Validity fingerprint Sensor does not not after replacing hard drive

Similar Questions

• Recovery disk works does not after replacing hard drive Pavilion dv7

  Hello. I have problems of replacement of a failed hard drive in my HP Pavilion dv7-6154nr notebook running Windows 7. New HARD drive seems to install OK, but I get a Windows Boot Manager error when I try to run the recovery disks created when the system was purchased. The message says "the boot selection failed because a required device is not accessible" "status: Oxc000000f. I changed the boot order in the BIOS to boot from the internal DVD player but continue to make the same mistake

  More info: I upgraded the HARD drive from a Toshiba MK6476GSX - 640 GB - 5400 RPM for a WD Black 7500BPKTSP.  I don't see any info in the new HARD drive in system information / BIOS so I don't know if it is recognized. However, it take and pass a diagnostic test.

  Thank you.

  You are the very welcome.

  Now you get the drivers from the support page and driver for your PC.

  http://h10025.www1.HP.com/ewfrf/WC/softwareCategory?CC=US&DLC=en&lang=en&LC=en&Product=5151752&Task= &

  If you have a problem to find drivers (such as the wireless, unless you already knew what the wireless adapter model you have in the PC, you will not know which driver to install).

  Just after the hardware ID's for all you can't find the drivers.  Who need device drivers appears in the Manager for devices with a little yellow. brand and labelled with material generic terms such as a network Contoller or PCI device, etc.

  If you don't know how to find the hardware ID, please read the info on the link below.

  http://www.DeviceDriverFinder.com/blog/device-drivers/how-to-check-the-hardware-ID-for-a-Windows-device

• Windows Update does not not after replacing hard drive in the laptop

  I had to replace the hard drive in my HP Pavillion DV6911OM. Everything works except Windows update. I tried all the recommended fixes I could find on any site without success. Any ideas anyone?

  Hello

  (1) you get an error message?
  (2) what exactly happens when you try to update Windows?

  See the methods mentioned below and check if that helps

  Method 1:
  Problems with installing updates
  http://Windows.Microsoft.com/en-us/Windows-Vista/troubleshoot-problems-with-installing-updates

  See also:
  Updates: frequently asked questions
  http://Windows.Microsoft.com/en-us/Windows-Vista/updates-frequently-asked-questions

• Tecra A11 - 11L - fingerprint sensor does not work

  Hello
  I had a problem with my Tecra laptop. The fingerprint sensor does not work since yesterday. It also disappears from the hardware Manager. I tried to reinstall the utility, but the setup.exe will not run successfully. When I try to install the utility directly from the amd64 Directory installation will be successful, but the software is unable to connect to the fingerprint sensor. I also tried to install the original Windows image, but the sensor does not work.

  You have any ideas?

  Berst cordially
  Thunder1988

  You can try a BIOS update and set the default BIOS. If it still does not appear in Device Manager, the player is maybe defective or there is a connection problem. I'm guessing that the laptop is still under warranty, you may have to send the laptop to a Toshiba repair center.

• The fingerprint sensor does not work

  Hello, I have reset windows on my laptop and the fingerprint sensor does not work, windows recognize the sensor, but in the Device Manager, windows says there is a problem with the sensor, "this device does not work properly because Windows cannot load the drivers required for this device. (Code 31) »

  Thank you for your attention

  I finally found the problem reset the pc thanks for your attention somehow

  Good day.

• HP Pavilion 17: mouse pad does not work after replacing hard drive

  Hello

  After replacing hard drive and installing windows 8.1, I can't use my mouse pad.

  I installed the Synaptics driver but it didn't help.

  How can I check that mousepad device is not damaged when replacing the hard drive and which also can I try to fix the mouse pad?

  USB mouse works fine.

  See you soon

  The only way to be sure is to open it up and see if the touchpad cable was disconnected during the upgrade of the hard drive. That's my bet. Easy to forget when you're winding. You don't provide complete model number, but many of the recent models Pavilion 17 require removal of the cover together to get hard disk that requires disconnection of the touchpad cable.

