Satellite A100-914 - stop after 10 minutes on

Similar Questions

• Satellite A30 921 stops after 10 minutes

  I am the owner of a Satellite A30 921, but it stops after 10 minutes.
  I tried to change the settings for toshiba power management, but they will not work any ideas?

  The laptop turns off automatically without display of error messages?
  This can be caused by an overheating problem!

  How old is your laptop and you clean the cooling fans in the past?
  If this isn't the case, I recommend you this doing.

  To clean the fans, you can use the jet of compressed air that can be bought in most computer stores.
  The problem is that dust and debris inside of the laptop prevents cooling modules works properly, and so the temperature increases to a higher level. This leads to the farm automatically from the bottom.

  In my opinion, fans of cleaning might help with this problem.
  Good bye

• Satellite Pro A10 stops after 15 minutes of internet games

  Hello
  When I play games on the internet such as zuma, scherwoods my laptop sat pro A10 stops after 15 min of game
  When I start my laptop it read disk
  What can do what
  [email protected]

  Hello

  I think overheating is the problem. First of all, you can try is to clean the machine properly. I guess the CPU and graphics card works very intensive and produce a lot of heat. If the equipment cannot be cooled properly the laptop stops suddenly.

  Clean it up.

• Satellite C660-1ZN stops after 30 minutes

  I just recently brought a portable c660-1zn but it overheats and turns off after about 30 minutes when I play games like second life on the graphics settings lower.

  I know that's not it's a new laptop from dust. Should we do this? or is it current on these laptops
  more his game to power saving in power management and am making sure that the ventilation is not covered.

  > I know is not that it is a new laptop from dust. Should we do this?

  Laptop overheating not even if some strong performance running applications or everything at stake.
  You use the preinstalled Toshiba system?

  You should test the laptop with system preinstalled Toshiba and published by Toshiba display driver.
  The driver can be downloaded from the European pilot of Toshiba page!

  Remember that this driver is already installed, because this driver supports the GPU overheating protection. This keeps the temperature low and decrease the performance if the temperature rises.

  This is necessary because the laptop cooling modules are smaller than the cooling modules in desktop computers.

• Satellite Pro U200 starts after some time it stops after 5 minutes

  Satellite Pro U200 stops after 5 minutes, then starts after some time. When she stops the
  blue screen say - stop: (0x0000008e, 0xaa846f58, 0xa9f29808, 0x00000000)

  Sysaudio.sys - address aa846f58 base at aa843000, datestamp 41107f1a

  Hello

  Believe me; It's not easy to say exactly why the BSOD appears.
  It usually happens because of a malfunction or severe software hardware fault.
  Have you used the operating system of the image of Toshiba?
  Message it says something about sysaudio.sys.
  This file is a system audio WDM filter processes and it s a part of the Windows operating system. It controls the material such as the printer or the graphics card at a lower level.

  Note: The virus uses these files as a camouflage. You should always use an anti virus application.

  In addition, you suggested that the laptop stops after 5 min.
  Well, this looks like an overheating problem. How did you use the laptop? You know that free space around the laptop is very important due to the circulation of air. Fans should also be free.

  I you use Notepad in the right position and it happen, so I recommend asking for help Toshiba service partner. They should check the laptop.

• Satellite A100 psaa9e beeps after BIOS update

  Hi all!

  My pc is a Satellite A100 psaa9e and after that the Bios updated Bios say 'no tmp or tmp has failed. "

  I have try this procedure (http://forums.computers.toshiba-europe.com/forums/thread.jspa?threadID=36186&tstart=0) and my pc does not restart automatically.
  He finishes the beep continuous beep, a low beep and two normal beep, and * didn't do anything that I have not reset! *.

  _FLOPPY LEADER: _
  the diskette is 1.44 m
  MINIDOS on the diskette. SYS PHLASH16. EXE BIOS. PHLASH WPH. INI
  the BIOS. WPH is version BIOS of San Antonio s10gm590.rom (5.90) http://support1.toshiba-tro.de/tedd-files2/0/bios-20070709111839.zip
  the PHLASH. INI file contains the following:
  [UI]
  Advanced = 1

  [Hand]
  RetryCount = 3
  UpdateMode = 3
  FormatVersion = 2
  UpdateFlags = 802880
  UserFlags = 802080
  UserMask = d121a4
  PSIFlags = 8000080
  UserMode = ffffffff
  BackupFile =
  ImageFile =

  Please help me!

  In my opinion, the ROM module where the BIOS is stored has been damaged or has been flashed properly.
  In your case, I recommend you contact the ASP technician and ask guys processional flashing the BIOS.

• My DEFY music stops after 3 minutes with the music player not on the list end

  I have a problem with the way my Defy plays music.

  I'm ciau built in music player and it works fine if I listen to it from the widget of the screen, but if I go into the player's menu and manually select a song in the list he stops playing after 3 minutes (once the screen goes black).

  It's really annoying as I'm going jogging, I can't listen to the favorite podcast that she stops after 3 minutes. I have to keep hitting the widget button 'next' until I find this podcast to listen to it without interruption.

  In addition, music player is not on the list of end in my task manager.

  Help...

  
  

• I have my laptop set in place to stop after 15 minutes of inactivety

  I have my laptop set up to stop after 15 minutes of inactivety I use a k/b wireless & mouse & put the lid nothing when closed when I try to run he won't come 'sleep' no mode using k'b or the mouse

  This problem occurred after an update of windows - ie updates that would have included drivers recommended

  If so, reinstall the chipset and updates from the support site for manufacturers of portable type pwr

  You must also install the updates to the bios

• Satellite Pro 6100 stops after 15-30 minutes

  My satellite Pro 6100 Cup after 15 to 30 minutes of operation on power outlet. There is a noise and all the lights go out except orange slow flashing (power problem). I have restore by removing the power cable and wait a while.

