Laptop stops when the power cord is not plugged in but the battery is charged to 100%.

Similar Questions

• HP Pavillion DV5020 that blanks out when the power cord is not plugged in.

  I have a HP Pavillion DV5020 that white outside when the power cord is not plugged in.  Then, when it is in it's very well and when he's not even starts not with the screen committed.  It is NOT the function sreensaver.  Can I plug an external monitor and see what happens, but the maternal lines white leaves display off whenever it is on battery power.

  Anyone seen this before?

  g

  I would recommend to go ahead and reset the computer of hard edge. This is one of the best steps for these types of troubleshooting questions. Here is a link that will guide you through the steps on how to perform a hard reset: http://goo.gl/6mk6K

  I would like to know how it works and post back with all new details.

  Thank you!
  Sean

• My computer is no longer warn me entry stop when the battery reaches the critical level.

  My computer is no longer warn me entry stop when the battery reaches the critical level. Officially, it shows a warning sign and told me to shot or recharge the battery when it gets to level criticism, but now he can't, but stop just when the battery has reached its critical level. No warning sign more.
  What should I do to get the warning before the pc turns off when the battery is at its critical level.
  My pc is hp laptop mini 110-3100. Start Windows 7.

  Hi Sage180,

  ·         Did you change in the computer before the show?

  Follow these methods.

  Method 1: Run the Troubleshooter of power.

  Method 2: Follow the steps in the article.

  Solutions to common battery problems

  Battery meter: frequently asked questions

  For reference: take care of your laptop battery

• BlackBerry BB Z10 Z10 stops when the battery indicator shows about 35%

  Z10 BB stops when the battery indicator shows about 35 percent without any warning. Does not illuminate until the charger is plugged. Immediately shows charge remaining 40% +.

  Please advice.

  Stephen

  Hello

  Here is a solution I tried after lookng through various forums and type of works for me. A common thing in most of the solutions is to take the battery and sim card out, leave like this for 1-2 hours and put them, I found back in and turn it on. I'm not sure of the logic behind it, but I remember reading that this overshadow the phone battery problems (connected incorrectly - essentially a reset) and begins to charge.

  I tried it 2 days back and I see that it worked for me, at least until now. I cross my fingers.

  I hope it's useful, works at least for few of you.

  Thank you all for the suggestions.

• When I unplug my laptop - even if the battery is charged - it turns off immediately

  I have a laptop HP pavilion with windows vista.  The fine battery charges but when I have a connect the power to the computer will stop immediately.  What can I do?

  Hello CorySchneider,

  In addition to commentary of Veritas Aequitas, I suggest trying a diagnostic test, assuming that HP has one installed.  Who would check usually software and hardware.  Including battery, to see if it is bad.  Have you ever replaced the battery before?

  Fix the battery issues:

  http://Windows.Microsoft.com/en-us/Windows-Vista/troubleshoot-battery-problems

• Tecra A7: When the battery starts charging?

  Under what title did the Tecra A7 specifications battery start charging itself (when on a domain controller)?

  Hello

  In my knowledge ff as the AC adapter is plugged in the battery will be charged all the time.
  There is no level battery charge or does not charge.

• How do I know when the MacBook is charged

  Show the retina MacBook battery 12 "will load if you lift the screen while the MacBook is power off and load?

  Cargo stops when the battery is charged to 100%.

• Tecra R10 - 10W - charge when the battery fully

  Hello

  I have this laptop for a few weeks and his strange behavior. Lets say I use this connected to AC and the battery is charged to 100%. When I disconnect from AC from one day to the next and connect it again in the morning, he begins to charge the battery, even if it is charged to 100%. It charges the battery for 5-10 minutes.
  Does anyone have a similar experience?

  Other portable wait until the battery level reaches about 95% before loading. Is there a way I can influence this behavior? I guess that this short of frequent charges is not good for the duration of battery life.

  Thanks for your opinions.

  Hello

  > Lets say I use this connected to AC and the battery is charged to 100%. When I disconnect from AC from one day to the next and connect it again in the morning, he begins to charge the battery, even if it is charged to 100%. It charges the battery for 5-10 minutes.

  As Akuma has suggested, it's a normal question.
  Nothing unusual, because the battery loses power even the laptop is turned off.

  Here is one of the Toshiba articles:
  + Why my laptop loses 2 to 4% of its energy from the battery whenever I turned the unit off and turn it back on? +
  http://APS2.toshiba-tro.de/KB0/FAQ6301EP000ER01.htm

• Satellite Pro L500 - stops when the power cord removed

  Toshiba Satellite Pro L500 stops when the power cord is removed even with the battery to 100%. I removed the battery and all the indications associated with battery answer correctly. For example turns off, Toshiba Health Monitor also indicates when the battery is removed. If installed Health monitor indicates that the battery is at 100%.

  Someone please help. I have not installed anything new.

  Hey,.

