Cisco Wireless

I wish to order two autonomous. What is the difference between "air-sap2602i-n-k9" and "air-cap2602i-n-k9"?

When you create a client wireless internet on a wlan controller, type what is the difference between WLAN and LAN comments -? is it really important which one choose it?

I have a 4402 and 5508 times code v7 running, are compatible if used as primary and secondary controllers? Thank you Jason

If I have my controller anchor sitting on my DMZ subnet and my other controllers on my LAN (local subnet) inside, how they communicate? I'll be able to connect to my other controllers or vice versa, when I am connected to my Internet Guest? because I

Hi all Whenever we talk about 802.11 wireless network, we consider that it is a network hub. However, 802.11n supports MIMO which can receive means while one antenna transmits the other antenna. For me, it works as a switch, no hub. I want to confirm

Hello world... I need help. I have an AP 1310 G with ' software Cisco IOS, software C1310 (C1310-RCVK9W8-M), Version 12.3 (11) JX1, RELEASE SOFTWARE (fc1). I need to configure this as autonomous AP to do a Site Survey, but the APs is reseting trying

Hello I recently bought a 2112 a Wlan controller a number of LAP1042n Ap of the AP will not join the command and the message I get in the console of the AP, it is that the AIR-WLC2100-K9-6-0-199-4.aes firmware does not support this model?  Can someon

I have a site that is get about 900 laptops for use on the WIRELESS network.  We have just completed the installation of a cisco with a controller 5508 wireless infrastructure.  They are all performed in mode local (WLC is on-site) and use a SSID for

Can I use mesh indoor APs do outdoor mesh? I want APs inside buildings but who attennas outside for the outdoor mesh. It will work, and it is supported? Zhenning

We habe a WLC 4402 race (SW Version 6.0.196.0) which is supposed to support access 50 points. It is a solution of WLAN of comments with 2 Wireless LANs that are tunneled through the FW to a WLC anchor that leads to the internet and 1 WLAN which is di

Hello which is image ios LWAPP for cisco 1242AG AP series? C1240-k9w7 - tar.124 - 10B .JA .tar C1240-k9w7 - tar.124 - 10B .JA3 .tar C1240-k9w7 - tar.124 - 25d.JA.tar

Hi all My version of WCS is 6.0.181.0 and my AIR-WLC4404-100-K9 2 running on a very old version of 4.2.61.0. I've decided to update the IOS on the WLCs. All the upgrade were made on the WLCs. First of all, I upgraded the to 5.1.151.0. After the level

Hello I have 3300 MSE/2700 THE connected with v.7.0.X WCS My question is what tracking method should be used? Prints of RF or airespace THE automatically chooses the tracking method? or I have to do it manually? you please give me more information on

Hello I have a question for you guys. I created my cisco 861w in order to get access to the Internet at home. Everything was good except that I can not tune to work wireless N. can take you a look at my setup attached to make my network works speed N

Hello, I am using 1131AG at school. But even I was correct (I think..) settings for our school system, but I do not see the SSID. There is no DHCP server in our school and the address ip of the AP is 192.168.102.x //subnet mask 255.255.0.0 I went wit

Hello Is it possible to access the cisco 1242ag in graphical mode AP LWAPP?

Is AIR-WLC4402-12-K9 offers gigabit over copper connectivity?

Hello I want to configure my cisco 1242ag ap (autonomous) series to work as internet gateway. How can I connect it to the network so that it works as the internet gateway for users.

AP is AIR-AP1142N. SSID & RADIO 1 configuration is that... Enable ssid on the radio 0-> I see the ssid (but 72mbps..) but, close radio 0 after activate the radio 1-> I do not see the ssid 802.11n configuration is open authentication or encryption wpa

Dear members of the Forum I found the link below which is awesome, but I was wondering if you can provide some additional information. http://www.Cisco.com/en/us/partner/products/ps6087/products_tech_note09186a0080736123.shtml The piece that does not