Independent black print cartridge does not print

Similar Questions

• Photosmart 7510 - black ink cartridge does not print

  Recently, I replaced the ink cartridges on my Photosmart 7510 C311A. These are all the "genuine HP cartridges ', full.

  Black ink (with the symbol of the Pentagon) does not print, not at all. I ran through the standard troubleshooting steps:

  Cleaning of printheads

  Cleaning of copper contacts

  * Check for a good evacuation

  My colleague in the corridor as the printer even so I borrowed his black ink cartridge and tried: same problem. The printer does not record that there is a problem, but when I run printing tests, where there should be a black ink, there is absolutely none. All other colors print correctly.

  The printer doesn't lack NOT of the printer "align" test however does not offer a suggestion of what to do from there. I've not seen - in test reports - an indiciation of the misalignment.
  
  Suggestions on what to do now?

  I had the same problem. I had replaced the empty cartridge black and suddenly, no ink. Finally, what has worked is
  (1) I removed all the cartridges and cleaned the copper connectors with wet Publix.
  (2) I got a wet paper towel and he pressed repeatedly on the silver circular vent that would be under the black cartridge. I did until no black came. Let it dry.
  (3) I replaced all the cartridges and on the printer. I went to tools/clean the cartridge. I did it a couple of times and he finally printed black ink! I confirmed by going to tools/align, and align the cartridges successfully. He had kept before crashes when the black ink did not work.

• HP Officejet 6500 a Plus: black ink cartridge does not print

  I have a HP Officejet 6500 a and have an operating system of Windows 10 on a Dell Inspiron 15R.  The printer does not print any black ink. I have genuine HP cartridges and the black cartridge is about 75% full. It was working properly until this morning. I downloaded your troubleshooting and everything seems fine. I ran the program cleaning head several times, but I can't always get black ink on a page. The other colors are fine. After the second head cleaning, I got a very small black image, but head cleaning has resulted in no black ink. I made sure that the wind had been reached on the cartridge and this problem occurs with wireless and hard wired connections. Time before, it happened and when I replaced the cartridge, it worked. After reading some of the messages on the map, it seems not to be the solution. I also hesitate to throw a cartridge that is only 25% used. Can you help me?

  Hello @robertj138,

• Photosmart C4280 new black HP74XL cartridge does not print

  I installed a new black cartridge HP 74XL and black ink does not print. I checked the ink level, and it shows that the cartridge is full 100%. The old cartridge printed fine until the ink ran out. I'm running on Mac OS X 10.6.8 operating system.

  Anyone has an idea on how to solve this problem?

  Yes try just remove all the cartridges the printer "lit" > and then pull on the power cord directly from the back of your printer with it > wait 30 seconds > reconnect your printer and wait that it will ask for you to install cartridges.

  This should force to align

• A black HP364XL cartridge does not fit my printer Deskjet 3070, even if you advertise it - why?

  I bought a black HP364XL cartridge for my printer 3070, but it is not well announce it as it should be - why is - this?

  Hi people, just to let you know there are different sizes of 364xl black print cartridge...

  More details HERE

  Figure 1: Example of the Black XL cartridge update installation with space on both sides

• 3520 Deskject HP all-in-one: newly replaced black ink cartridge does not print

  My ink level is full.  I just replaced my black cartridge (with genuine HP cartridges). No black is printing.  I tried all the troubleshooting tips including the alignment of the printer, clean the print head. Remove and reinsert the cartridges.  I replaced the cartridge several times during the past year is nothing new.  Can't understand why black will not only be printed.

  This is your last hope.

  https://www.YouTube.com/results?search_query=DeskJet+3520+cartridge+cleaning

  Watch the videos and if you can remove the printhead and clean, it might work.

  Let us know...

• Black ink cartridge does not print. tried all of the suggested remedies nothing works!

  What is value?

  The problem solved itself suddenly. Black works now! I don't know what he cured I have applied a single repair by turning off it and back on and at the time that doesn't seem to work. It took until a few days later, when I decided to try another printer that I found that it worked. Thanks to all who have tried to solve my problem!

