Portege Z930-12J - WiDi updated to version 3.5 and greater

Similar Questions

• I'm using Firefox Portable and lack the 'Extra' _Menue been updated to Version 11. And "No, I can not add with the toolbar customization."

  I am using Firefox Portable and lack the menu "Extra"since updated to Version 11. And "No, I can not add with the toolbar customization."

  What is this extra menu?

  In some languages of the menu Tools is called Extra, so you can watch in this menu to see if you can find what you are looking for.

• Update trial version, but got and even that will not open because my email associated with the account configuration has changed, so I can't get into it at all. Adobe said that I can't change my email that I have to close my account and start a new. any w

  Update trial version, but got and even that will not open because my email associated with the account configuration has changed, so I can't get into it at all. Adobe said that I can't change my email that I have to close my account and start a new. any way around this? sounds to me ridiculous

  Contacted Adobe Support and they recommended to configure the new Adobe ID?

• Portege Z930 - 12 H - update of the BIOS and McAfee Endpoint Encryption?

  The update to the latest BIOS (Ver.6.70) for my laptop Portege Z930 12 H comes with the warning:

  «If you use the BitLocker Windows Drive encryption, please temporarily suspend (or turn off) before BitLocker Drive Encryption updated BIOS.»

  The same caveat applies to McAfee Endpoint Encryption, which is used on my laptop and I can * not * pause or stop? Or can I apply the upgrade of the BIOS safely?

  Thank you.

  As much I know Bitlocker isn't related to Antivirus from McAfee software and two security tools are not connected to each other. BitLocker is a tool for Microsoft Windows and McAfee is a 3rd party software preinstallation on the device.

  I found a nice how doc on the update of the BIOS.

  [How to upgrade the BIOS on Toshiba laptops | http://aps2.toshiba-tro.de/kb0/HTD9502M10000R01.htm]

• After downloading Firefox version 26.0, I still get web messages encouraging me to update to version 25.0 and window pop up - why?

  After downloading Firefox 26.0, I keep getting guests to update to Firefox 25.0. In addition, I am continually interrupted with ads and unsolicited Web pages popping up. Can you help me?

  Hello, you can have malicious software on your computer. Please, try the following steps:

  1. Reset firefox (this will keep your bookmarks and passwords)
  2. then go to firefox > addons > extensions and where there are still extensions listed there, disable them.
  3. Finally, run a full scan of your system with security tools like the free version of malwarebytes and adwcleaner to ensure that adware is not present in other parts of your system as well.

  Fix Firefox problems caused by malicious software

• Portege Z930 - 14L - DC orange led blinks 8 times and green ECO light led

  Portege Z930 - 14L. I can't boot from the last power since.
  The domain controller in the orange Led blinks 8 times and eco green light led is lit.

  DC IN flashing ornage indicator indicates a problem with the power supply. Initially, you should try plug the adapter HAVE an another power outlet. If she does still not work, you should contact Toshiba ASP (authorized service provider)

  Electronic supply on the motherboard is probably the problem.

• I've updated to version 5 (twice) and he continues to revert to the old version.

  This is the second time that I found that Firefox 5 returned to version 3.6.18. I also caused problems when I stopped at the end of a session - it seems to crash - but do not know if this has something to do with the firefox program.

  Uninstalling Firefox. Search Firefox in your drive Windows (C:\) and DELETE all Firefox files found in the search.

  -> Start RUN in the Start Menu-> type regedit and press enter-> on the left sidebar, double-click on my computer-> five files appears.

  Right click on each folder-> select "search...". '-> Type Firefox and place check on all the options provided-> in the left sidebar a Firefox folder will be visible-> DELETE folder Firefox-> back to the top

  Repeat this process on all the five main files opened from workstation until you can't find not all Firefox files in the Registry Editor window.

  Now, restart your computer and re - download Firefox http://www.mozilla.com/en-US/firefox/fx/

  Check and tell if its working.

• You guys just automatically updated my version of Firefox, and I can restart is no longer with disabled addons! I need to do. Either tell me how to do with this new

  I need to reboot with disabled addons because that otherwise my screen replaces text colors and
  Funky fonts when I scroll up and down on the pages of the web site.

