Upgrade memory - starts to beep

Similar Questions

• Satellite L50 - A - 1 5 PSKK6E does not start after upgrading memory

  Upgrade memory L50 - A - 1 5 pskk6e

  I have a memory ddr3 4 gb 1rx8 pc3 - 12800 S-11-12-b2 hynix and I tried to add another memory
  memory DDR3 4 gb 1rx8 hynix pc3 - 12800 S-11-11-b2, but it does not boot up the laptop.

  I tried to mount only the new but it won't start.

  Some ideas?

  I think that it s you already know that this Satellite L50 - has - 1 5 would support max 16 GB of RAM (2 x 8 GB)

  But why, box for computer laptop doesn t is very simple: the new modules are not compatible.

  I found modules recommended by Toshiba.
  These are:
  8GB DDR3L - 1600 PA5104U-1M8G
  4 GB DDR3L - 1600 PA5104U-1M4G

  Both are made of Kingston and the specifications are:

  Memory speed: 1600 Mhz PC3-12800
  Capacity: 8 GB (1x8GB module)
  Pins: 204 SODIMM
  Type of RAM: DDR3 SODIMM
  Verifying the integrity of data: non ECC
  Specifications:
  Latency (CL) CASES: 11
  Voltage: 1.35v

• Satellite L100 113 starts slowly after upgrade memory

  Hello

  Toshiba Satellite L100 113 PSLA3E-02401JRU starts slowly after upgrade memory with Kingston KTT533D2-512 (512 MB) of memory.
  When I press the 'power' button, it flashes, starts the fans and HARD drive several times. Then it shows BIOS start messages by memory full 768 MB and starts Windows XP without a problem.
  This behavior is noticed only after "shut down."
  It does not happen with "restart".
  What can I do to eliminate this long "attempts" to start my laptop computer?

  Thank you
  Novomir Kovalenko

  Hello

  This problem appears before upgrade memory?
  Have you used exactly the same memory modules?
  If this isn't the case, then perhaps there are a few compatibility issues.

  Usually, after the insertion of the modules you must enter the BIOS and then save the settings. Please it and eventually the laptop will start without any problems.

• Upgrade memory for desktop Aspire TC 705

  Hello, I would like to upgrade my TC Aspire 705 4 GB to 8 GB... whose memory is compatible and which is best?

  It has two slots a blue and a green, blue is occupied by the Bank of memory that came with the pc and is a SK 4 GB PCL3 1Rx8 hynix low voltage - 12800U - 11-13-A1 I said, I tried a similar Bank, but he did not not recognized by pc (?) no beeps or the other (?) I tried the solo Bank upgrade, then I got beeps (?) someone advice pls?

  TIA

  Rudy

  The problem with the purchase of Hynix is that it is too expensive.  Almost double or triple the price because they have really not the retail arm for their "regular memory.  They started a retail arm for their passionate high range for boards thing this year... which does not help.

  All you really need is this module of Kingston.  It works perfectly with your memory of BIOS and Hynix Board, CPU, Intel/Acer H81... and should run two channels with existing memory... no problem.

  http://www.Newegg.com/product/product.aspx?item=9SIA4M53GY8162&cm_re=KAC-VR316S%2f4G-_-20-239-298-_-...

  Edit: If you can find the part of Hynix on Ebay at reasonable prices, then go ahead.  I have the above kingston module and it works perfectly (dual channel) with Hynix in tc - 605 (which has the same advice that tc-705).

  Edit2: Memory voltage (DDR3L) will work to 1.35 or 1.5V.  Your existing Hynix DDR3L will work perfectly @ 1.5V as this is a standard JEDEC for your motherboard.

  http://www.Kingston.com/us/memory/search/?partid=KAC-vr316s/4G

• Upgrading memory on the NB550D - 11 d - 4 GB of RAM are possible

  To anyone who thinks of a memory upgrade on the NB550D:

  The NB550D supports up to 4 GB of memory, not only 2 GB as mentioned by Toshiba in their specifications.
  Upgrade memory to 2 GB is _only limited_ by the pre installed Windows 7 Starter OS, and not by the netbook itself.

  I use Linux Mint 11 Katya, 64-bit and my system works perfectly well with a 4 GB ram module. If you want to use the full support for 4 GB ram, get rid of the Win 7 Starter operating system.

  Specifications for more memory ram volume are DDR3 1333 MHz PC3-10600 SO-Dimm. I chose a 4 GB of Corsair module, because of the guarantee of 30 years of offers from Corsair.