  It will then start again. I used two different adapters and two different batteries. It also happens if work on AC with no battery in the. My suspicion is an overheat cut-out. The Sat Pro has a? Could it be clogged with dust inside (it is 5 years old)? If yes how I clean. I don't think it's a fan failure because I can hear the fan cut in. Advice much appreciated. Thank you.

  > Could it be clogged with dust inside (it is 5 years old)? If yes how I clean. I don't think it's a fan failure because I can hear the fan cut in
  I agree with you and the user SambadeAmigo. It seems like a simple problem of overheating and so the laptop automatically stops to prevent the equipment from damage

  I assume that your laptop can be enabled again after being allowed to cool. It is a common question if the cooling modules may not work properly because of the dust and debris.
  As suggested, it would be possible to remove dust using the can of compressed air.
  It should work.

  See you soon

• Satellite A10 stops after 40 minutes

  A-10 Pro keeps closing after 40 minutes, power source is always the head of HQ, can anyone help?

  Has been verified the following: -.
  Virus
  Management - never switch on stop
  Cooling fan seems to agree

  In my view, this question has nothing to do with the virus, but maybe with overheating.
  How old is your laptop?
  Have you ever cleaned cooling grids or cooling fans? Fan may be OK, but how it looks behind the grille. Perhaps there dust and traffic blocks the air properly.

• Satellite A30-213 - stops after loading Internet pages

  My satellite A30 213 stops almost everytime, when I enter a website with a lot of uploadings. The machine rotates in about a minute or two and closed its doors. I know that my RAM is only 256 KB. Is that why and in this case, what can I do about it?

  Best regards
  Janne

  Hello

  It is not easy to give a correct answer, but the fact is that 256 MB of RAM for using Windows XP Home edition is really not much. I do not know what A30 you have exactly, but some of them can be upgraded up to 2 GB of RAM.

  RAM modules are not more expensive and I recommend you to upgrade to 1 GB minimum. After this the laptop will have a lot more resources and will go much faster.

• Satellite A100 keeps freezing after a short period

  Hi, I wonder if anyone can help.

  I have a Satellite A100 laptop. The laptop starts without any problem. However, after a short period of time the system crashes and I have to reboot the machine.

  I am running Windows XP Home Edition. I tried to reinstall a new copy of windows XP Edition family. However, the laptop continues to freeze when I try to do something.

  Although the real time, it takes before it freezes changes each time.

  I have two 512 MB RAM chips, and I thought it was a fault memory. So I took each chip out, leaving the other chip in. It makes no difference, the machine hangs with either chip.

  Help, please. I would like to hear from anyone who might suggest what's not here.

  Thanks in advance

  Maybe the temperature inside the laptop could be the reason of this gel.
  I had once similar there is question. My frizzy 6 specifications because the temperature affected the memory modules.
  So I cleaned the cooling fans using a jet of compressed air and I replaced the thermal grease which is a space between the cooling module and CPU. This helped...

  You can try to clean the cooling also fans. But be careful and if you have no experience, then a mobile technician should help you.

  Good luck

• Satellite A100-498 hangs after suspension or hibernation

  Hello everyone

  I just bought a new satellite A100-498 and just realized that whenever I leave the computer for a while and he needs to go in hibernation or suspenson, he's going, but when I get back and try to restart, it begins to restart, but it crashes right after with a black screen (in hibernation) or on the desktop (suspension). I tried to change the settings for tye on the Toshiba powersaver, but it still happens...

  can anyone help?
  Thanks in advance

  Hi Helen,
  Try to install the new drivers VGA and chipset.
  I think it will solve the problem.

• Satellite X 200 freezes after 15 minutes of inactivity

  I'm tired of this problem: my laptop freezes after 15 minutes of inactivity and I can get it going again to reset. The problem was solved when I reinstall Vista, but after several months my laptop started hanging up. And my laptop is unable to install Tempro 2.0.3.

  Please, help me to solve this problem and I don't want to reinstall Vista again.

  Hello

  For me it sounds like that a 3rd party software application or is causing this problem because you wrote that after Vista reinstall, the problem has been resolved.

  I put t know this software you have installed, but you need to remove all unnecessary applications as shareware or trial versions.
  Then use CCleaner to clean the registry.
  Visit the Windows update website and install all the updates that are available for your Windows.

  In the worst case, you will need to reinstall Vista again. In my opinion a reinstall from time to time is normal and I have reinstall my laptop every year. So I often have good performance.

• Satellite A100 - display balack after replacing the LCD screen

  Hello

  So I'm trying to fix a LCD on a Satellite A100. The girl I am set as said she accidentally hit the screen with his hand and became black.

  When you turn on the laptop I can here windows activate, nothing is on the LCD screen. It is not the backlight, because I don't see anything on the screen at all. So I bought a replacement LCD screen and that one does not work either. Same question

  I think it is the inverter, any suggestions?

  Could be the sensor cover?

  Thank you! Kyle

  Hi Kyle,.

  Did you buy this new LCD screen to a service provider authorized? I ask this question because it would be interesting to know if it s a Toshiba valid a party or 3rd party a spare.

  Did you check the connection of the LCD cable? There may be a link to lose or the cable itself is touched.
  Theoretically, it might be the FL inverter too, but I doubt that. Otherwise, you'd see something on the screen but very dark.