HP 7310 transport jam becomes jammed traffic!

Similar Questions

• HP Officejet 7310 transport Jam

  I tried all the recommended solutions and still cannot get it printed, he tries, but then I get the error message

  Jam of transport

  Door open, clear transport jame and then press OK to continue.

  Hello

  Please check if there is no paper stuck near the transport area. If found remove it.

  Also, check if you are able to manually move the carriage.

  If the truck moves automatically / manually, then we might have to reset the printer. Therefore, check your Inbox for the steps to perform the reset.

  If the transport does not move, the printer must be repaired.

• Photosmart 2575: eprint causes transport jam

  My Photosmart 2575 printer can print the self-test and Windows, but most of the time when I use eprint to android, either phone or tablet, it loads the document and then reports the transport jam. It almost seems like eprint sends a command to the printer is not exoecting. How can I fix?

  Hello

  The HP Photosmart 2570 series is not supported by the HP ePrint software, so you may experience problems.

  You can find the following table with web solutions offered for any model of HP printer, HP ePrint is not supported for your printer:

  http://support.HP.com/RS-en/document/c03722645

  I suggest trying the HP Print Service Plugin that seems to support your printer and check differences using this solution:

  http://support.HP.com/RS-en/document/c04024231

  Kind regards

  Shlomi

• OfficeJet 4620 - stall of transport: transport Jam

  HP Officejet 4620 error: transport Jam. The print cartridge will not move...

  I get this error message, and the printer does not work.

  I watched the video of support, and there is no paper stuck or blocked anywhere, or any obstacle that I can find. I unplugged the printer, etc., as suggested. I can't always the printer to work. The carriage move not left by itself when I open the lid. I heard a noise of rattling after printing... I know that the video States if all else fails it may need service. But I was just wondering if there may be a few other simple fix, I forgot? The White Ribbon seems intact at both ends. The transport does not seem to move at all. I pull it to the left, and he stayed there after the closing and reopening of the coverage. I also removed all cartridges and reinstalled them.

  I called technical support... a new printer is shipped to me... thanks...

• Warning of Photosmart 5524 transport jam not clear paper jam

  My HP Photosmart 5524 seems to be in perfect working order but I can't move it beyond the 'Transport Jam' warning on screen.

  Have followed all the steps on the screen of the printer and the HP Web site.

  Mac OS x

  Running wireless printer.

  Thanks for any help.

  Hello @And1234 , welcome to the forums

  Check out the guide I posted below. If you have already tried all of the steps, please consider contacting HP directly to inquire about a replacement printer or a trade in option.

  A 'Transport Jam' Message displays for HP Photosmart 5520 e-all-in-one and HP Deskjet Ink Advantage 5520 e-all-in-One Printer Series

  Details of HP:
  If you call in North America, the number is 1-800-474-6836 and if you call outside the United States / Canada: click here.

  Best wishes

• HP Envy 4500 ~ transport Jam

  I just bought this printer. I'm trying to install it. I'm stuck after installing cartridges. The display shows 'transport Jam. The printer carriage cannot move... "I see no visible obstacles. I have taken the cartridges out and reinstalled several times. I unplugged and plugged the power cord several times for different durations. I'm about to make it. Help, please!

  My son came home and fixed my problem. I had to start him early, and he's got to work. Thanks for your help.

• transport jam message deskjet3052A

  receive message carriage jam, but have no jam, power light flashing.

  Here is a link that can help you with the transport jam.
  http://goo.GL/oL45u

  I hope this helps.

• My printer gives me the message 'transport jam'... open door, clear jam and press OK

  HP Officejet 6300 all-in-one

  Mac OS X Snow Leopard

  message: 'transport jam'... open door, clear jam and press OK

  Sometimes, I have to do this many times before it will work.

  Hello

  This article should cover the problem you are experiencing. Give the steps described a shot and tell us if it helps.

  Good luck!

• HP 6500 has more transport Jam

  I have a HP 6500 has more printer that has stop working.  Appears on the printer 'Transport Jam'.  I search the web and find videos that have troubleshooting steps to correct this problem, but they have not been of any help.

  When I turn on the printer, I hear a clicking sound until the "Carriage jam" message appears on the printer screen.  The print carriage is stuck on the right side of the printer and will not move.

  Any ideas?

  I'm sorry that you are having this problem with the printer. Here a link to a document from HP that addresses transportation for your model of printer jams. It will give you the troubleshooting steps that should be taken to resolve the issue you are experiencing with the printer.

  If you are still in warranty, HP can replace the printer without cost to you. I'll link the information to get in touch with them below. The link takes you to a form to fill out. Once you fill it and she is treated, it will give you the printers warranty information, a file number and the phone number to call.