  I solved the problem of finding ways to appear no more
  indicated by the default menu bar.

• Re: Sore eyes using Portege Z930 screen

  Hi all

  After appr. 30 min of work with my Portege Z930 I get the pain in my eyes and, later, headache.
  I can't just work properly with him.

  I tried all known by me options to configure the graphic display, Intel utilities and a Windows, change text size and so on, but to no avail.
  Text is a little fuzzy looking.

  I'm 12 years old laptop user, changed a lot of it and it's my first laptop with such a poor quality screen.
  Or is it a default and I should ask replace the matrix?

  Appreciate all the advice of many,
  Sergey

  Hello

  The device supports a common 13.3 "(HD) TFT color LCD."
  The max resolution is 1366 x 768.

  So I can't find big differences between this screen and others, used in other books

  Of course 13.3 is not really a big screen I prefer notebook with a screen size of 15-17.
  The 13.3 is too small for me

  I don't know... maybe there is something wrong with the LCD display... then maybe you should ask a service provider to verify the part... but this is just my personal opinion...

• Portege Z930: The update of the BIOS with LINUX/UNIX OS

  Hello.

  I manage a COMPUTER company, and some of our facilities are portege z930.

  We use Linux as main OS, and in order to use all the disk space, we erased the Windows partition.

  How can I update the BIOS of a Linux operating system? I asked a support company official technichal, and they told me that they use a special live linux CD managed by Toshiba.

  I don't know if I can get this cd somehow live. If this isn't the case, I would like to know how to upgrade our Bios without having to reinstall the Windows operating system.

  Thanks in advance!

  As far as I know on the download page of the BIOS that Toshiba offers the Windows version only. Of way General Linux is not supported.
  Try to contact the nearest Toshiba service provider and ask for help. Maybe they can get this special CD.

  By the way: why you didn t prepared machine (BIOS update) before starting to install Linux?

• Audio choppy and distorted on Portege Z930 after update of Win7 for Win8 64

  I just wanted to share a tip with you that cost me some time to work, about the sound reproduction of a Portege Z930.

  When I got my new Z930 - 14L, he was running Win7.
  I tried everything like you do when you get a new machine and it worked fine - including the audio playback.

  When I updated for Win8-64 since the CD that came with the computer, everything still seemed to work very well and I had not changed any driver or Setup.

  However, after a few minutes, the linenn of audio playback. It choppy, distorted, interrupted, stuttering and I was shocked.

  Oddly enough, as soon as I turned my attention to the computer again, reading was OK again - but no screen saver came and no power saving mode has come in so little time. I knew that this was no hardware problem (because it worked in Win7), it was not a driver problem (because the first 5 minutes, the sound was pristine), he was not a ground loop, (as many have suggested) because it sounds differently.

  Thanks to another forum, I discovered that it is actually the combination of Windows Defender, Win8-64 Pro and the audio driver that causes this. If the device is idle for a few minutes, the Defender thinks it's a good idea to use idle time to scan the SSD - causing interference with audio playback. Of course, you cannot simply disable or stop the central antivirus process, that would ruin some the whole point. :-)

  _So I installed Kaspersky suite on the machine (which automatically disables the Windows Defender) and the problem disappeared! _ it's probably the only time where the installation of an antivirus suite SOLVES a problem. :-)

  BTW, this is not probably limited to this antivirus product, simply play a bit with the Defender.

  Best, Yuppie

  > Then I installed Kaspersky suite on the machine (which automatically disables the Windows Defender) and the problem disappeared! It's probably the only time where the installation of an antivirus suite SOLVES a problem.

  Thank you much for sharing this details here in the community.
  I guess that the information could be useful for others who have these problems of his fellow men.

• Portege Z930-118 does not start after the BIOS update

  My PORTEGE Z930-118 failover and wont start after I upgrade in the middle of the upgrade I remove power, then press stop down after I see the power and wireless but the screen stays black?

  Any help please

  In this case the EPROM has to be reflashed once more using crisis disk BIOS.
  Usually this must be done by authorized maker Toshiba. But of course this will be possible only if the EPROM module has not been too bad.