• My mac does not detect my hard drive after the upgrade. How to solve this problem?

  My mac does not detect my hard drive after upgrading to Mac OS Sierra. How to solve this problem?

  Please provide more detailed information. You can read write an effective communities of Apple support question. Maybe you could open disk utility and take a screen snap so that we can see what you see.

  To post a screenshot

  1. Press command + shift + 4, that will change the cursor to the line of sight.
  2. Hold down the mouse button and the collimator allows you to select the part of the screen you want to capture.
  3. Release the mouse button and the image will be saved on your desktop.
  4. Click on the camera icon in the toolbar of the message forum Editor.
  5. Drag the image on the button select a file and click the Insert button.

• Dell Vostro 430 sometimes breaks down and does not find the hard drive in the bios

  So I have this old - ish Dell Vostro 430, intel cpu, windows 7 hard disk sata 250 GB, 4 GB of ram.

  Update BIOS to the latest version 2.4.0

  In certain exceptional circumstances, this PC sometimes crashes in windows, it is restarted, and then when he comes back it does not find the hard drive as a gift. He is not seen in the bios and does not start.

  To fix, I have to unplug the power cable, wait a few seconds, plug in, reboot the computer and it starts normally, load windows and everything.

  So far, I have tried to paginate on another hard disk, reinstall the Windows operating system from scratch, and same thing happens from time to time.

  It is difficult to find the cause of the problem, because this happens very rarely.

  Sometimes, when the pc is turned on for the first time in the morning, the hard drive is not found by the bios and we reappear at the same trick (disconnect the power cable) to take him back.

  When it crashes when using inside Windows, it seems that the reason is the computer can't find the hard drive.

  Such computer is out of warranty.

  It would be nice to just throw this computer because it is still fine for the work it has to do, + I have Windows and Office OEM license on it, as well as many other software that I have to reinstall etc.etc.

  No idea what I could troubleshoot?

  Maybe change the motherboard? How can I buy a new motherboard for an out of warranty Dell?

  While possibly keeping all the OEM licenses (Windows 7 and Office 2007).

  Desu

  .. .once in a while...

  That will make hard to resolve this situation.

  • Have you tried to replace the battery in the motherboard, if nothing else than to exclude it? CR2032, 3-volt lithium-ion, ~ $2 at discount stores. Do not forget to open the BIOS Setup and copy down all current settings first because remove battery BIOS resets the default values, which is maybe not correct for your specific system.
  • Have you tried another SATA data cable, or reinstall the existing at both ends?
  • Have you reinstall RAM and PCI card in their slots?
  • Have you used canned air to blow out the dust?
  • Maybe a power supply problem... ? If insufficient voltage, he could not start the HARD drive quite fast at startup, or quick enough after your option settings to be able to turn the HARD drive off when it is not accessed, what may cause this error message 'not found '.
  • If you use a power strip or surge protector, have you deleted and the PC connected directly to a wall jack?

  If it is a motherboard defective and you replace it with another jury of Vostro 430, you shouldn't have any problems with Windows or Office licenses. Assuming you are using Windows Dell reinstall for exact same version of Windows drive that was installed at the factory, it should not even ask the product key, if you must reinstall Windows on the HARD drive. But even if she asks, there should be a sticker somewhere on the PC with your unique product key so you can enter if the installer made the request.

  and make sure you have the Office product key too...

• Satellite A30 PSA30E - BIOS does not recognize the HARD drive

  Hi all
  I have a Satellite A30 (PSA30E) and I start the computer. When I enter the BIOS it does not recognize the hard drive.
  Does anyone no what I can do?
  Is it possible to restore the BIOS?

  Thank you

  Hello

  You replaced the HARD drive by a new one or the BIOS don't recognize the old HDD?

  Usually if the laptop is not able to start and that the BIOS does not see the old HDD then I guess that the HARD drive is faulty.
  If the BIOS doesn't recognize the inserted new HARD drive and then either you ve bought is not compatible, or the size of the HARD drive is just too big.

  Please provide more info. You see error messages?

