MONITOR HP PROBLEM, I have HP TouchSmart 600 PC & after closure, monitor has rows colored @ bottom of page

Similar Questions

• TouchSmart 600-1040nl

  I have this Touchsmart 600-1040.

  He got very dusty over time.

  I have many would like to do is open the case to own fans and carefully the cooling fins.

  So, how can I open the case?

  Thank you.

  Wim Kreuger

  There is a video in this document from HP web that shows how to open the rear part of the housing. Once you have done this, you will be able to access inside your PC.

• TouchSmart 600-1055-Message of disk error hard hd521-2w

  I have a Touchsmart 600-1055 is our guarantee. I am running Windows 7 (64-bit). I have hard to start when the computer hangs at the Windows screen. I was able to carry out repairs and after many attempts it finally began. I ran the test of the system and the only test that failed was for my Smart hard drive test and gave the code of hd521-2w. I guess that means that the HD is about to go. Am I wrong? And if yes, what is the replacement and can I upgrade to 2 TB and when and where can I find instructions on how t it? Thank you!

  Hello:

  Yes you are right. The hard drive has virtually disappeared.  Back up your files.

  I would go no larger than a 1 TB HARD drive.  2 TB might work, but it might not.

  SATA II 7 200 RPM desktop drive, that's what you need to replace with.

  Here is the link to the guide of upgrade and maintenance.

  http://h10032.www1.HP.com/CTG/manual/c01895538.PDF

  You will also need a set of discs of recovery to reinstall the operating system and the programs that came with thePC.

  Paul

• I have a Hp touchsmart 600-1050 and I also have 3 other laptops running of the internet itself, but I get a message IP address conflict.

  I have a Hp touchsmart 600-1050 and I also have 3 other laptops running of the internet itself, but I get a message IP address conflict, why? & How can I fix this problem, thanks Aldo Zapata

  An IP address conflict occurs when two computers on a LAN (local area network) or the Internet were assigned to the same IP. IP conflicts between two computers normally make one or unusable both for network operations.

  Try below methods

  1. for networks where the addresses are fixed (statically assigned) IP, ensure that each local host is configured with a unique IP address.

  2. If your computer has an address assigned dynamically, releasing and renew its IP address can bypass IP address conflicts.

  Run the following commands in the command prompt:

  ipconfig/release

  ipconfig / renew

• I have a problem, I exit 3500 x 600 25 fps targa moive inAEcs4, mixing his PR CS4, why moive is 29.97?

  I have a problem, I exit 3500 x 600 25 fps targa moive in ae cs4, mixing his PR CS4, why moive change to 29.97 6.40 min?

  BUT mix in cs3, the DISPLAY IS just PR... 3500 x 600 25 fps targa moive... WHY... IS THIS BUG PR CS4?

  Unfortunately, you have posted on the forum for the creation. This is for the precursor to the PrPro, which has its own forum. I'm sure that Jeff or Curt happen during this forum.

  Now, there are two places that would have put the FPS. The first will be in the predefined sequence. If we choose a desktop Preset, then they can change almost all parameters. What is the FPS of your sequence?

  Then, when exports to many formats, we can also define the FPS. What was chosen in your case.

  Good luck

  Hunt

  PS - what type of view will take care of 3500 x 600 material? Just curious.

• HP TouchSmart 600-1265qd does not connect to Samsung LED 55 '' TV via HDMI

  HP TouchSmart 600-1265qd does not connect to Samsung LED 55 '' TV via HDMI. I have connected the same cable to your laptop and it connects, suggesting that there is a problem with the CV. The TouchSmart has a GeForce GT230 graphics controlled by the control panel NVIDIAnView. By using the system control panel and the control panel NVIDIAnView, I have not been able to locate the Samsung monitor.

  I made restarts it etc. also without success. Does anyone have a suggestion that I could follow.

  Hello

  It is a machine CTO, but have many models of the Touchsmart 600 HIMI IN port series, not OUT port so you can't connect to a TV using HDMI in order to get the picture on the TV.

  

  Kind regards.

• 600-1050 HP Touchsmart All in: upgrading ram touchsmart 600

  I bought a

  Memory RAM-DDR3-1333 8 GB [2x4gb] Upgrade Kit for

  to upgrade my HP Touchsmart 600-1050 all-in-one.