• BLACK ink cartridge does not come back up after changing the cartridge.

  I replaced the cartridge a few days ago and it was printing fine, but today, I tried to print something

  and it was like all other lines... lines, it wasn't like there was just a spot of ink on the

  paper anywhere in the line.  After detach the cartrdige, can't do it back up again in the printer.

  What could be wrong?

  Hello.

  It would be useful to know what model of printer you have.

  See you soon.

• Re: Black ink cartridge does not work

  I'm having the same problem.  New cartridge.  I bought a pack of three for $59.00.  I think to install a new one and return to the rest of the three Pack if one is defective.  Don't know what else to do.

  Hello Traceey,

  Please perform the below mentioned steps, which should solve the problem.

  1. Check the level of ink on the ink cartridges, it should be full of > 25%.
  2. Press on the SETUP ( button tool key icon), and then
  3. Press TOOLS , and then select CLEAN PRINTHEAD.

  You may be able to execute the above mentioned as follows at least for 2 - 3 times.

  If the problem persists, call the HP TECHNICAL SUPPORT for assistance.

  If you are in the United States, the toll free # is 1-800-474-6836.
  
  If you're not in the United States, and then connect to www.hp.com , bottom left it is an icon of the world map, click it and then select the region that you belong to, which would then provide the support options for you for this region.

  Kind regards
  Jabzi
  
  Help the community by marking this post.
  Your question has been answered? Mark it as a accepted Solution!
  See a great post? Give it a Bravo!
  I work for HP

• Always printing black ink cartridge is not after several clean using your own ink cartridges

  I have a HP Deskjet 3050 All in One J610 series printer.

  I use Windows XP.

  I'm a Newbie as HP printers are concerned, but some have experience troubleshooting former HP model a parent.

  The black cartridge is not printing.   For various reasons, I have not used the printer for about two months.  So far, the printer worked fine, and in fact it is still using the cartridges that came with the printer.  I mention these points here because I realize or the other or both can be part of the issue.

  When I sent a document to the printer, printing was uneven.  I checked ink levels and black and color cartridges were about the third two full (before I used the print head cleaning utility.

  After cleaning the printheads, I tried again and this time the impression was the same, but in a shade of light blue, which was very low.  However, the original document is in a police man and a shade of gray, so perhaps he used ink cartridge color and not black?

  Research using the viewer help from HP does not help because it implies that you don't know how to locate the ink cartridge Clean Utility.

  After searching on Google to match the questions, I tried a second and then a third level of cleaning.  And because a post mentioned have to do eight times, I did a little more luck.  When the page is printed at the end of the cleaning cycle, the colors come out crisp and even.  There is no black bloc... is there?  I can't find an image showing a what print perfect following cleaning should look like.

  Additional to clean using the utility attempts do not seem to have worked and could even have been counterproductive because when I tried to print another document, and this came out so pale that I first thought that it is a blank page.

  I used the utility to re-estimated ink levels and the color is always about two third full, while black has dropped a little down, but is still above half full.  There is a check/tick showing for black ink and color.

  Messages on similar questions suggest that the replacement of the cartridge does not solve the problem and that heads should be cleaned manually.

  Should I try to clean the heads manually?  Who was mentioned on the threads and even on the HP support but as another option for a very different model.   I watched some demos on You Tube, but they are for different models of HP, in which they remove the printheads and clean them in a solution provided in the trade which I think is available in the United Kingdom, or with water!

  I would be grateful for any advice as to whether I should remove the black cartridge and clean heads printing and, if so, if someone could point me to a link where this is illustrated step by step, video, or shown in the logical steps.

  In the meantime I'll go off and buy a new black cartridge, but if it's the heads need cleaning, I'll have to do anyway.

  Thanks for any advice you can give me!