  HP Technical Support call case form:
  http://goo.GL/w7Hgh

• transport jam f on Officejet 6310xi all-in-one printer

  I use an all-in-one HP Officejet 6310xi priniter.  I send the print command and when prinited sheet is delivered first four lines or are so prinitinig that half of the line and the message thenrerst prints OK.  However, after the delivery of the printed sheet I get message, "Transport jam" I received instruction of "open the door.  Clear jam and then press 'OK '.  How can I stop this from happening?  My operating system is Windows 7.

  Have you removed all paper from the input tray and shined a flashlight upwards in the status bar to ensure there is nothing caught in the rollers?  Remove the duplexer/rear access door and make sure that there is nothing in the rollers at the back.

  I would also check the printer.  The top and look down inside the right-hand side of the printer (right side of the carriage house).  Do you not see any paper into a ball in this section?

  There is also a document with steps to help fix a carriage jam in an Officejet 6310xi.  The document can be found here.  Let me know how it goes.

• 'transport jam' paperless in the officejet pro 8500 printer

  I received a fax and then "clean printhead" appeared... 15 minutes later... always cleaning... I shut it off with the power button... waited 2 minutes and then turned back on it... "jam carriage error", I check the whole printer inside out and backwards on the side... I turned it off again... unplugged it... and rekindled it... then I saw "replace ink cartridge"... the cyan and black... I took the cartridges off... put them back in and then looked at the ink level... There are still many at a time... then I get the "jam carriage error" once again... and nothing that I may change this in the window... If I click OK in the window... it says "Printing cancelled... then back to 'jam carriage error'... I think» also the transport of ink is pasted on the right side... He tried to pass it... and cannot without ripping it out of the printer... when I opened the box in the back... it was ink on the right side...

  It is 3-4 years, because I had it... and put some miles on it... I do PITCH it... just bought the 8600... still in the box... or is there hope... and of course, I just bought and put new cartridges color... lol... Thank you...

  I count on the printer immediately.  It may be just a deep reset to clear the problem.  Run through this document.  If it doesn't help you to solve the problem, then go ahead and get rid of the printer.  Let me know what happens.

• Transport jam 6520

  Hello

  I bought my wife a new printer HP 6520 for Christmas.

  I tried to put in place today, unpacked, installed the cartridges and then got the error message "clear carriage jam".

  I tried to do the hard reset and also follow the instructions in previous posts on this subject several times, and still, this has not solved the problem.

  Please can you advise of any new idea of troubleshooting I could do with this work for my University wifes work as soon as possible.

  Thank you very much

  Stu

  I managed to solve the problem. With the 4 link tracking solution, posts in cartridge parking blocking transport.
  http://support.HP.com/us-en/document/c03369132
  Thank you

• Transportation jams, always on the left side, always 3/4 this page

  Printer HP all-in-one HP Envy 110

  Jams of transport, always on the left side, always about 3/4 per page

  Hello Radians,

  I don't think that the router would be the question, unless you have more than 20' away from the printer.  This would cause a sporadic connection.  Regarding the shaking or any question relating to a question of power, the only thing I can suggest is to make sure that the printer power cable connected directly to a wall outlet and NOT a bar/power strip.

  If you still have questions, please use the contact information to get suggestions from HP Total Care.

  Thanks again for your time.

• HP photosmart c4280 issue transport jam

  Tried the hard reset as suggested, still getting the same message. "Jam, jam clear transport transport. Press OK. Any suggestions? Like new, used one summer in my truck. Cheaper to buy a new one and it crash?

  There are a few things I would do in this case.  I remove all paper from the paper tray and make sure that it is no that whatever it is taken in the rollers that would block the way of transport.  Also, look inside the printer on the right side of the cart and make sure there is nothing blocking the movement of the cart here.

  Have you tried to raise transportation and trying to move gently by hand?  Can it go all the way to the left and all the way into the printer?

  There is also a document with more troubleshooting for a jam carriage found here.

  If all the troubleshooting steps are carried out and the error continues to be present on the screen of the printer, then the next step will be the replacement of the product.  If you are still in warranty, HP can replace the printer without cost to you. I'll link the information to get in touch with them below. The link takes you to a form to fill out. Once you fill it and she is treated, it will give you the printers warranty information, a file number and the phone number to call.

  Technical Support case HP formula call: https://h10025.www1.hp.com/ewfrf/wc/phoneInput?cc=us&dlc=en&lc=en&product=5061082

• HP photosmart 309 a. transport jam

  transport in my printer will not move the error message says clear paper jam and jam from transport. There is no paper jam, and I tried all the steps listed at hp to clear the jam. nothing works, this problem occurred when I tried to copy a document. any suggestions. I can't see anything that could block the carriage doesn't move

  There are 2 documents with useful information in this case. The paper for the C309a jam paper can be found here. The document of carriage for C309a jam can be found here.

  If the steps described in these documents do not fix the issue, then the next step will be to replace the printer.