Error - table of valid, unable to boot partition external hard in-depth.

Similar Questions

• vSphere Host Update Utility - ERROR: not enough space on the boot partition

  I get the following error when I run the host update utility

  ERROR: Not enough space on the boot partition

  The boot partition doesn't have enough space to store initrd.img.

  Expected free space (MB): 50, found: 44

  I can free until you reach the required amount?

  Send the output of this command:

  DF h

  And the version of ESX 3.x

  See also this KB (there are a few tips on where space can be lost):

  http://KB.VMware.com/kb/1016511

  André

• Error 0x8007045D when copying files from computer to external hard drive

  I am trying to copy some files from my drive HARD outside., but I get this error (error 0x8007045D: the request could not be performed because of an i/o device error).

  I run windows check disk on my external hard drive, I tried to run windows defrag, but it takes too Lowe and cancel (external HARD disk is 1 TB). I download a software defrag and defragmented my hard drive using fast (the software is O & O Defrag). I tried on another computer and got the same error. Is it a hardware problem. Y at - there any possibility to fix it. Thank you for helping

  Hello Nyfixen,

  1. have you changed the permission for the external hard drive or files you are trying to copy?

  2. you have all important data (files) stored on the external hard drive?

  3. are you able to copy the external hard drive to the computer?

  The Autorun.inf could not be a problem for that. It always seems to be a problem of permission for me. Some hard drives have a jumper on them for write protection. You should check the configuration of jumpers, thank you consult the manual that came with the hard drive for permissions.

  http://Windows.Microsoft.com/en-us/Windows-Vista/what-to-know-before-applying-permissions-to-a-file-or-folder

  Format hard drive:

  Read this article for more information on this:

  http://Windows.Microsoft.com/en-us/Windows7/create-and-format-a-hard-disk-partition

  Thank you
  Irfan H, Engineer Support Microsoft Answers. Visit our Microsoft answers feedback Forum and let us know what you think.

• What is a "device i/o error. (0x8007045D) concerning the transfer to an external hard drive to my new computer?

  I backed up the files from my old computer Visa on a 1 TB hard drive.  I now need these files on my new computer.  I have a Mac with Parallels (virtual Windows 7) running on it.  I get the above error when you try to copy the files on the Mac or the side of Windows, Mac.  What is the solution to do this, to be able to copy the files?  Thank you!

  Hello

  Try running chkdsk on the external hard drive to check if there are errors.

  1. Click Start, type cmd in the start search box, right-click cmd.exe in the list programs and then click Run as administrator.

  2. If you are prompted for an administrator password or for confirmation, type your password, or click on continue.

  3. at a command prompt, type the following command and press ENTER:

  CHKDSK X: /R

  Note in this command, x is a placeholder that represents the drive letter of the volume you want to check.

  4. press y when you are prompted to check the drive the next time the system restarts.

  5. close all applications and restart the computer. Note When you restart, Windows checks the drive for errors, and then Windows starts.

  6. after that restart the computer check if you are able to move files on your hard drive.

  Reference:

  Check a drive for errors

  http://Windows.Microsoft.com/en-us/Windows7/check-a-drive-for-errors

  Important: when running chkdsk on the drive hard if bad sectors are found on the disk hard when chkdsk attempts to repair this area if all available on which data may be lost

• What is an I / Q error? This occurs with the backups using external hard drive SeaGate

  We have two external hard drives; a 3Terabyte (don't know how it) Seagate and another whose name escapes me. On the Seagate, I get the message: backup did not complete due to I / Q error. What is I / Q error and how to fix this? If all goes well, not a complicated process.

  Thanks for any help. Hope I selected the areas to fix this, below.

  Fred, SR.

  Win7 64 bit, Office 2010

  Hello

  I assumed that by I / Q error you mean error e/s? Run chkdsk on the drive Seagate:

  Start > Search bar > type cmd right click and select run as administrator

  High CMD should now be open, type the following:

  CHKDSK x: /r

  x involves the reader of your letter, so if your hard drive in question is the letter c, it would be:

  CHKDSK c: /r

  Restart the system and allow to run chkdsk.