  However, he had not worked and shows only a black screen after the installation.

  The discription is

  Memory 4GB DDR3 - 1333 PC3 - 10600 Non - ECC Unbuffered 204 pin 1.5V = 9 CL

  Then after, I bought another

  8GB (4GBx2) DDR3 1600 MT/s Kit (PC3 - 12800) CL11 SODIMM Notebook Memory Modules CT2KIT51264BF160B / CT2CP51264BF160B to amaozn.com

  It has the same problem.

  Those who are not compitable with my computer?

  If so, let me know a compitable memory set for upgrade.

  Yes, that would be true, but that model is an all-in-one computer, it is not flexible for the replacement of the Board of Directors, as a regular desktop would be. You probably only have the option of a Board.

• My desktop HP Touchsmart 600 computer: My HP Touchsmart 600

  Desktop HP Touchsmart 600 has a about 5 inches square dead spot on the top left corner of the screen.  Is this a problem that can be easily repaired?  If so, can it be repaired locally?

  Thank you...

  Bruce

  @ButchBob, welcome to the forum.

  If your computer is no longer under warranty, I suggest you find a computer repair shop known locally to see what they have to say.  It shouldn't be too difficult for them to fix it.

  Please click on the button + Thumbs up if I helped you and click on accept as Solution If your problem is resolved.

• HP TouchSmart 600: External Toshiba USB 3.0 drive not recognized on HP Touchsmart

  I have a desktop HP Touchsmart 600, and I bought a 1 to Toshiba external USB 3.0 drive and when it plug to the USB port, it does not, even tried the other port and restarted, but does not yet recognize, I tried to reload the USB Chipset, but no cigar. I am able to use it on my Sony laptop. I would be grateful for any help or suggestion. Thank you people.

  Hi @StevieB1,
  
  Welcome to the Forums of HP Support! It's a good place to find the help you need, other users, HP experts and other support staff. I understand that you have a problem with the external drive not being seen. I'll be happy to help you.

  Please, try the steps in Troubleshooting connections USB (Windows 7).

  I hope this helps. Please keep me informed of the progress of things.

  If you need help, let me know and I will gladly make all that I can to help you.

  Please let me know if that solves the problem by marking this post as "accept as a Solution.
  To simply say thank you, click the Thumbs up below!

  Thank you.

• HP TouchSmart 600 - 1070 has blocking of overheating?

  I am repairing a Touchsmart 600-1070a who suffered a fall from his office (damaged the on/off switch, but that is fixed), already replaced the HARD drive that had bad sectors.  There seems to be a lot of cumulative small hiccups, including;
  
  * sometimes not even bring to the top of the screen on powerup, remains black despite the fans running, power light.
  
  I suspect that it is a matter of gfx module or connector problem, as I loosened and forced the GFX module in its unlocked connector and reinstall the graph LVDS lead and - apparently - to have solved the problem for now.
  
  * for execution, will crash intermittently Win7 and how the region of radiator for chipset is exceptionally hot (about 50' C) and it is with the metal plate still attached.
   
  To do this, I don't know what approach to take.  There is a spacer between the heat sink for this chipset and the metal casing that is filled by a heat-carrier pad.  My suspicion is that the pressure of the arriere-stand against the metal actually requires chassis-pad-heatsink to stick, but I think now that the cushion is probably due to replace or another option sorted as things are just not too hot
  
  Someone else had a similar problem?
  
  The GPU and CPU radiators have all been cleaned with compressed air / brush and work correctly.
  
  (photo showing the motherboard exposed without the metal support pregnant.  The radiator in question is orange, one located in the center of the motherboard near the memory.
  
  

  I placed a layer of transfer thermal padding that is normally used between transistors/MOSFETS and sinks of heat, about 1 mm thick, on top of the orange radiator - seems to have now settled the system down, played a video DVD and YouTube full length at the same time without crashing.
  
  So now, we have chip|heatsink|transfer-padding|pale-transfer-thick-padding|metal-backing.
  
  Active cooling a bit more would have been nice in the form of a fan from somewhere, but as long as it doesn't crash, I guess.   Metal case houses approximately 49' C around the location of the radiator.