  It took me a while to find this out hope, that this will be a help to all those who are just as secure as I was how to upgrade memory NB550D. Good luck. (o).

  Thanks for the comments

  Also it of important to mention than the 32-bit systems (not serious if its Linux or Windows) would recognize only 3.2 GB since it is a limitation of 32-bit
  So to use all of the 4 GB RAM 64-bit system is required.

• Question about upgrading memory Satellite M55-S1001

  can you please recommend what to do? I want to make my satellite m55-s1001 run faster please let me know, what do you recommend: 512 MB or 1 GB of memory? I'm not familiar with updates so please help!

  Hello

  First of all, if you want to go for fastest laptop, you should start with simple things.
  Try to defragment the disk, turn off the background process is not necessary, etc.
  Upgrade memory will the powerful laptop and of course a lot more quickly.

  To my knowledge the Satellite M55 should support the bars of memory 2 x 1024MB, and I also recommend the use of 1024MB instead of 512 MB module.

• Portege 3500 - upgrade memory

  Necessary upgrade memory for a p3500. 'Expert' advised two sticks of 512 MB PC133, but on opening the rear of the location that a laptop computer and on the insertion of the new RAM it gives an error code beep. Is there than a single slot? and if so what maximum capacity and what type of RAM will it take?

  Hi Jeffrey,.

  As far as I know the 3500 Series provided with a removable module of RAM of 128 MB, 256 MB or 512 MB depending on what model and specifications you purchased. There is one other remaining slot for expansion purposes.

  The total support for the 3500 Series RAM is 2 GB and the type of RAM should be SODIMM PC133 144 pins.

  It is important that you match the RAM modules that your RAM module existing (one removable) is of the same type you new RAM module. Of course, you can always delete the original from the RAM and insert two new modules of RAM instead.

  Please check the following URL for more information on the available RAM module type.

  http://www.orcalogic.co.UK/ASP/ProdType.asp?ProdType=5371&ft=m&St=3

  HTH

• upgrade memory in a Portege 3410ct

  I tried installing memory of 128 MB PA3034u 3410ct, but on commissioning a message comes up saying that the ACPI BIOS is not fully compliant with the ACPI specification.
  I downloaded the latest BIOS setings but makes no difference. Will not start just yet. Clues as to correct the problem, other that not upgrading memory.

  Hello!

  This problem may occur if you add the memory (RAM) to the computer when it is in hibernation.

  When the computer comes out of hibernation mode and load the file Hiberfil.sys, Microsoft Windows detects the change in the State of the memory, and then you receive the error message.

  To resolve this issue, restart your computer.

  If the problem persists, start the computer by using an emergency boot disk, and then delete the Hiberfil.sys file.

  Good bye

• Firefox 4 beta too slow / crashing after upgrade memory?

  Hello

  my beta firefox started crashing my whole system yesterday and only noticeable change I did was upgrade memory of 3 to 4 GB of RAM...

  I tested my system widely and it works very well until firefox is started, after that, the system started crashing and takes forever to be reactive. I uninstalled and reinstalled firefox, tried running without addons, I tried to close all the tabs and all Eske I remembered... still no luck.

  I am desperate because I really wanted to keep this beta on my computer, and cuz is a new facility, I can not install firefox 3.6 on side by side, I only have an option 'upgrade' on the installation wizard...

  What can I do to fix this?

  Thanks in advance!

  The steps to troubleshoot and diagnose problems of Firefox would say you always try in questions to troubleshoot Firefox in Safe Mode of course some additional software may conflict, it is even more likely if you are using a beta version of firefox and probably the beta or alpha some of the addons or plugins.

• Upgrade memory - 4100XCDT

  Hello
  I am the proud owner of a 4100XCT satellite.
  I have upgradet the HARD drive on a 30BG drive.
  I also tried to upgrade memory (RAM live) but the 256 MB Dimm PC133 so-built by A-Data, with I ordered seems not to be compatible with the laptop. (The system no longer starts when the new RAM is installed.)

  An update of the BIOS would help solve this problem?
  And: RAM that is compatible with this laptop? (Is there a witch of memories 256 MB are compatible?)

  Thanks for reading.

  Hi Katzenfreund

  The nice thing about Toshiba and memory upgrades, it's that we don't need to think about what technology or the speed to use. Just use original (recommended) or search in the referencetable of the provider to use, their module that is compatible with the partnumber Toshiba memory you want.