  Kind regards

  Patrick

• Disk partition external hard indicates vacuum. Properties shows 96 GB used.

  I have an external hard drive partition that shows to be empty.  However, when I look at the properties, it shows 96 GB used.  I have "Show hidden files" on. No explanation?

  It may be a hidden system partition.  Also the les fichiers files from hidden view, uncheck "Hide protected operating system files" as well.

• Unable to connect the external hard drive on the computer of Windows 8

  Hi I have a laptop Windows 8, I don't know too plug I bought last year I recently bought a samsung 3 TB external hard drive I plugged it in and it was recognized tried to transfer files (photos and music) he transferred a little then kept showing error e/s even when I clicked ignore it just kept showing for the next photo , so I unplugged and ive not touched since ive then connected again today to have another shot at it but it does not even appear in the my computer part now ive red somewhere else on this site to go into Device Manager and I can see the mass with a yellow triangle storage device small as he said he could on the subject , I was reading I uninstalled and plugged the hard drive on and when I plug it then settling again, nothing appears when I go back into Device Manager it is there once again with the yellow triangle, thanks in advance if anyone can give me advice.

  Thanks for the reply.

  Have you tried to uninstall and reinstall the USB controller drivers?

  If so, have you installed latest drivers from the motherboard chipset?

  Follow the steps below and check if it works:

  1 download the drivers for external hard drive from the following link and check.

  http://www.Samsung.com/us/support/downloads

  2. click on the link to the HP Web site below to download the latest drivers. Search for drivers related to USB / external peripheral.

  http://h10025.www1.HP.com/ewfrf/wc/softwareCategory?cc=us&LC=en&DLC=en&product=5078476

  Click scan now.

  
  3. If you have a third party security/firewall software installed, you need to change settings or disable it temporarily.
   
  NOTE: Antivirus software can help protect your computer against viruses and other security threats. In most cases, you should not disable your antivirus software. If you need to disable temporarily to install other software / update, you must reactivate as soon as you are finished. If you are connected to the
  Internet or network so that your antivirus software is disabled, your computer is vulnerable to attacks.
   
  I hope this helps. Back to us for assistance.

• Received error BSOD, ran Diagnostics, got the error code 2000-0146, tried to boot from different HARD drive, got the same stop error message

  So my friend gave me his computer dell laptop. The thing would boot normally for a few days until he would give me a blue screen of death with the "UNMOUNTABLE_BOOT_VOLUME" message constantly to not even upward. I ran the diagnostics and got the error code 2000-0146. What I've read, this code error means that the HARD drive is bad and must be replaced. So, to make sure that it's the hard drive, tried to boot from an old hard drive, I got around the installation by USB and windows gave me the same stop error message. May - so that means it's a motherboard problem?

  No, it isn't - unless the operating system was installed on this drive AND the system in question, that it won't work as a bootable drive.

  Unplug the system, remove or disconnect the battery and hold the power for 30 seconds approximately.  Turn on and re-run the diagnostic tests - if the same error appears again, the drive is bad.  Replace it.

• Impossible to partition external hard drive

  I have two HD with files in MS-DOS (FAT) format. But I have a few files more than 5 GB, so I would like to create a partition exFAT, without losing the original files (aka, without formatting the HD).

  One of them, when I use disk utility, I open the menu of partitioning, but when I try to add a new partition (by clicking on the button +) nothing happens! See the screenshot:

  

  The other is won't let me even open the menu score (it's gray, and I can't click it):

  

  What should I do?

  Thank you

  You can't resize a FAT partition. You cannot create a partition where there is no free space to do so. You can not re-partition / re - format the drive without erasing it.

• Partitioning external hard drive NTFS on iMac?

  I have a 500 GB hd ext Omega, which is in NTFS format. I used it when I had a PC. I can still use TI-reading data, copy on Mac etc but unfortunately the space there I would use on it is inaccessible. I'm running out of space on my hard drive of Mackintosh and hope I could partition the omega using disk utility. But, when I try the option of Partition does not appear as an option. I'm under Lion 10.7.5... any reverse this?

  Read this previous thread of the Knowledge Base...