  I would like to manually clean the contacts on the cartridges and the printer. The process is described for your model of printer in step 3 of this document here.  The rest of the document does not apply to your question, but it does a great job giving instructions step by step on the manual cleanup process and materials needed to use lists. Manual cleaning will help ensure that the accumulation of contacts is not the cause of the issue of the print quality that you are experiencing. I hope this helps.

• OfficeJet Pro K850 - ink cartridge does not print

  My K850 printer is not printing cyan. According to the Toolbox of the K850, cartridge series cyan was 75%, and the health of the print head has been fair. The cyan cartridge was beyond its expiration date I replaced it. The new cartridge does not better than the old cartridge print. Before I spend another $40.00 + did someone has something to suggest?

  Although the cleaning of the print head has helped a little, it did not help, so I bought a new cyan print head. When I installed the new print head, the printer automatically aligned to the printhead and now cyan works very well. Unfortunately, the alignment process pointed out flaws in magenta and Yellow Printhead. Now everytime that I print anything the printer goes through a continuous systematic alignment printhead to try to correct the magenta and Yellow Printhead, waste of paper and ink, until I cancel all print jobs. New cleaning of the printheads and the contacts did not help. In the end, no matter what is the status of print head in the tool box, replacing the print heads is the only solution that worked.

• HP 640 c: HP640c cartridge does not return to its original position and the printer will be no print anything

  Printer cartridge does not return to its original position on the right side of the printer after the top cover is opened, with the resume light continues to Flash.

  After restarting the printer, the cartridge moves to the right, but not all the way and remained there when the printer is off.

  The printer will not print anything.

  How can I get the cartridge is positioned correctly?

  Solved the problem... it's a defective color print cartridge, which was the carrage Act strangely.

• "Black ink cartridge is not compatible with this printer" message - 56 HP deskjet 5552

  I just replaced my HP 56 cartridge in my old printer HP Deskjet 5552 - I use an iMac & when I try to print, I get the message error "black ink cartridge is not compatible with this printer.

  It makes no sense that I replaced the cartridge many times before without ever having a problem.

  I have already returned a cartridge to the store where it was a problem with the cartridge itself, but the same thing happened with a second.

  Any suggestions gratefully received.

  Thanx, Alison

  Hello

  It usually take a few cleanings to operate.

  Best regards

  ERICO

• When I start my computer I saw a MSI logo and then the screen goes black and Windows does not load.

  original title: HELP ME PLEASE!

  (I am running windows xp) I need help! I tried installin linux ubuntu for netbook 10 on my msi u100, but everything was wrong when my little brother from my FlashDrive from the port, it has been installin linux from. so now when I turn on my computer it will not load windows, it will just have the msi logo and then the screen goes black and it does not load windows xp.

  Netbooks and also most computers these days, do not come with an installation CD. Instead, it has a recovery partition. Assuming that you have not deleted the recovery partition,

  Take a look at this:

  http://randompastime.blogspot.com/2010/02/restoring-MSI-wind-U100-NetBook-to.html

  Hope this helps

  Post back if necessary

  __________________________________________________________

  If this post can help solve your problem, please click the 'bookmark' or 'Yes' to this message button. Marking a post as answer, or relatively useful, you help others find the answer more quickly.

• Black cartridge does not print.

  Model HP6510.  Black cartridge will not print computer or copy.    A new cartridge has been installed, but it prints just blank or a very light blue.  Yes, it is installed correctly.  The other three colors work very well.  Any help?

  Hello westielover,

  Welcome to the Forums of HP Support! I see that you recently replaced the black cartridge and you get blank pages or a very pale blue text. To better help you can you please let me know the Exact modelof HP printer that you are using?

  Please start here: printer does not print black ink or color of ink or prints blank Pages

  Let me know the results if you always work in printing questions reply back.

  Thank you

• Want to 120 black cartridge does not print

  My black ink will not print. I aligned cartridges. Tried a new cartridge HP ink, cleaned cartridges, printer turned on and outside and he do not always print and when I print a page of quality diagnostic, the black ink column is completely empty. Help, please!

  I tried to unplug and reset for 2 minutes and it does not work but I turn off the morning at night and then it worked.