  What to say: try procedure (link above) posted by Bob. In which case it will not work, ASP is your next contact point.

  Good luck

• Portege Z930-146: BSOD running Win 7 64 bit - support pointers and advice

  Hello

  First post following the latter (academia / business) purchase of a Portege Z930-146 (serial number XC141056H, short PT235E part number).

  Configured the pre-installation software 64 - bit W7, local installed, delivery to the primary user (the boss).

  User reports 3 BSOD in a few days - I have the mini-decharges and made first order analysis using blue-screen display:

  PAGE_FAULT_IN_NON_PAGED_AREA (ntoskrnl.exe)
  SYSTEM_THREAD_EXCEPTION_NOT_HANDLED (dxgkrnl.exe)
  MEMORY_MANAGEMENT (ntoskrnl.exe)

  We really are the guys from UNIX, so it is not familiar territory.

  I just updated the BIOS but now have a long (50 +) list of possible drivers also be updated. One at a time to download and install?

  I ran the diagnostics memory and disk - without errors or warnings that are reported.

  Can someone identify a likely problem, or direct me gently in the direction of the road to official support of Toshiba please or suggest next steps?

  Thank you in advance,

  GLM

  Ntoskrnl.exe is a Microsoft kernel boot and the dxgkrnl.exe seems to have something to do with the chart.

  I recommend to check if the update of the display driver would improve the performance of the system.
  Then visit the Toshiba UE driver page, select the Satellite Z930 PT235E and download the latest display driver Intel.
  Z930-146 was equipped with chip Intel HD Graphics 4000, so you need the Intel driver.

  You can also try to download the driver directly from the Intel page since they always provide the latest version.

• Portege Z930 cannot start with installed RAM module

  My laptop Toshiba Portege Z930-108 has stopped booting with any module of RAM installed in the support.

  If I remove RAM module, laptop computer starts and works fine, but if I install any module of RAM (4 GB 1600 original or a new 4 1600 CL9 or 1600 8 CL11) the computer cannot start.

  The screen stays black and power led flashing two green and two orange and a few seconds later, 3G indicator also on blue.

  This is the only problem I have with this computer, but it's strange.

  I updated the BIOS to the latest version and the problem is not resolved.

  I tried to reset the hardware (http://aps2.toshiba-tro.de/kb0/TSB3B03J90000R01.htm), also I tried to reset the equipment with power button 30 seconds without battery but button without success.

  Any idea on this problem of strage?

  Kind regards
  Lito.

  I guess you used bad RAM or not fully compatible modules.
  It's the only plausible explanation.

  I recommend you to order the RAM modules recommended by Toshiba that are:

  4 GB DDR3 - 1600 PA5037U-1M4G

  2 GB DDR3 - 1600 PA5037U-1M2G

• Portege Z930-102 - Igftext.exe caused an error

  We have a problem with ultrabook Toshiba Portege Z930-102.
  Ultrabook is connected with Toshiba Dynadock U3.0 with secondary DVI monitor like dispay.

  Ultrabook comes preinstalled with WIn7 Pro X 64 from Toshiba with the last worm Intel display drivers. 8.15.10.2712. the problem occurs in only one scenario:

  1 ultrabook is closed and connected to Dynadock with external DVI monitor, windows is rebooted the system restart and windows connect to the domain we have the message that * caused Igftext.exe* and error one, then the message that the Igftext module has stopped working. We tried the drivers from Displaylink version 6.2 update to the new version 7.144152.0, but nothing has changed.

  This Ultrabook is already deployed for VIP and windows of opportunity for quick testing.

  We are oppened to any constructive suggestion, thank you in advance.

  Hello

  It seems that it's not laptop problem.
  Maybe his Intel issue because I found this thread in the forum Intel and it seems that this Intel igfxext.exe process hangs on mobile phones from other manufacturers too.
  http://communities.Intel.com/thread/31920

  I found another suggestion: just rename the file igfxext.exe to something like * igfxext.dat* and restart the laptop. It would be interesting to know if that helps.