  How to format external Seagate 4 tb HD 'ExFAT? NTFS

• Boot from external hard drive

  My external hard drive is connected to my USB hub member.  I need to start from the outside (and backup on it works fine).  When I hold down the option key to restart, externally does not appear as a startup disk.

  You format the disk to a bootable disk and you have the OS files needed for this topic?

• Unable to detect the external HARD disk

  I have a Buffalo external HDD 3.0 Ministation 500 GB which worked great for a month, but now when I plug it into my laptop it does not appear in my computer. It does appear in disk management and remove material without a drive letter.

  I looked for a solution and tried to rename it in disk management, but the option letter and paths of change disc is not available. Please let know us if there is another solution. I use Vista Home premium on a computer Asus F80. I have important data in there so reformatting now is not an option.

  Plug the other ports does not work. Always undetectable.

  Reset does not work

  Update the hard disk driver does not work. He said that the drivers are up to date.

  Plug it into another machine has the same undetectable result.

  Hello

  I would like to ask you to the manufacturer of the device to contact for help that you were facing the same issue when you talk the device to another computer.

• Computer unable to detect the external hard drive after installed update

  original title: update for the usb drive problem

  2 things really:

  Should I really all these updates unhappy? My computer spends much more of his time fiddling with updated it and update that never it does nothing I want to do. (Where do you want to go today? I want to lose my afternoon watching this stupid update new thing!) I'm sick of forever updated. And...

  I keep losing my 1 TB ext HDD. My computer won't find it. I do a restore to when it was visible, and I can use it. Then miserable update starts messing around again and I lose it. It seems to me that the update is hiding my ext drive.

  Any help much appreciated

  see you soon

  Hello SidBloggs,

  Did you first disabled automatic updates by following these steps: http://windows.microsoft.com/en-US/windows-vista/Turn-automatic-updating-on-or-off

  Once they are off have you tried every day updates individually and you determine who updates is causing the problem with your hard drive?

  Maybe it's just that the update interferes with the driver that you have for your hard drive and it may need an updated driver.

• Unable to detect the external hard drive (WD)

  My laptop does not recognize my external hard drive.  I have Western Digital external drive (my passport).  Can you help me please?

  The external hard drive is recognized on another computer? MS - MVP - Elephant Boy computers - don't panic!

• Unable to access external hard drive.

  Orginail title: G: is not accessible. ?? Windows 7

  I have an external hard drive of my passport.

  . I have Windows 7
  The computer reads but cannot access it.
  I did some research and saw that cmd-chkdsk g: /r is working to fix it.
  I did the other day, after a while, it seemed that it worked. (treatment and removal of some files)
  But my gf unplugged the hard drive!

  I tried a few times, and now he is just like that ' master file table corrupt.» Windows will attempt to recover the master files of the disk table.

  Its been sitting there for about an hour, nothing is has been updated or changed.
  Is there a way to return to the old cmd of before, like restart the process?
  Someone at - it suggestions?

  Hi Ryan,

  Welcome to the Microsoft community.

  I understand that you are unable to access your external hard drive. We will help you solve this problem.

  I suggest you disable the disk activity control. Follow the instructions to disable the disk check.

  1. Command prompt opened with administrator.
  2. Type chkntfs /x c: g:
  3. And then restart the disk check process

  If the problem persists, follow the method below.

  Method 1: run the auto repair by using the installation media and check if it helps.

  1. Insert the bootable (USB or DVD) media and restart your computer.
  2. Press the F12 key (usually it's F12, but it may differ between computer manufacturers) and choose the drive in which you inserted into the installation media.
  3. Once the Windows Setup window appears, follow these steps:
  4. Click next and select repair your computer.
  5. Click Troubleshooting option, and select options in advance.
  6. Click the automatic repair option.

  If you do not have installation media, then create a referring to the answer of Mr. André Da Costa.

  http://answers.Microsoft.com/en-us/Windows/Forum/Windows_7-windows_install/where-can-i-download-Windows-7-ISO-i-have-a/7d964b05-2be9-4800-BC7F-3ca30356fc3d

  It will be useful. Let us know if your problem is solved. For further information, feel free to contact us.

  Thank you.