptop. Never had any problems until now and have been running linux for centuries. Also, I have mainly the laptop the power supply turned off, but do not remove the battery (is that really a problem these days?)

  I obviously need to replace the adapter, but is - it is likely (and how I can check) that the battery was borked until?

  see you soon
  Chris

  First, please check if the other are lit.
  If the AC led and power led are on the adapter sector is ok and it provides the power to the laptop.

  > The battery light starts yellow (which means more liberated, I think?), then will both green, the machine sat for awhile
  If the battery LED is yellow, this means that the battery is not fully charged and if the Green led changes then recharging is caught and the battery has been recharged.

  So I really don t see any problems with the charge process.

  Maybe the battery is old and so you cannot use it for an extended in such a case only the replacement of the battery could help.

• Satellite Pro L20 - overheating of the power cable

  Hello

  For several months, I had problems with the keys suddenly works intermittently. Although brushing under the keys with a toothbrush relieved the problem for awhile it obviously was not the main cause. Each time, so not attributable to each of the keys of damaged to different keys.

  When unplugging the power cable from the metal part is very hot, and I worked on the problem of keys occurs only when the computer is running on a/c AND the battery is fully charged. In other words, no problem on the battery or recharging. The adapter is also hot, but guess that's 'normal '.

  The power cable has been tested directly from another outlet and not ongoing execution of the usual belkin surge protector, external sources seem so plotted on. I tried to find another cable/adapter to test but living very rural location of doubt this will be possible or practical.

  The fan seems to work OK, the air coming out of the side is very hot. It does not appear to be clogged with dust. Also, the area of the laptop above the fan heats up.

  Sometimes the computer crashes on black or blue screen (on iplayer lately, maybe other progs too) but the noise continues. I turned off by pressing the button for 5 seconds, but he still works for a while. I guess from overheating. But not some of it is always on a/c-do not charge, it may be on a/c-charge as well.

  Sometimes the computer seems confused if he is re-load, on a/c or battery. At least the icon switches and requires a session to unplug the device before doing things.

  Other times it is the machine of Angel since last two years! It's a Satellite Pro L20, the adapter's clover LiteOn 65W, 19V 3. 42 a. part PA3396E-1ACA (what I see is no longer available).

  Searched through but not found any similar problem, but hope someone can advise me what to do next!
  Thanks in advance

  Hello Robin

  It doesn't sound good. According to the specifications of the laptop, you have the right AC adapter. In my opinion you should contact the partner of service authorized in your country. Make a call and I hope they can help you how to handle this issue.

  It is also possible that they can send you new power adapter. Make a call and explain the situation. If you have need for addresses and phone numbers you can find under http://eu.computers.toshiba-europe.com > support & downloads > find an ASP.

  Good luck!

• Installation of Windows XP on Satellite Pro L20

  Hi all!

  My problem is with a Satellite Pro L20.

  My hard drive broke so I replaced it. Now, when I try and install windows xp pro on the new hard drive, it does nothing. First of all, I put the disk it starts to load and say to support on enter to launch xp installation, R to repair windows or F2 to exit but when I press ENTER, nothing happens if I press R, it starts to look for windows in order to repair, but no windows system cannot be found because it s not been installed but know someone or have any good suggestions on how to get windows installed.

  Any information would be most appreciated.

  I could also just add that when the computer starts first and it s on the first boot of the bit with the Toshiba logo we have 2 options F2 and F12, none of them work when I press them and also when I pressed r in the window xp installation you should be able to type exit, and then enter to leave but some type of keys and some don't but be4 just broken hard drive it typed very well no problem, if it is the problem cos I can't press on enter how fist to solve the problem of keyboard?

  Thank you once more for the reading of my problem.
  Kind regards
  Dave

  I used a panel of USB plug-and-play installation of windows this fantastic worked

  Post edited by: dave1982