  Toshiba PA-numbers for the 4100 are:
  PA3004U - 64 MB
  PA3005U - 128 MB

  Good luck

  Tom

• Upgrading memory on Satellite Pro L40 - 15A

  Hello

  I have the Satellite Pro L40 - 15A with 512 MB of memory (Samsung), but I'm not going to 1 GB. I have Kingston ktt667d2 / 1 g I tray to put into the two slots, but nothing works I can't spend on computer.

  But when I change to old laptop is ok. What can I do? Install special program update the BIOS, or maybe the memory stick is broken.
  Concerning

  Hello

  Safe computer laptop doesn t after upgrading memory due to these different problems;

  -memory modules are not compatible set
  -memory modules are not compatible with the laptop
  -memory modules are defective
  -a memory slots is defective

  In most cases, replace the memory module helps.

  A hint; have you tried to move the modules of memory in the slots? Sometimes it helps.
  A few weeks ago I updated my memory and safe laptop didn t.
  I thought that it s a malfunction of memory, but after the switch module Notepad started successfully.

  Good luck

• Upgrading memory on the Satellite L500D - 13 c

  Hello!

  I own a laptop Satellite L500D - 13 c and I am considering upgrading memory 2 x 2 GB 2 x 4 GB RAM. According to a specific model list on the accessories compatible with the 4 GB of PC2 DDR2 (800 MHz) memory, item # PA3670U-1M4G, is recommended by Toshiba.

  What I want to know is if this module specific memory (with article # PA3670U-1M4G) is the only compatible module for my laptop or if I could get and buy bars of memory corresponding (and hopefully cheaper) with the same specifications (800 mhz, etc.) without damaging my PC?

  TI would appreciate some advice on this.

  See you soon!

  Hello

  You can also buy another module of memory with the same specifications. Fact is that some modules at low cost and without name can be initially responsible for compatibility issues. It may happen starting cell phone s display will be remains black.

  Therefore I recommend you to use high quality modules and Kingston is one of the best manufacturers of memory modules.

  I understand that you want to save your money but you buy it now and it should work properly.

• Satellite L350 - upgrade memory 107

  Please can someone help provide a certain insight or details on the options of upgrade memory for a Satellite L350 - 107 laptop

  According to the Toshiba records, this unit can only be upgraded to a maximum of 2 GB of RAM - there are web sites that warn that this device can take a maximum of 4 GB of RAM... This unit can be upgraded to 4 GB of RAM and if so, how do you? I installed 4 GB of RAM in the unit and the BIOS recognizes the RAM during POST. Windows starts to load and then crashes...

  The unit is a Satellite L350 - 107, model number PSLD0E - 00500TF3

  Thank you very much

  Hello

  In General, upgrading memory depends on the chipset that is placed on the motherboard.
  The Satellite L350 107 has been provided with the Chipset Mobile Intel GL960 Express and this chipset manages max 2 GB RAM
  This means that you can upgrade the RAM to 2 GB RAM max using PC2-5300 memory Modules.

  Hope this info might help you.

• Upgrade memory 520-1050 TS

  It would have been great if the 520-1050 TS came with its maximum in memory of 8 MB instead of 6 MB, but no problem, it can be upgraded.

  My question, it seems 2 types of memory upgrades can be used and wanted to find who I use because I've always loved my systems to memory max. The specs on the upgrades memory say the following:

  -==============================================

  Boxerm, welcome to the forum.

  Given that the motherboard supports the memory dual channel, you will need to replace the existing memory.  It seems that there are only two slots.  So, you want to buy a set (2 x 4 GB = 8 GB) you ensure that you have dual channel.  Dual channel is faster.  I would buy the PC3-10600 (DDR3-1333).  Here's a good explanation of the speed of memory.  If you're like me when I started to learn about the RAM, most of this information is difficult to understand.  However, it will give you a good learning experience.

  I suggest to use the Crucial memory.  Here is the memory they recommend for your computer.  Recommended memory is guaranteed to work or it will be replaced free of charge for you.  I had read the entire page, as it provides good information.

  If your problem is solved, please click "accept as a Solution.

• cannot start single beep heard

  computer feel about one inch of the plateau, now it won't start, single beep heard reinstalled memory, checked everything, nothing seems to be wrong, help its my daughters computer, she has the habit of stop asking to play mine help she is only 4

  Make and model of the computer?

  Could be hard drive, does not resemble the loose video.