• TouchSmart 600: touchsmart 600 x 64 wireless network card

  Ralink 802.11 Wireless Lan Card on my PC seems defective.  Wireless internet began to drop out of school for weeks, then finally wouldn't connect to the internet.  This is the latest driver to June 2014.  My computer laptop HP, 2 tablets and 2 smart phones have no connection problems, so this isn't my wireless network.  The PC is unable to connect to DHCP and manually configure IP addresses.  Diagnosis point always restart the modem (not on the PC).

  The wireless network card is replaceable?

  If so, are their any instructions on how to replace and where the card (or a compatible card) can be purchased?

  Hello again @tmburson,

  Thanks for the information on your product. According to the page of HP TouchSmart 600-1000 t desktop PC product specifications and configurable Options , your computer has a wireless card "802.11 b/g/n PCI Express half-Mini Card + Bluetooth wireless". As long as you get the same type of card you'll be fine. I provide you with instructions on how to change it below:

  Removal of the Mini PCI Wireless LAN card
        
  To remove the WLAN Mini card, first remove

  • the hard drive and memory cover
  • the stand
  • the cover of the e/s
  • the feet
  • the back cover
  • the shield of the amp Board

  
      
  Remove the shield from the motherboard.

  
      
  Carefully remove the connectors of two antenna to the card.

  
      
  Remove the two small screws of the Mini PCI card in place.
   
  
   
  Point the card upward and remove the card.

  
      
  Replacing the Mini PCI Wireless LAN card

  To replace the Mini PCI card, orient the card in the slot at a 45 degree angle and press down.

     
   
  Keep it pressed all by replacing the first of the two screws.

  
   
  Reattach the connectors of two antenna to the card.

  

  Reconnect the:

  • the shield of the motherboard
  • the hard drive and memory cover
  • the stand
  • the cover of the e/s
  • the feet
  • the back cover
  • the shield of the amp Board

  I hope this helps. Thanks for posting on the HP Forums. Have a great day!

• Opening of loop control HP TouchSmart 600 password

  I think that we can guarantee the HP TouchSmart 600 using the 'lock' feature when the computer is current in the standby state. If the power is off, then the computer restarts all right on the desktop without the password screen. What is a feature of Windows 7 or a problem of HP TouchSmart 600? I prefer the old Windows XP/Vista feature that does not allow access to the computer without password any that she has been waking up from sleep or from zero power state. Does anyone know how to fix the problem please?

  Is not a 'problem' or a loophole, it is a parameter, you have the camera do not ask for a password at startup, intentionally or not.

  You can change this with netplwiz.exe.

  Diane

• TouchSmart 600-1120 graphics card

  I bought the nVidia GeForce GT 230 M DDR3 1 GB MXM VGA card and installed.
  I have an HP Touchsmart 600-1120 all-in-one PC and there a processor intel on board the grap. card. But a top model of this comp. has nvidia gt230m so I installed it on the mxm slot. It took a lot of time, it was difficult to open the case...
  Now, when I press the Start button, sometimes a blue screen, then color screen scratched, then 2 times beep beep sound and the computer shuts itself.
  What can be the problem?
  Thank you very much...

  OK thanks dianebrat

  God bless HP...

• Win 8 on Touchsmart 600-1055?

  My Touchsmart 600-1055 (exactly 3 years from dec / 2013) has experienced a hard drive failure. I bought a new hard drive but have no restore disc and HP don't use them more for this model.

  So: Did anyone see a problem with the installation of Windows 8 on this old system? I understand that it may not work because of drivers... but that's it or throw the PC, which is always a great PC for some uses.

  I appreciate the answers.

  Hello

  Windows 7 is still the best at this stage, but if you want to switch to Windows 8, it's your choice and you will need to find one or two drivers for your computer. A lot of friends in this forum will help you.

  Kind regards.

• HP TouchSmart 600: HP TouchSmart 600 does not power on and flashing lights

  Hello

  Need your expert help! My HP TouchSmart 600 won't turn on. The lighting at the bottom of the screen will flash green. It worked fine the day before. Is it the motherboard? Or a power supply problem?

  Hi @YUL_TechWriter,

  You can go surf part HP

  On the right, select the country

  In the quick search, enter the serial number and it came with the part for this computer list.