  For me, the matter is clear: the battery can't hold a charge so the laptop will be shut down because it has no power.

  I think you need to replace the battery with a new one and you can get a provider of service authorized in your country. Simply contact the guy and ask that they can tell you how much it would cost.

  You can find a list of all FSA here:
  http://EU.computers.Toshiba-Europe.com > support & downloads > find an authorized service provider

  Good luck! :)

• computer Vista laptop does not stop when the lid is closed

  I have all the correct power settings. mode when the lid is closed, I tried setting Hibernate and sleep. It just keeps running and running, I'm afraid it will overheat. but it should stop when the lid is closed, correct? Thank you sissy

  Hello banditpunpun2,

  Thanks for the return of the response.  I also go to your manufactures website and confirm you are updated with the lates drivers, updates the firmware and BIOS.  I even watch the forums on the manufacturer's Web site to see if others have experinced the same question.

  Please let us know status.

• Satellite A300 stops when the power adapter cable

  Hi people

  When I connect the power cable for my toshiba satellite a300, it stops immediately. I can use it on battery normally without any problems.
  When I boot in safe mode, it works fine without any problems with the AC adapter plugged into the laptop.
  Operating system is Windows Vista
  What is the reason? What can I do to fix this?

  Thank you

  Can you use it for laptop with AC power only when the battery is removed?
  If so, boot up your laptop and when the operating system is loaded to put battery inside, wait a few minutes and disconnect the power supply.
  Plug it in again and let us know if the same thing will happen again.

• Satellite Pro L10: CMOS clock stops when the OS is not running

  Hello

  We know a reason why the cmos clock would stop when the operating system does not (phone off), the laptop is 18 months old, I've updated the bios tries to give him a good boost, but no effect, he was also in charge for 24 hours.
  Any advice would be great.

  See you soon
  Paul

  Hello

  Usually if the BIOS date/time is wrong and always changes, the RTC battery which is mounted on the motherboard fails.
  In this case the CMOS battery needs to be changed or maybe only removed for awhile

  If your laptop is 18 months, the guarantee must be valid.
  Generally if you have registered on the page of Toshiba notebook the warranty covers all repairs for about 2 years (24 months).

  In this case, I would recommend contacting ASP in your country, because the technician must be able to solve this problem very easily.

  Good bye

• While the loop does not stop when the two values are equal using equal to comparitor

  Hello world

  I have a really, really strange bug. I have a LabVIEW VI that change a chain on a power supply. I have a start and a stop voltage and use a while loop to increment the device. For example if I want to scan from 1, 2V to 2.2 V in 0.2 V incremements, the program will end when "The current tension" = "stop the tension." And it works very well!

  However, when I start - 3 V and want to stop to say-0.8 (new in 0.2 V incremements) the program does not stop when "The current tension" = "stop the tension." I checked with the probe close to what should be the end of the race and - 0.8 V goes both of the entries ' equal to ' comaprison operator, but that his can't trigger a real result.

  It's very strange for me. Espeically as if I'm going - 0.8 V to-2 V but decrement of-0.2 V, the program stops correctly!

  I am very confused!

  See you soon!

  Search on: comparison of floating-point numbers

  The second thread is particularly relevant. This discussion was 2009, but you can find that the same "bug" being reported to enter the end of the 1980s.

  Mike...

• laptop stops when I enter the user name.

  OT: Laptop * low randomley.

  laptop stops when I put a name

  My all started when I did a search people

  Hello

  You do not give us a lot of information to work with.

  What name?

  What looking for people?

  We need more information.

  It may be an overheating problem and it is normally the main reason for your problem.

  .

  If it's a hardware problem, it would not not to restart.

  That said, it is possible to have a hairline cracks in the motherboard, etc, which becomes obvious as soon as it warms up

  Check vents for hair, dust, etc. and do not use a laptop when it is based on material surfaces: bedspreads, blankets, etc.

  If the problem persists, because it of a laptop, bring it to a local computer and reliable repair shop and get them to open and clean the dust inside...

  Here is an interesting discussion about the reasons for your problem:

  http://PC-trickandsolution.blogspot.com.au/2011/07/fix-laptop-overheating-shutdown-problem.html

  NB: > however 9 out of 10 cases of overheating are caused by obstruction of the air flow.

  See you soon.

• Power HP Pavilion g7-1310us ca not detected when the battery is installed.

  OS: Windows 7 64-bit Ultimate.

  When AC and battery power available, the laptop wants to run on battery. Test the battery with AC plugged ends upward with a message similar to "the battery is OK, but the test did not complete because AC is not plugged.

  When the battery is removed, the laptop works fine on AC.

  Unplugged AC and battery, power button that is held for a minute, reconnected battery and HQ - the problem persists. Tried removing / reinstalling compatible Microsoft ACPI control method battery driver - did not help either.

  The laptop runs all the BIOS the most recent and the software updates that have been available through HP software support support.

  Center of Service HP solved the problem by replacing the AC adapter