• Windows 7 Starter Edition does not recognize a hard drive WD

  Windows 7 Starter Edition does not recognize a hard drive WD, I used until last month. Device Manager sees it, he sees the USB controller (it lists as a mass storage device), but I can't access the information on the hard disk, or make use of the last backup. I tried to uninstall USB drives - it is not the thing. It gets listed under disk drives.

  Thanks for the reply.

  There was no error message: the device has been recognized (listed) by the USB controller and the Device Manager, but not by the management of the disks - so I couldn't access.

  I managed to fix the problem after:

  -J' scanned the computer (DELL Inspiron) with the Safety Scanner
  -J' completely uninstalled all the software associated with an external hard drive
  -J' uninstalled the USB controllers
  -reboot the system
  -reconnected the external HD
  -After gaining access to the drive, I installed the dedicated software

  Best regards

• I can't access my external hard drive with windows 7. How can I get my music out of her files? My pc with xp operating system can access it without problem. but my new pc with windows 7 does not see the hard drive.

  I bought a new pc to replace my old hp 14 months as the motherboard fried in. I bought a case of disk external hard to rocketfish to put the hard drive of my Windows 7 pc in. burned does not see the hard drive. my old pc with xp can access all the items on the external hard drive.

  Check that the drive appears in Device Manager.

  If so, go to disk management and assign a drive letter.

• Recovering the Windows system does not recognize the hard drive

  Computer does not recognize the hard drive when booting.  Guard gives me 1782 disk error.  Then try to use the ROM installation thing and throw a disc hard test there is no option to test anywhere.  Computer was working fine this morning and then I stop when I turned it back on it was not properly start.

  I have a zt3000 running xp sp3

  someone please help me, thanks

  Hello

  Please reinsert the drive from the rear panel and check if the device detects the drive hard in case you have the same problem, then the hard drive is bad, you need to replace the hard drive and reinstall the operating system on the unit to return to its operating state.

• Dell Inspiron 531 s problem of power/does not recognize the hard drive

  My Office does not illuminate. I replaced the power supply. No, it powers on but does not recognize the hard drive. It gives an error as SATA 0 None SATA 1 no SATA 2 No. How do we know that the cables are properly connected. I feel like I'm very close to solving the problem but don't have a clue what that next step to follow

  The original PSU had 4 sets of cables and connectors.  The new power supply has 5 sets of son.

  aries7531

  From your post, I guess that the configuration of the system now recognizes the hard drive?

  If you do not have a floppy drive, then BIOS can find the player who isn't there, it returns this error.

  Make sure that the floppy drive [drive A] is disabled in the [BIOS] installation system, page 173, so that it is no longer looking for the disc and see if this stops the error message.

  If the hard drive is recognized in the configuration of the system, he now knows in windows "My computer" or in "disk management, [right click on 'My computer' and select 'Manage', then disk management]."

  Bev.

• Windows 8 does not see the hard drive on the Satellite A200

  Windows 8 does not see the hard drive on the A200.
  How to install it?

  S strange Windows 8 should already contain the HARD drive controller driver to recognize the HARD drive during installation.
  The HARD drive is visible in the BIOS?

  Do you use the original disc from Microsoft of Windows 8?

• Tecra S3: Installation of Vista does not recognize the HARD drive

  I try to install Vista Ultimate on my Tecra S3, but installation does not recognize the HARD drive.

  I tried to find the driver for Vista for my computer, but not found RAID.
  Tried it with XP drivers, but no longer works.

  Do you have an idea where I can download Vista drivers for RAID?

  THX

  Hello

  Your suggestion is good. The Tecra S3 supports the RAID, and the RAID driver is required to install the OS on the HARD drive.
  On the European driver Toshiba page I found a RAID for XP driver.

  I put t know if this driver will run under Vista, but I recommend to test.
  The RAID XP 1.3.8.0 driver version can be downloaded from this site:
  http://EU.computers.Toshiba-Europe.com/cgi-bin/ToshibaCSG/download_drivers_bios.jsp?service=EU

  Please note; You can store the RAID driver on an external USB and Vista should recognize it!

  Good luck